Question about Chevrolet Camaro

Open Question

Where is the fuel pump relay 1991 Camaro Z28 5.7

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
bluelightnin
  • 35 Answers

SOURCE: Fuel relay placement 1991 Buick LeSabre. Replaced pump & filter still won't start

Your vehicle's fuel pump relay is located on the relay center, behind the glove box, 2nd column of relays, 2nd one from the top.

Posted on May 23, 2009

Ad
  • 2 Answers

SOURCE: 1997 camaro fuel pump relay location

Found It!!! It is located on driver's side kick panel or left foot rest, near firewall. Note: you must remove the plastic panel (4 screws) that is on the side.

Posted on Jun 25, 2009

  • 242 Answers

SOURCE: dont know location of fuel pump relay for 1992 camaro

This is going to sound stupid, but before you change the fuel pump relay, go back to the tank and give it a few good raps(rubber malet works great) if your pump comes on-the buzz, you need a new pump. also if after replacing the relay- if thats what you determine to be the cause and it still won't run- get your ignition module tested-it needs to send a sig to turn on the relay as a safety. oh and sorry can't tell you were the relay is.

Posted on Aug 26, 2009

Testimonial: "Will test tomorrow, thank YOU so much for help! 2 hours on net looking for relay.; location; goodfirst step T.Y..."

  • 1 Answer

SOURCE: trying to locate fuel pump relay for 1991 corvette- coupe

The fuel pump relay in the 1991 corvette is located under the IP on the pass side.
Open pass door, unscrew two screws under the glovebox (you will be upside down in the car), take off the fuse panel, unscrew third screw to plastic plate underneath glovebox, pull away carpet (velcro), pull down plastic plate (watch out for the wiring to the lamp), then under the glovebox you will find a number of fuses and relays if you dive in under there DEEP, prob 4 or 5 in a row, not really sure wich one, but one in the middle is the fuel relay, and they are the same (interchangable).
Take a look at --the12volt.com/relays/relays.asp--
It´s those relays we are talking about.

Posted on Sep 12, 2009

cshubart
  • 146 Answers

SOURCE: need relay location for electric fuel pump on 1991

under the hood or dash

Posted on Sep 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Locate fuse for fuel pump 1997 camaro


The fuel pump power to the relay is powered by the PCM BAT fuse 15amp.
The relay is grounded and the PCM powers the relay to turn it on and power the pump.
You should have power on the orange wire with the key on.
The PCM powers the relay when the key switch is in the start position and after the computer sees oil pressure and RPM.

Jan 30, 2013 | 1996 Chevrolet Camaro

1 Answer

91 camaro rs 3.1 v6 will not start has code 12 and code 54


Well code 12 means you are in the test mode of the computer, so skip that one.
Code 54 is telling you the fuel pump circuit voltage is low, which could be the pump relay.

Aug 26, 2012 | 1991 Chevrolet Camaro

1 Answer

1991 camaro v6 Does computer tell fuel relay how much voltage to send to fuel pump? Mine is low volts


No it doesn't work that way. You may have a poor connection some where in the fuel pump circuit. A common problem is a damaged connector to the fuel pump due to overheating.

Jun 20, 2012 | Cars & Trucks

1 Answer

I wanna know where is the electric fuel pump relay on my chevy camaro z28 1991. the engine run good when he is clod but stop when he is hot i think is the relay


Sounds like a crank sensor rather than fuel pump. You should check your fuel pressure at the injector rail to get a better idea of the cause.....Mike

Jun 19, 2011 | 1991 Chevrolet Camaro

1 Answer

I have changed the fuel pump, fuel filter and the fuel relay. Car won't start.


Have you put a pressure guage on the fuel rail? The guage should read 45-60 psi to run.Have you checked the fuses?

Sep 30, 2010 | 1991 Chevrolet Camaro

1 Answer

Not getting fuel to engine


Check fuel pump relay &fuel filter& fuel pump

Aug 28, 2010 | 1991 Chevrolet Camaro

1 Answer

91 camaro 5.0 5sp no injector pulse and no power to fuel pump


Using a multimeter check the wiring for power at the pump and at the relay. It sounds like a bad relay.

Jul 19, 2010 | 1991 Chevrolet Camaro

1 Answer

Where is the fuel pump relay fuse on a 1991 camaro with 305 engine?


I do believe it is located in the "relays" panel under the hood. Look on top/cover for "Fuel Pump".
Most likey a 10a fuse.

Dec 20, 2009 | 1991 Chevrolet Camaro

3 Answers

Starts but wont stay running


In reply: if its not the maf there are 2 relays in the relay box i belive its underhood, 1 primes the fuelline to 32psi the second kicks in after it starts, and keeps it running and varies the psi. if the primer relay isnt kicking in then it wont start due to no fuel

THX

Don :)

Jul 26, 2008 | 1991 Chevrolet Camaro

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...