Question about Cars & Trucks

Open Question

Champion 34 gas engine special Spark Plugs - Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Monster80
  • 460 Answers

SOURCE: changing spark plugs

First remove the big plastic cover that covers the motor by taking off the oil fill spout.Then the plastic cover should just lift right off..No you should be able to see all of the front ones and the rear ones are a little tricky..You'll need a 3 to 6in. extension with a swivel next to the 5/8 deep well socket.Taking them out is usually the easy part to which reinstalling is a little more trickier.Make sure the plug socket you are using has the rubber piece inside of it because you don't want to break the plugs..And when putting rear ones in to use an old plug wire end or just the socket and three inch extension to start the threads because you dont want to cross thread them.After you have atleast threaded them in as far as you can get them and they went atleast 3 to 4 revolutions tighten them up and finish the rest in process you be great..Good luck to you and am always here to help you and anymore questions will be glad to help......

Posted on Mar 30, 2009

  • 159 Answers

SOURCE: Bad miss after changing spark plugs

could have cracked the porcelin on the spark plug

Posted on Jun 04, 2009

ZJLimited
  • 17970 Answers

SOURCE: where can i find champion A-6G spark plugs for my 1986 Ferrari

Check the "cross reference:
Champion / NGK
A6 / DR8EA
A6G / DR8EIX

Visit here 1986 FERRARI 328 GTS 3.2 V8 F105CB FI

Good luck.

Posted on Sep 04, 2009

  • 132 Answers

SOURCE: What is the spark plug gap for a 1989 Dodge

39 to 44

Posted on Nov 09, 2010

dcramer531
  • 1654 Answers

SOURCE: i have a 350 chevy

Without any more information than this I have to say it should be between 32 and 35 thousands. I don't have the info from the ignition system that your using, Have you checked the manufactures suggestions. Unless this is a super spark ignition then the gap I quoted should work.

Posted on Mar 20, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

A champion plug 12jyc what moter will it fit in


plugs for 350 block , 4 barrel carby 1967-19710 is j12yc
all plug descriptions have a series of letters number and letters..you can download the champion chart from the champion plug site
it works like--- this any plug that will screw in the hole will provide a spark
you have to measure the thread length in the head as the plug thread cannot be longer or shorter that that length
next the sealing is by taper or copper gasket so the plug will require the same as is in the head ( flat or taper ) whether the electrode protrudes or not depends on the application ( High speed engine etc)
there are factors that come into it as well like the heat range ---cold plugs for new engines and hot plugs for worn engines to burn the oil

Mar 13, 2017 | Cars & Trucks

2 Answers

I have a 2001 Dodge Stratus and awhile ago I switched the plugs to a Autolite plug. Then I decided there might a problem and went back to the Champion plugs.


I believe the factory originals are champion brand, and would have been platinum, but it should still run decent with the coppers. The only thing I can think of is they are of the wrong gap. Copper plugs do not come pre- gapped at all and need to be done by installer. The gap for your stratus, if it's a 4 cylinder is .050. Wrong gap will cause no power and shaking. Correct champion number in copper is #443, and should say that on the box/plug.

Jan 15, 2017 | 2001 Dodge Stratus

3 Answers

Replace spark plugs


The OE Autolite plugs installed in the Navigator use a 9/16 inch
socket, which is most exactly the same diameter as the thread area, which makes it look round in the hole. The Champion 7989 uses a 5/8 Spark Plug Socket, which is one of two "standard" plug sizes. The other "standard" plug size is 3/4 inch, which is not used very widely any more.

Nov 09, 2013 | 2006 Lincoln Navigator

1 Answer

How to test mass air flow sensor on 1992 jaguar vanden plas


If a spark has no path to discharge, it will often find a weak one or create one. If your wires or plugs are so bad that they cannot pass a spark, the coil will discharge elsewhere. It is a great coil. I have seen brand new plugs completely disable an engine. Completely. I have seen wires completely fail on their maiden voyage. The plugs were Champion BRF52 on a Ford, the wires were Belden for a V6 Mercury. I do not recommend Champion plugs, at all. I do however like Belden quality. You would not suspect them, but... Suspect them. Pull one out lay it on a steel part of the engine, and see if it sparks. If not, replace them. For wire, try to start the engine at night, watch in the dark for arcing wires. Replace them.

Apr 03, 2017 | 1995 Jaguar XJ6

1 Answer

My 2003 Chrysler Voyager, 3.3L, SFI, runs very rough and at times it almost dies out while driving. The engine seems to choke up at times. I just replaced 6 old spark plugs with 6 new spark plugs, Bosch...


Chrysler Voyager seem function well on Champion spark plugs. I had the same issue and only after buying Genuine Champion Plugs, the car resonded with power

Sep 21, 2011 | 2003 Chrysler Voyager

2 Answers

What is the spark plug gap for an 1989 ford F250?


Make: FORD
Model: F-250
Year: 1989
Engine: V8 - 5.8L - FI - - GAS

Needed GAP 0.44" Champion Catalog

More details for other engines sizes in Champion Spark Plug

Hope helped (remember rated this help) Good luck.

Oct 16, 2009 | 1989 Ford F 250

1 Answer

I'm looking for the gap required in the spark plugs for my Mazda MP3.


Make: MAZDA
Model: PROTEGE - MP3
Year: 2001
Engine: L4 - 2.0L - FI - - GAS

Brand: Champion
Product Name: Traditional Spark Plug
Part Number: RC12Mc-4
GAP: .044"
Notes: w/DOHC (Original Equipment Manufacturer and/or Original Equipment Equivalent)

More details: Champion Spark Plug

I hope help you whit this (remember rated this help).

Sep 10, 2009 | 2001 Mazda Protege

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...