Question about Cars & Trucks
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: I have a 2004 Toyota
You have to remove the rear door inside panel.First thing is to remove the top and side interior trim panels,they just pop out by prying them away after they are out the metal retaining clips sometimes stay in the door,pull them out and put them on the plastic panel before reinstalling.Then the strap that you use to close it has a cover on it that you have to push up to get off then remove the 10 mm bolt that holds the strap.Then pry the panel away from the door I think that the bottom has two hooks on it which means that the top needs come off first so you can lift the panel hooks out of the slots.Once the panel is off you will see the bulbs they twist out and you have to pull the bulbs out.Good luck
Posted on Nov 29, 2008
I had to replace my passenger side mirror on my 2004 Sienna a while back. I took some pictures as I did it. Maybe this can help.http://time4nothing.blogspot.com/2008/03/fixing-04-sienna-passenger-side-mirror.html
Posted on Oct 04, 2009
Try this.....Find the latch on the door, stick your finger in the hole, lift up and pull the door handle at the same time, the inside latch mechanism should go up, then try the door again. It would be nice if that's all it was huh? Sometimes they stick when they get too cold. If this works for you....spray it with some WD-40 or graphite. Hope this worked for you. Cheaper than the 2000.00 motor!
Posted on Feb 05, 2010
If you have the HID bulbs, and there is moisture in the bottom of the assembly, the high voltage box at the bottom will not work. this requires removing the whole headlamp, removing the circuit board from the bottom and drying out. I have done mine twice before finally finding how water was getting in at the top seam of the lamp assembly. You will have to dis-assemble part of the wheel well and bumper cover to gain access to all the mounting bolts. Best of luck
Posted on May 02, 2010
Tips for a great answer:
Nov 29, 2015 | 2005 Toyota Sienna LE
Jan 12, 2015 | 2004 Toyota Sienna
Jul 13, 2014 | 2004 Toyota Sienna
Mar 19, 2013 | 2006 Toyota Sienna
Feb 10, 2013 | 2006 Toyota Sienna
May 13, 2012 | 2009 Toyota Sienna
Apr 03, 2012 | 2004 Toyota Sienna
Feb 01, 2012 | 2007 Toyota Sienna
Dec 19, 2011 | 2006 Toyota Sienna
Mar 20, 2009 | 2004 Toyota Sienna
21 people viewed this question
Usually answered in minutes!