Question about Ford Mustang
Engine doesn't crank over ? Or cranks over an no start ? If you have a no crank issue when you turn the key , do you have a security light flashing In the top center of the dash panel ! This is part of the PATS - passive anti-theft system ! If there is a problem the computer will disable the starting system !
PATS uses a visual theft indicator. This indicator will prove out for three seconds when the ignition switch is turned to RUN or START under normal operation. If there is a PATS problem, this indicator will either flash rapidly or glow steadily (for more than three seconds) when the ignition switch is turned to RUN or START. PATS also "blips" the theft indicator every two seconds at ignition OFF to act as a visual theft deterrent.
Posted on Apr 19, 2015
Make sure the positive cable, makes a good connection at the battery and at the starter. Make sure the negative cable makes a good ground connection at the battery and (preferably) at the engine.
If the starter spins and no crank, the problem is most likely the Solenoid's bendix gear is stuck.
Have someone hit (not too hard) the starter while you try to start the car. This usually works by dislodging a stuck bendix gear.
Posted on Apr 19, 2015
Bypass the starter motor, see the diagrams attached. You will have a new view vision with this.
God bless you
Posted on Jul 23, 2013
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: my darango won't start, replaced
this could be as simple as a bad battery have you tryed to jump start it? if you try and that dosent work make sure you have power going to the starter with jumper cables on the battery. it should at the very least make a clicking sound while trying to start it check the battery posts also make sure they are clean and if it does click give it a minute and try starting it again.[ dont take the cables off the battery while waiting] the fact the starter doesent even click when you try to start it tells me no power to it or bad starter remember just because its new dosent mean it works i cant tell you how many times i have put somethig on a car and had to take it back off because it didnt work from the boxx new. and make sure the starter wires are tight and clean. if no clicking and you have power to starter then starter is bad.. i hope this helps..
Posted on Jun 04, 2011
SOURCE: 2007 chevy cobalt ls won't
Ignition relay or fuse could be the problem. When you turn the key to start do you hear a fuel pump kicking on and or do you have spark when you hot wire the starter (I know it's hard to check while trying to start it)? You can email me back and I might be able to pinpoint it more.
Posted on Jun 06, 2011
I would be re-checking the battery. Make sure that when you have it tested they do a "load test". Sometimes a battery can seem good, but be bad when there is a large load placed on it. This test will reveal if that is the case. It could also be a starter problem, and it is possible (but unlikely) that it is a wiring problem.
Posted on Sep 23, 2011
Hi Vernon, There could be a number of different reasons why your vehicle is failing to start. The battery voltage could be dropping during start and become unable to engage the starter motor to turn the engine. You can check this by trying the key with the head lights switched on. If the lights become very dim, you'll need to check the battery, meaning clean the terminals and then try to start with a jump from another battery. If you achieve start up and it fails again the following morning, you will probably need to replace the battery. There could be a problem with the starter relay or a loose contact for the starter motor, most lik3ely the one connecting to the soliniod. It would be good to know some additional information, such as does a clicking sound come from the starter when engaged? Is there a perceptible drop in voltage output when the starter is engaged? does the enine turn at all? Try what I've suggested and if that does not solve the problem answer the questions and let me know anything else which you may think is relevant. Regards John
Posted on Nov 18, 2011
more then likely its a bad starter. or the cable to starter.
Posted on Jan 17, 2012
Tips for a great answer:
Sep 25, 2013 | Ford Mustang Cars & Trucks
Mar 20, 2013 | Cars & Trucks
Dec 06, 2012 | 2009 Ford Mustang
Jul 09, 2012 | Cars & Trucks
Jun 05, 2012 | 1999 Oldsmobile Bravada
May 30, 2012 | 2005 Nissan Altima
May 21, 2012 | 1999 Toyota Camry
Jan 17, 2012 | 2004 Ford F250
Nov 18, 2011 | 1999 Saturn SL
Jun 18, 2011 | 1999 Ford Windstar
Apr 22, 2018 | 1998 Ford Explorer
316 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: