Question about 2005 Chrysler Crossfire

1 Answer

Car locked in park

Went to start car and "check Eng light" stayed on. Car would not come out of park. Used over ride and limped home in first. Any Ideas? Had no issues till this.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chrysler Master
  • 12,223 Answers

Follow this steps and fix it. GOD BLESS YOU

Ensure that your vehicle's transmission is in park. If you have manual transmission you can skip this step and move on to Step 2.


  • 2 Press the brake of your car completely down with your right foot. If the key of the car is not in the ignition put it there now.

  • 3
    Hold the steering wheel of your car firmly with your left hand and the car's key placed in the ignition with your right hand. Turn the steering wheel to the right and left while you twist the ignition key as if you are starting the car. Engaging in these two motions simultaneously will release the ignition switch and allow you to turn the car on.


  • Read more: http://www.ehow.com/how_7566817_unlock-ignition-switch.html#ixzz2ZqCAUIzC

    Posted on Jul 23, 2013

    6 Suggested Answers

    6ya6ya
    • 2 Answers

    SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

    Hi,
    a 6ya expert can help you resolve that issue over the phone in a minute or two.
    best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
    the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
    click here to download the app (for users in the US for now) and get all the help you need.
    goodluck!

    Posted on Jan 02, 2017

    emissionwiz
    • 75051 Answers

    SOURCE: Cirrus Stalling With Check Engine Light On did not come on the first time it happened

    Your problem sounds like it may be a Mass Air Flow sensor, when it does run bad disconnect the sensor, if the engine starts running ok the sensor is bad, this would be the most common reason for your problem and why it is only intermittent. As far as the overheat do you have a coolant leak?

    Posted on Sep 17, 2008

    localwonder
    • 6784 Answers

    SOURCE: 2006 Chrysler Pacifica touring abs light on stays on

    Hi. this light is a warning that concerns the ABS sensor and mechanism assembly. there is a central module and connecting sensors that are attached to each axle/rotor. If any of the sensors become unstable or starts to malfunction, the main module will detect this anomaly and it will trip the light via, the ECM.

    I recommend taking this vehicle in so that the ABS techs can diagnosis this issue and they can pin point which sensor or mechanism is malfunctioning.

    You vehicle seems to operate in a normal manner at this point but, you will actually have to be in a hard braking situation in order to experience this malfunctions results. If you where to initiate a hard brake while the ABS system is in safe mode(light on), your vehicle would simply lock up. It would not provide the ABS actions due to this malfunction that is evident at this point.

    Please rate and god bless:)


    Posted on Apr 21, 2009

    • 21 Answers

    SOURCE: Car stuck in Park, wont switch gears

    check to see if the brake lights come on it may be a problem with a brake switch under the dash not letting the shift lock release. there may be a seperate switch just for it so check and see it there is two switches touching the brake pedal lever if the brake lights come on.

    Posted on Jun 09, 2009

    • 15 Answers

    SOURCE: 1997 Chrysler Grand Voyager. Transmission and

    For the steering problem first at all check it the fluid level.
    For the Transmission, if you recently replaced the fluid this MUST BE a ATF+3. Never use others like Dexron or Mercon. So, first, let me know what kind of fluid you put on in.

    Posted on Oct 03, 2009

    • 1 Answer

    SOURCE: 2006 Chevrolet Uplander Parking Lights Stay On

    My 2006 Uplander would not shut off the parking lights. I came here for a solution. I saw the answer here, actually the question, and I used the key fob to lock the vehicle. The lights went off. That was a temporary solve. Now, is this a "glitch" or a "feature"?

    Posted on Mar 20, 2010

    Add Your Answer

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    2 Answers

    Can't switch out of Park on my 2003 Expedition. Was driving normally and parked it. Then when I went to leave it wouldn't switch gears from Park into Drive; the lever is stuck and it is all...


    U need to disconnect the brake lights switch on top of the brake pedal, and stick a wire or paper clip in between the two wires, the will allow you to take it out of park, then you need to replace the switch, if that Dosent work check you fuses, if it blows try it with the switch unplugged please rate and good luck

    Jul 31, 2011 | Ford Expedition Cars & Trucks

    1 Answer

    We were at the drive in the ignition was on accesory after about an hour the radio went out and the car wouldnt start the key was also locked in the ignition. we got a jump when car started it sounded...


    Low voltage on this vehicle causes all kinds of problems...The ECM has gone in to "LIMP" mode, if you are lucky it's just the TPS sensor. Will need to know what the fault codes are to confirm. If you have Onstar you can call in to them and they will retrive the codes from the ECM. A high end diagnostic scan is recommended because often codes will be set by low voltage and false sensor readings....Good luck, i hope this helps.

    Jul 16, 2011 | 2006 GMC Envoy

    1 Answer

    Subaru Forester 2001. Parking lights stay on when car is turned off. Lights go off only when fuse removed. Light switch on steering column was changed to no effect. Separately, AC, fan and heater...


    I have had the parking lights on my 1998 forester stay on w/ no way to turn off. Used the remote door lock to lock and unlock car and the lights went off?????????? This has happened twice with the same solution

    Nov 26, 2010 | Subaru Forester Cars & Trucks

    2 Answers

    98' Cav.. Drove it to store, shopped, didnt leave anything running or turned on. Went to car, opened dr...no dome light (thought, hmph, must have burned out -- fix later). Tried to start car... I turned...


    this sound to me like at first I thought it was a fuse, as the problem went on it shifted more toward a weak cell in the battery, if a weak cell sits for a little while the battery will not hold the charge in that cell and that will cause loss of power, "its charge", in tne other cells. you had mentioned you used another battery and it ran great but when the battery was removed, things went wrong. You may check to see if there is water in your battery

    Aug 19, 2010 | 1998 Chevrolet Cavalier

    1 Answer

    Car is stuck in park. Wife drove home last night


    TRansmission went on the car you may have to buy a new transmission

    Mar 19, 2010 | 2001 Pontiac Grand Am SE

    1 Answer

    Interior lights stay on sometimes. after a jump, drove home, shut off ignition, int. lights continued staying on, then parking lights when on/off every 3 seconds, the elec. locks did a triple, then lights...


    This is a common ford problem, The easiest way to solve it is to SOAK all door latches with WD40, I mean really soak them. Then open and close the doors a few times... Im betting this will solve the problem.

    Jan 25, 2010 | 1999 Lincoln Town Car

    3 Answers

    2006 Chevrolet Uplander Parking Lights Stay On


    My 2006 Uplander would not shut off the parking lights. I came here for a solution. I saw the answer here, actually the question, and I used the key fob to lock the vehicle. The lights went off. That was a temporary solve. Now, is this a "glitch" or a "feature"?

    Sep 04, 2009 | 1996 Chrysler Town & Country

    1 Answer

    Check Engine light


    It sound like you are having a electrical problem.You need to check your electrical/ignition system,not all electrical problem the diagnostic machine can read.

    Aug 22, 2008 | 1999 Saab 9-5

    1 Answer

    Check engine light stays on


    Make sure the gas cap is there and is fully tightened (it will click), a loss or missing cap will turn the check eng light on.

    Jul 28, 2008 | 1997 BMW 328

    Not finding what you are looking for?
    2005 Chrysler Crossfire Logo

    104 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chrysler Experts

    yadayada
    yadayada

    Level 3 Expert

    75005 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22095 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    7710 Answers

    Are you a Chrysler Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...