Question about Cars & Trucks

Open Question

Pcv valve on a 2006 chevy malibu 3500 - Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1129 Answers

SOURCE: PCV VALVE REPLACEMENT

The pcv valve is usually located on one of the valve covers look for the larger vacuum hose coming from the intake manifold and follow it you should find it that way. changing it is a matter of sometimes using a pair of pliers to remove a small clamp then rotate back and forth the pcv valve while holding the hose and pulling it away and off.

Posted on Jul 02, 2009

  • 1 Answer

SOURCE: Where is the PCV Valve located on the 1996 4 cyl Cavalier?

the thumbscrew with a hose coming out on the pass. side of your valve cover

Posted on Jul 21, 2008

  • 61 Answers

SOURCE: how to replace valve cover gasket 1998 chevy malibu

The first step is to remove all the parts that are in the way of you being able to remove the valve covers. (Ex.: air intake, loose wires etc.) Then you will need to remove your valve covers (using basic tools) and be very careful to not let anything get on your lifters, which your valve covers protect. Once you have the valve covers off compare the new gaskets to make sure they are the right size. Then remove the old gasket and replace with the new one using a high temp gasket sealant (available at any auto parts store) to attach the gasket to the valve covers. Then tighten down snug and check for leaks after replaced. 

Posted on May 06, 2009

  • 2692 Answers

SOURCE: Can't find PCV valve on 2000 Chevy Impala 3.8 V6

PCV . Positive Crankcase Ventalation Valves are always located in the valve cover pans with a hose attached usually leading to the air cleaner, or some other vacuum source..

Posted on Jun 19, 2009

gh20s
  • 343 Answers

SOURCE: Chevy 2002 Malibu ERG valve

Symptoms of a bad EGR valve are usually stumbling idle or the engine stalling when the car is warm (normal operating temperature). Find the EGR valve and locate the vacuum line attached to it. Start the engine cold and wait for it to warm up. When the engine starts to stumble, pull off the vacuum line. If the EGR is bad, the engine idle will stabilize and no longer stumble.

Posted on May 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

WHERE IS LOCATION OF PCV VALVE ON 07 MALIBU 2.2L ECOTEC ENGINE ?


Usually in valve cover...will have slightly bigger hose coming off of it

Jul 05, 2016 | 2007 Chevrolet Malibu

1 Answer

Does a 2006 chevy optra have a PCV valve and if so where is it located?


A PCV valve's a 1 way valve that ensures evacuation of gases from inside a gasoline internal combustion engine's crankcase.------------------------------------------------------------------------------
super mb star

Jan 14, 2013 | Cars & Trucks

1 Answer

1998 Chevy Malibu is using excessive oil. Had an oil change done back in October 2012 . Then checked Oil level in December of 2012 and was about 3/4 low in oil! why ?


first thing check make sure oil pan drain plug tight. check make sure oil filter tight. try tighten oil filter by hand see if turn tighten oil filter clockwise direcction if all is good. how many miles on vechicle.could have oil leaks park vechicle in spot that clean.move vechicle see if you see oil spots on ground if yes.your front timing cover seal leaking oil or rear main oil seal ;eaking.or valve cover gaskets leaking.if find no oil leaks more likely engine burning oil.replace pcv valve.check air filter if you see oil in air filter housing either have bad pcv valve or pcv not getting vacuum make sure pcv valve getting vacuum when engine running vacuum should be felt at pcv if not pcv valve bad or pcv hose disconnected broken or plugged.if pcv valve okay engine has worn piston rings.worn valve seals or guides or oil return holes stopped up thats all possible reasons for engine burning oil.if spark plugs oil fouled engine burning oil.

Jan 11, 2013 | 1998 Chevrolet Malibu

1 Answer

Where is the location of the PCV valve in a 3.5 liter 2006 Chevy Malibu Maxx?


Almost all PCV Valves, have been on one valve cover or the other, for
the last 50 years

They never need replacement.

Remove & clean, if you got nothing else to do

Sep 20, 2011 | 2006 Chevrolet Malibu Maxx

2 Answers

Chevy 2002 Malibu ERG valve


Symptoms of a bad EGR valve are usually stumbling idle or the engine stalling when the car is warm (normal operating temperature). Find the EGR valve and locate the vacuum line attached to it. Start the engine cold and wait for it to warm up. When the engine starts to stumble, pull off the vacuum line. If the EGR is bad, the engine idle will stabilize and no longer stumble.

May 25, 2010 | 2002 Chevrolet Malibu

1 Answer

2006 chevy malibu.... where is the egr valve


If it's a US car then there is not an egr on the 2.2L engine. I think some of the mexican and oversea's engines had them, but not here in the US.

Oct 21, 2009 | 1999 Chevrolet Malibu

2 Answers

How do I replace the PCV valve on my 2004 Chevy


It is located on top of valve cover. It just pulls out and pushes in by hand. If it is good, the valve inside shoud jiggle around. If it does not move freely, it should be replaced.

You can go to autozone.com and register for full free online repair manual with everything you could ever need for your car.

Oct 11, 2009 | 2004 Chevrolet Malibu Maxx

1 Answer

PCV VALVE REPLACEMENT


The pcv valve is usually located on one of the valve covers look for the larger vacuum hose coming from the intake manifold and follow it you should find it that way. changing it is a matter of sometimes using a pair of pliers to remove a small clamp then rotate back and forth the pcv valve while holding the hose and pulling it away and off.

Jul 02, 2009 | 2003 Chevrolet Malibu

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...