Question about 1998 Toyota Camry
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Look closely at the cover. You will see a small slot. Insert a small flat blade screwdriver, and pry it off. Very easy..
Posted on Nov 10, 2008
Removal of the plenum is pretty straight forward. You will need to replace the plenum gasket after you remove it; the gasket is not reusable. Personally, if I was going to take the trouble to remove the plenum, I would replace the plugs and wires back there, also.
I know, I have a 93 Camry V6, and it is a real pain to do the plugs and wires with the plenum on. There are no secrets or great tips on the plenum removal, just take your time. Remember that there are different size bolts, and where they go. Please get back to me if you need any more info...Hope this helps, and thanks for choosing FixYa to resolve your issue.
The graciousness of a FixYa rating for my assistance would be greatly appreciated.
Posted on Dec 15, 2008
SOURCE: torque specs for toyota tercel
Hello vienotkelly: The correct Main bolt torque is 42 foot pounds. The connecting rods torque to 29 foot pounds. The torque sequence for the head bolts and the correct way to tighten the bolts are attached to this reply. Thak You for using FixYa. Roger
Posted on Apr 15, 2009
You need to pull the plug wires up and out of their tubes. They can get stuck so twist them left and right to help loosen them first. The plugs are in the tubes. Use a 5/8 plug socket to remove them. Around the tubes you will see large flat nuts. You will need to remove all 4 of these. Also on the top timing belt cover there are 2 10mm head bolts you will need to back out at least 1/2 way for 2 reasons. 1 to free up the wire harness that crosses there and the bolts extend over the valve cover blocking its removal. Then with a screwdriver pry up the metal washers and rubber seals that were under the large flat nuts. The pcv valve needs to be pried out of the valve cover in the center and then the cover will come off.
Reverse to install.
Posted on Apr 20, 2009
Tips for a great answer:
Jan 24, 2016 | Toyota Cars & Trucks
Sep 04, 2015 | Toyota Cars & Trucks
Jul 07, 2014 | 2002 Toyota Sienna
Aug 29, 2013 | 2002 Toyota Camry
May 25, 2011 | 1999 Toyota Camry
Jun 28, 2010 | 1990 Toyota Camry
Dec 16, 2009 | 1998 Toyota Camry
Oct 29, 2009 | 1998 Toyota Camry
149 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: