Question about Cars & Trucks

1 Answer

700r4 transmission problems

Hello, i just bought the car and it dosent engage. pulled lines out of rad and no fluid goming out. i can here noise from trans.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 12,223 Answers

Follow this steps and see the diagram attached.God bless you

First, check the transmission fluid level and condition. If you don't know how to do it, here is an illustration:
How to check the automatic fluid
With the engine idling and transmission in "Park" (some car may have different procedure, refer to the owner's manual) remove the automatic transmission dipstick and wipe it out with the clean lint-free cloth. Insert the dipstick back fully and then pull it out again. Check the fluid level; low level may indicate a transmission leak. Look at the fluid very closely. It helps if you drip the fluid onto a white paper to be able to see the fluid condition. The transmission fluid should be clean and transparent, without any metal filings or black flakes. The new fluid usually comes red. Over the time, it become more brownish, but it shouldn't be very dirty or black. Look at the image. Try to smell the transmission fluid; It should not have a burnt smell.
All this may seem difficult, but when you check few similar cars, you'll be able to see the difference. If the transmission fluid is too dirty or black, or smells burnt, it's better to avoid such a car.
Keep in mind, however, that some modern cars don't have the transmission dipstick and require special procedure performed in the auto repair shop to check the fluid level. In this case, the only way to check the transmission is on test drive. 700r4 transmission problems  - 68c27b4c-81ab-4513-9708-389569a89182.jpg

Posted on Jul 23, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 247 Answers

SOURCE: Transmission not engaging

is it manual or automatic transmission?

Posted on Dec 18, 2008

c17hydro
  • 2984 Answers

SOURCE: Transmission fluid leak just off Radiator

Those are your transmission cooling lines. Buy them and replace them.

When you install them, take your time...don't be in a rush.

Posted on Mar 27, 2009

csmock132
  • 4669 Answers

SOURCE: Buick 2000 Le Sabre-transmission does not engage in any gear.

Try unplugging the electrical connection on the transmission to lock it in 3rd. It might get you moving. Although the transmission is going to need rebuilt or replaced.

Posted on May 24, 2009

mx5turbo92
  • 545 Answers

SOURCE: Should i change tran fluid on xg300?

just change it,oil too old,it might low too coz of the shudder.

Posted on Jun 03, 2009

yegarboy
  • 286 Answers

SOURCE: 99 dodge ram 4x4 w 360 engine trans has only 1st gear and reverse

Are you saying you put in a new but used tranny and it still dosent go out of first gear? Or are you saying you replaced a tranny line? If its the tranny you replace and first is the only gear you may not have adjusted the shifting linkage correctly. Put the truck in park and loosen the linkage on the tranny and slidr the rod on the tranny back and retigten and try that

Posted on Aug 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Transmission shifts very hard


Check your transmission fluid level as soon as possible.
If you are experience hard transmission shifts, it is possible that the only problem is a low transmission fluid level. Low transmission fluid level can change the operating pressures of the transmission as well as reduce the amount of lubricant present between the clutches and bands and raise transmission temperatures. All these things can cause hard or jerky shifting. You need to identify why the transmission has a low fluid level and refill it as soon as possible.

Apr 25, 2016 | 1988 Chevrolet Corvette

1 Answer

Why won't transmission engage after an oil line blew?


Most likely the fluid level is low. You need to check the fluid level with the vehicle running on most models and add as neccessary

Nov 29, 2015 | Cars & Trucks

1 Answer

Mercedes Benz C240 mixing transmission oil with antifreeze


Thats what it is the rad has antifrez and tranny fluid running thru two sep lines tru same rad

Feb 25, 2014 | Mercedes-Benz Cars & Trucks

1 Answer

Transmission fluid in radiator could lines be switched


no way you need a new rad to solve this one the internal tube has split or broke ,just disconnect the pipes and seal the rad connections up with a couple of blanking plugs to stop the water leaking out then the transmission pipes you make a nice sort square round out of some copper plumbing pipe and connect this to the transmission pipes from the gearbox run in front the AC rad and this will save you from buying a new rad which the last time i bought one for this motor was about 550 euros as i couldnt one made by a recon company only original part from deal;er

Jun 06, 2012 | 1996 Plymouth Grand Voyager

2 Answers

1973 chevy c10 pickup 350, truck is an automatic, starts up and goes into reverse and 1st fine but when i accelerate and the transmission shifts from 1st to 2nd the rpms keep increasing but the speed never...


