Question about Cars & Trucks

Open Question

93 dodge dakota v6 magnum 3.9L

Carburetor idling high and making LOUD sucking noise??

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

losflip
  • 94 Answers

SOURCE: dodge dakota wont idle

You might have a possibilty of a vacume leak check all vacume line connections.

Posted on Nov 30, 2008

  • 366 Answers

SOURCE: Firing Order for Spark Plug Wires for a cavalier v6 93

2.3 and 2.4 has idi ign.syst. mounted directly on top of plugs,2.2 coil pack cylinder numbers are marked on it,from left of elect. connector on coil pack is 2-3-1-4where spark plug wires go,on block, cyl. from drive belt side is 1-2-3-4,timing firing order is1-3-4-2

Posted on Mar 16, 2009

  • 205 Answers

SOURCE: 2007 dodge magnum 2.7 v6 made a noise when i

the bendix may have gone bad. take the starter off and take it to an auto parts store such as auto zone they can test it.

Posted on Oct 15, 2009

  • 2 Answers

SOURCE: Windshield wipers don't work but the motor runs . 93 Dodge Dakota

remove wiper arms and then you can raise the hood to remove screws that hold down the vent panel.
now carefully remove vent panel.

Posted on Jan 09, 2010

BCAS1298
  • 3092 Answers

SOURCE: I need a firing order diagram for a 93 Dodge

Hope this helps you.

762453a.gif

Posted on Sep 17, 2010

Testimonial: "The diagram was exactly what I needed. Thanks"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Stalling and overdrive


IAC ( idle air control ) location. You need to be sure to clean pintle (pointed end) of motor as well as spray clean inside port where it comes out of. Careful not to lose small "o" ring on motor.
e2d88525-4c9d-4bfc-89fe-2917a3ff290a.jpg

Feb 27, 2014 | 1993 Dodge Dakota

1 Answer

2004 Dodge Dakota 3.7L V6, manual. Below


I suspect you have hydraulic lifters and the sludgy oil could plug up your lifters - as well as running that low on oil. Top off your oil and get an oil additive engine cleaner, warm your engine at idle only then change oil when warm. Add 1 quart of marvel mystery oil to the crankcase then top off with high mileage oil, like Valvoline. Run motor at idle only and see if this cures the problem - if not then you may need to remove the intake and replace your lifters, a costly and time consuming job. I would not try driving as you may waste the cylinder head or block by running a stuck lifter. There is also an oil additive specifically for stuck lifter and I think I would add that as well as the Marvel.
I hope the quick fix works for you and good luck!!!

Nov 27, 2010 | 2004 Dodge Dakota

1 Answer

1996 Dodge Dakota V6. Looking to buy this vehicle used. It has 190,000 miles. The V6 engine has a ticking noise that sounds like it is coming from the front of the engine. Are there any common problems...


THAT COULD BE PISTON RING OR PIN NOISE.ALSO TIMING CHAIN MAKE NOISE ON A HIGH MILEAGE ENGINES.YOU TAKING A CHANCE TO BUY A VECHICLE WITH THAT MANY MILES ON IT.

Apr 18, 2010 | 1996 Dodge Dakota

1 Answer

Transmission quits when truck warms up 93 dakota 4wd v6 works fine up to that point


Sounds like you need to change the fluid and filter. When it sits: debris settles in the pan, then when you take off, it sucks all the debris up to the filter, clogging it up.....no pressure. Hope this helped.
Bryon

Jan 16, 2010 | 1993 Dodge Dakota

1 Answer

I am getting fault codes 34, 53 & 25 on a '93 dodge dakota 3.9L magnum...could you tell me what problems these codes specifically refer to so that I can fix the problems?


25 Automatic Idle Speed (AIS) motor driver circuit shorted or target idle not reached, vaccum leak found 53 Logic module internal problem


have you tried to reboot the ECU by removing the pos battery terminal for a few minutes

Nov 30, 2009 | 1993 Dodge Dakota

1 Answer

I NEED TIMING SPECS FOR 93 DAKOTA SPORT W/MAGNUM V6 12VALVE


The two front camgear lobes should face upward at equal angles "away" from the engine.

Oct 09, 2009 | 1993 Dodge Dakota

1 Answer

Will a 440 short block engine fit into a 1993


A 5.9 should fit nice with no mods

Mar 02, 2009 | 1993 Dodge Dakota

1 Answer

2005 Magnum Noise on Cold Start


lack of oil in top end, on start up ! running 0-20 synth oil right, I add some LUKAS oil treatment,

Dec 14, 2008 | 2005 Dodge Magnum

1 Answer

Engine noise from 2.3 liter 93 tempo


VACUUM LEAK SOMEWHERE AROUND THE THROTTLE BODY LOOK FOR BROKEN CRACKED EVEN POSSIABLY A VACUUM LINE CAME OFF.SOMETHING TO THAT FACT THIS WOULD MAKE IT DO THIS.LET ME KNOW WHAT YOU FIND.

Jun 13, 2008 | 1993 Ford Tempo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...