Question about 2006 Ford Explorer

Open Question

2006 Ford Explorer Eddie Bauer Tire Sensor Fault dash message

I am getting a tire sensor error message on my dash when ever I turn the truck on. I can hit the reset button and it goes away but within a few miles it will come back on. I have checked the pressure on all four tires and all are the same. Do I need to have the sensors replaced? If so or if not is there something I can do myself to fix the problem or must I take it to the shop?

Posted by on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Molson02536
  • 3854 Answers

SOURCE: Tire sensor fault on our 2006 Ford Explorer after new tires

2006 Ford Truck Explorer
NOTE: The tire pressure sensor training prcedure must be done in an area without radio frequency (RF) noise. RF noise is generated by electrical motor and appliance operation, cell phones, and remote transmitters.

1. Turn the ignition switch to the OFF position
2. Turn the ignition switch to the RUN position three times, ending in the RUN position. Do not wait more than two minutes between each key cycle.
3. Press and release the brake pedal
4. Turn the ignition switch to the OFF position.

Sequence:
1- Left Front Tire
2- Right Front Tire
3- Right Rear Tire
4- Left Rear Tire


5. Turn the ignition switch from the OFF position to the RUN position three times, ending in the RUN position. Do not wait for more than two minutes between each key cycle.
6. The horn will sound once and the TPMS indicator will flash if train mode has been entered successfully. If equipped, the message center displays "TRAIN LEFT FRONT TIRE." Place the magnet on the valve stem of the LF tire pressure sensor. The horn will sound briefly to indicate that the tire pressure sensor has been recognized by the TPMS module.
7.Within two minutes after the horn sounds, place the magnet on the valve stem of the RF tire pressure sensor. NOTE: If the TPMS module does not recognize any one of the four tire pressure sensors during the tire training procedure, the horn will sound twice and the message center (if equipped) will display "TIRE TRAINING MODE INCOMPLETE." If this occurs, the entire procedure must be repeated from Step 1.
8. Repeat Step 7 for the RR and LR tires. When the tire training procedure is complete, the horn will sound once and the message center (if equipped) will display TIRE TRAINING MODE COMPLETE.

This should help. For now, probably all Fords are like this. And I do not believe that Ford puts sensors in their spares (some GMs do).
Good luck

Posted on Nov 13, 2009

ercupa190
  • 12223 Answers

SOURCE: 2006 ford explorer eddie bauer 4x4 tire sensor fault

will be a good idea to go the shop for to RUN the scanner/computer .remember the electronic in vehicles now is very complicated.
Do not waste time+money.
God bless you

Posted on Jul 23, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Ford explorer eddie bauer 1998 front passenger tire bald in one spot what causes it


Doreen, the radial belt has become faulty, replace tire immediately.

Mar 07, 2016 | 1998 Ford Explorer

1 Answer

2006 ford explorer eddie bauer 4x4 tire sensor fault


will be a good idea to go the shop for to RUN the scanner/computer .remember the electronic in vehicles now is very complicated.
Do not waste time+money.
God bless you

Jul 22, 2013 | 2006 Ford Explorer Eddie Bauer 4x4

1 Answer

I have a 2007 ford explorer eddie bauer eddition 4x4. iam wondering what the tire size is?


The original tire size the vehicle came with should be on a sticker inside the driver or passenger door jamb along with manufacturers suggested tire p.s.i.

Nov 01, 2010 | 2007 Ford Explorer Eddie Bauer

1 Answer

How do I get the Tire Sensor Fault Light to go off.


they come on becuase the tire pressure is low or the the tire pressure senser is broke try checking tire pressure in all tire make sure above 35 psi this should ,ake it go out

Sep 13, 2010 | 2007 Ford Explorer Eddie Bauer

1 Answer

What are the best and most affordable tires for the 2007 ford explorer eddie bauer?


mcdevito75 here, Believe it or not, find an out of the way tire shop, non big name for the best prices on tires.

Jun 16, 2010 | 2007 Ford Explorer Eddie Bauer

1 Answer

2007 FORD EXPLORER XLT


need to set tires at correct pressure you can find a sticker on the inside of drivers door to tell you the correct pressure after you do that it sould reset the light after you drive

Feb 02, 2010 | 2007 Ford Explorer Eddie Bauer

1 Answer

What does it mean when a message saying, "TIRE MONITOR FAULT" and how do I turn on the rear wiper


The tire pressure sensor, one of them, has either failed or become disconnected. Make sure tire pressure is OK before getting dirty hunting aound for the connector. 32 psi.

Jan 16, 2010 | 2006 Ford Explorer

1 Answer

Tire sensor fault on our 2006 Ford Explorer after new tires


2006 Ford Truck Explorer
NOTE: The tire pressure sensor training prcedure must be done in an area without radio frequency (RF) noise. RF noise is generated by electrical motor and appliance operation, cell phones, and remote transmitters.

1. Turn the ignition switch to the OFF position
2. Turn the ignition switch to the RUN position three times, ending in the RUN position. Do not wait more than two minutes between each key cycle.
3. Press and release the brake pedal
4. Turn the ignition switch to the OFF position.

Sequence:
1- Left Front Tire
2- Right Front Tire
3- Right Rear Tire
4- Left Rear Tire


5. Turn the ignition switch from the OFF position to the RUN position three times, ending in the RUN position. Do not wait for more than two minutes between each key cycle.
6. The horn will sound once and the TPMS indicator will flash if train mode has been entered successfully. If equipped, the message center displays "TRAIN LEFT FRONT TIRE." Place the magnet on the valve stem of the LF tire pressure sensor. The horn will sound briefly to indicate that the tire pressure sensor has been recognized by the TPMS module.
7.Within two minutes after the horn sounds, place the magnet on the valve stem of the RF tire pressure sensor. NOTE: If the TPMS module does not recognize any one of the four tire pressure sensors during the tire training procedure, the horn will sound twice and the message center (if equipped) will display "TIRE TRAINING MODE INCOMPLETE." If this occurs, the entire procedure must be repeated from Step 1.
8. Repeat Step 7 for the RR and LR tires. When the tire training procedure is complete, the horn will sound once and the message center (if equipped) will display TIRE TRAINING MODE COMPLETE.

This should help. For now, probably all Fords are like this. And I do not believe that Ford puts sensors in their spares (some GMs do).
Good luck

Nov 13, 2009 | 2006 Ford Explorer

1 Answer

Tire sensor fault on message center


your vehicle ussually comes with a senser activater. it looks like a fob and the owners manual should have instructions on its use

Sep 05, 2009 | 2006 Ford Explorer

1 Answer

One pf the tire pressure sensors is broken.


local tire dealers can get the sensor from car dealer, install & calibrate

Dec 22, 2008 | 2007 Ford Explorer Eddie Bauer

Not finding what you are looking for?
2006 Ford Explorer Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...