Yeah Brother, those old square bodies are still neat. I have a '74 I put on a 4x4 chassis and 6.2 diesel w/overdrive automatic(700R4). Most likely you have a TH350 turbo trans and on the side front is a vacuum actuated can that operates the shift of the tranny. Any vacuum line connected to the carb or intake manifold will supply vacuum to it. It's originally a steel line with rubber connector tubes on the ends. Check the tranny fluid after warm up, in park, and be sure it has enough fluid in it. Luck Bro.

Jul 07, 2017 | Chevrolet Cars & Trucks

2 Answers

I have a problem with my Kia Spectra 2006 gearbox, it sometimes dosent engage to R, when u engage it to R it will standstill, and when u press the throttle hard e.g. 1200RPM, it will engage and Reverse...


first thing is to check the fluid, if the fluid is ok then you need to check the transnmission line pressure, best guess is the pump inside the transmission is going out but you will have to have the pressure check before we can make sure that is the problem....good luck

Sep 30, 2011 | 2006 Kia Spectra

1 Answer

Need vacccuumdiagram for 77chev 350 engine loosing transmission fluid to i dont know where not leaking on ground


Hello shanebuerman: My name is Roger and I will help you. If you are using transmission oil and see no leaks on the ground I would look at the transmission as the source of the problem. If you have a turbo-hydromatic 400 transmission look at the modulator valve. It will be on the passenger side of the transmission and have a vacuum line attached to it. This will be a metal line that runs over the top of the bell housing. The other end will be connected to the intake manifold at the rear of the carburator. When the diaphram ruptures the fluid is sucked out of the transmission and burnt in the engine. Pull the vacuum line from the valve and if there is any oil at the vacuum port you will have found the source of fluid loss. If you have a 700R4 overdrive transmission? and no external leaks.Look at the radiator as the source of the problem. The transmission coolers were known to leak in the radiators. This model transmission does not have a modulator valve. Should you need further help please just ask. Please rate the answer. THank You for using Fix Ya. Roger

Aug 16, 2011 | 1983 Chevrolet Silverado

1 Answer

I'm working on a 2002 Dodge Neon. The transmission cooler line has become disconnected from the radiator but looks to be fine including the adapter. I can push the line back into the hole in the...


I had the same problem with my 2002 Neon and the transmission fluid was mixing with the coolant. You cant fix it yourself...Either pull the radiator and take it to a rad shop or replace the rad as I did. If the coolant gets into the transmission you will also need a transmission flush.The fitting you are talking about has come loose from the transmission cooler tank inside the rad.Its a common problem with neons I got a new rad from NAPA and changed it myself, and it was a lot of work. Good luck. The manual also says to replace the flexible tranny lines.

May 08, 2011 | 2002 Dodge Neon

1 Answer

How to remove hyundai trajet raditor


Hello first have a drain pan under the front under rad now open drain plug drain coolant ounce drain disconnect rad hoses and transmission cool lines use a strait head screw driver now remove the the bolts you see on top of rad usually 10mm size now lift out rad replace reconnect the bolts and hoses and refill the coolant and start engine let all the air bubbles burp out ounce coolant moves and rad fans come on top up coolant close off by putting rad cap on and check transmission fluid level add if needed you have now replace your radiator.

Jan 30, 2011 | Hyundai Motor 2003 Sonata

1 Answer

90 GMC 5.7liter motor.Transmission will sometimes when put in drive not engage.If I wait a few minutes,it will engage and works fine after that.Mostly does this when outside temps are cold (28 to 40...


The filter might be clogged/old and the cold makes the fluid heavy. With the 700r4 transmission its always best to let it warm up for a few minutes.

Feb 24, 2009 | 1992 GMC Sierra K1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

166 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...