Question about Cars & Trucks

Open Question

Navara engine noise sounds like tappet or piston

2009 nissan navara 2.5d, strange noise in engine on low refs, it sounds like a tappet or a piston, can anybodu assist me with this problem

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
chris bean
  • 61 Answers

SOURCE: nissan navara 2006 blown hole no1 piston 16000kms

do you have a hole in the piston or gasket? If in the piston it is most likely from coolant or water. If water, could be a cracked head, or being sucked in through the intake and building up in the 6th cyl. I have a lexus that had a hole in the side of the motor and noon could figure out why. I pulled the head and found water... Put new block in and egr codes came up. Pulled EGR and found it was sucking in water, due to an exhaust leak that was allowing condensation to build and would not blow out once in the egr tube. If you face the same problem (hole in block) I am going to say too much compression. Could be from head gasket not being torqued properly and leaking cooland, cracked head, or wrong spark plugs-and worst case scenario which I have yet to witness, bad spark plug gap. Not likely on your car, i would think.

Posted on Mar 29, 2010

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 Navara diesel. Is changing or adjusting the sync adjuster an easy job?


VW MK4/MK5 5 speed shifter adjustment for 02J and ...

? 6:22
https://www.youtube.com/watch?v=sheTKD03hmo
Oct 15, 2012 - Uploaded by dieselgeekdotcom
Shifter adjustment for 2000-2016 VW's with five speed transmissions. ... an issue selecting 2nd gear problem ...Missing: navara ‎sync

The Infamous D22 Engine Problem - Navara Owners Club

www.navaraownersclub.com/2009/.../the-infamous-d22-engine-problem...
Oct 5, 2009 - Also the sticky big end bearing change:- ... at risk - d22's with yd25 2.5 tdi engine (2002-2005), especially around the 60,000mile mark. ... The fundamental fault lies with con rod bolts that are NOT up to the job. .... seemed to be ok. i took it easy for the first 1500 miles as i was told the engine would be(tight)Missing: sync ‎adjuster

Questions, Troubleshooting Help & Support Page 7 - Fixya

www.fixya.com/troubleshoot/page-7
Any ideas why? I have cleaned the carbs and changed spark plugs ... 2005 Navara diesel. Is changing or adjusting the sync adjuster an easy job? Cars & Trucks ...

3 ltr Nissan Diesel problems resolved ' 4x4Earth



Dec 25, 2015 | Cars & Trucks

1 Answer

Nissan navara d40 v6 4.0 petrol. Makes noise when i start the car for few seconds ? What it can be ? Thanks


a description of the noise may have helped in the diagnosis, but generally if it is like a tappet noise, and goes with in 30 seconds of starting, it may be the hydraulic followers filling up.
If it is a roaring noise like a wind force ,it may be the viscous fan hub working until the silicon fluid is pumped into the hub reservoir

Feb 25, 2015 | Nissan Cars & Trucks

1 Answer

How do you remove and replace the injector pump "?"


This is a job bets left to an accredited diesel shop as the pump timing is critical to engine life. As little as 1 tooth out will result in low power/ hard starting or melted pistons.

Jul 25, 2014 | 2007 Nissan Navara 2.5

1 Answer

Nissan navara D40 making winding/whining noise when over 1500rpm


turbos normal make a whining noise under load noise may be present more then before if you have changed anything on the intake side sometimes it can be as little as a lest restricted air filter other cause is lose piping but some power loss would be noticeable if this was the cause
hope this helps good luck

Jan 15, 2014 | 2010 Nissan Navara 2.5

1 Answer

Adjusting tappet clearance


If you have adjustable tappets bring the engine to top dead center no 1 piston firing The rocker will be on the back of the cam lobes. Inlet .010" hot exhaust .012" hot and then turn until next firing piston is in position. Go by firing order. I suspect that a 1997 model would have hydraulic adjusted tappets which means no manual adjustment. If it is rattlly I would be checking for worn rocker shaft and rocker bushes.

Apr 02, 2013 | 1997 Nissan Pickup

1 Answer

97 elantra 1800 sounds like tappet noise only once engine warms up


sounds like a tappet,could be a ping caused by low grade of gas. hows the oil pressure. sometimes when oil pump is weak it will cause this when car warms up. will also do this if car is overheating...hope this helps some and good luck.

Aug 13, 2012 | Cars & Trucks

1 Answer

What is tappet settings


Hydraulic tappets are tappets that contain a small hydraulic piston, pressurised by the engine's lubricating oil supply.[5] Although the piston does not move appreciably or frequently, it acts as a hydraulic spring that automatically adjusts the tappet clearance according to the oil pressure. This makes the valve actuation self-adjusting and there is no need to adjust the rockers. Hydraulic tappets depend on a supply of clean oil at the appropriate pressure. When starting a cold engine, with low oil pressure, hydraulic tappets are often noisy for a few seconds, until they position themselves correctly.


Parts For Porsche Panamera

Jun 15, 2012 | Cars & Trucks

1 Answer

Oil light indicator flashing, Strange noise from engine.


Sounds like your either low on oil - or - your oil pump has seen it's days.

how many miles?

Mar 11, 2010 | 2005 Kia Sorento

1 Answer

ENGINE MAKING CLICKING SOUND SOUNDS LIKE LOOSE


PISTON RING NOISE.IT WILL MAKE A CLICKING NOISE LIKE A BAD TAPPET.

Oct 18, 2009 | 1997 Dodge Caravan

2 Answers

2007 Nissan Navara Service ligth reset.


You will need to send the navara workshop it needs to be hooked up to a special computer to be reset.

Jun 09, 2009 | 2005 Nissan Pathfinder

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...