Question about Cars & Trucks

Open Question

Where is the abs fuse on a 2005 gmc sierra

I tried to pull the fuse but it wont come out, it is a 60A and takes 2 spaces of a normal fuse. is the fuse supposed to pull out? it is not soldered?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2003 GMC Sierra heater Blower wont shut off

My 2003 Sierra's blower came on by itself in the garage while I was sleeping and ran the battery completely down. I had to replace the blower switch located under the glove box next to the blower at the bottom of the right corner of the dash. The switch is in front of the blower and held in by two screws. Disconnect the two wire connections. This is a "dealer only" part and cost me 65.00. Also check the wire harness with seven wires connected to it for melted plastic. It will be marked "ABCDEFG". If it has melted, you'll need to replace it. Pay attention when reinstalling either part, that the wires "ABCDEFG" match the switch in that order.

Posted on Jan 17, 2009

  • 1 Answer

SOURCE: 97 sierra ABS problem

ABS comes on all by it self at low speed braking, A GM defect with their brakes!!!! Sensor thinks the tires are locking up an puts on the ABS, my advice pull the ABS fuse the brakes work better!!!!! Sensor is **** never had a problem with my Honda's ABS I sent a letter to GM 0 response, never will buy one again!!!

Posted on Feb 28, 2009

  • 117 Answers

SOURCE: 2001 GMC SIERRA . ABS LIGHT STAYS ON

Wheel speed sensors misadjusted, damaged , or metal shavings and other debree, since they are magnetic can give false readings from one of the wheel circuits. Over sized tires can give of false speed readings as well. there are many other causes including bad relay, control module, e.t.c. It is best to have the proper scan tool to diagnose an ABS problem

Posted on Jul 09, 2009

  • 323 Answers

SOURCE: The blower motor in my 2005 GMC Sierra won't turn

passenger side under dash by blower there is a thermistor that is fried remove it from housing and replace

Posted on Oct 24, 2009

  • 172 Answers

SOURCE: 2005 GMC Sierra 1500 - heater blows, but only cold air

Check coolant level. Check for heat at the heater hose going from water pump to heater core at firewall. Check to see that cable is moving coolant control valve from the closed to open position. Low mileage so it shouldn't be plugged heater core.

Posted on Jan 07, 2010

Testimonial: "You were absolutely correct. Low coolant level. Put in some 50/50 and we're nice and toasty now, but need to find out why coolant was so low. Thanks."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1995 Toyota RAV4 and would like to know about the fuse ABS 60A as I am missing this fuse.


ABS labeled fuses of this era Toyota are for ABS (anti-lock) brakes.
It shouldn't hurt to replace it, but the anti-lock may not be working correctly is why someone removed it. The anti-lock may sense incorrectly and engage when it's not needed.

Sep 03, 2016 | Toyota RAV4 Cars & Trucks

3 Answers

I have a 2005 GMC Sierra. Afew years ago I started having trouble with the A/C fan. Found overheating at connections on control module. Jumped some wires and have every speed except highest. Was s


If you don't have wiring diagrams,can't read them,&
or work on your own vehicles & their technology,then
a repair shop or different dealer, is you only option,that
question you knew the answer to

Sep 07, 2014 | 2005 GMC Sierra

1 Answer

I have 2 codes, p0440 and p0449. what should i do to fix these codes?


I have the same two codes on a 1999 silverado vin t ...changed purge solenoid and got ac delco 214-2081 as a solution. Didn't work. Would your 30amp ABS fuse happen to be pulled from your underhood fuse box ?

Feb 03, 2011 | 2000 GMC Sierra

1 Answer

I have a 2005 gmc siera .I undid the battery and I now have heat on the driver side ,but now it wont go back to a/c. i think it is the door motor. how do i get the center consol out.( mine is digital not...


Before you do anything pull the HVAC fuse in the under-hood fuse box for 30 seconds. Reinstall the fuse. Turn the key to the run position. You should hear the HVAC going through a self test. Don't touch anything until it is done. Once its done, about 45 seconds or start up the vehicle and see if everything is working.

Sometimes it takes several tries to get it to work.

Jan 05, 2011 | 2005 GMC Sierra

1 Answer

When braking on hard surface, just before dead stop, the last few feet, the ABS brakes takes over and the veh caries on a few more feet, finishing with a slow stop. The 4 wheels braking system were bled...


There was a TSB on this issue with your Sierra, a faulty or dirty ABS sensor is the cause of this problem. The fix is simple, just clean the ABS sensor at the front hub with brake parts cleaner and inspect the wire leads. At worst you may have to replace the sensor it self. Good luck

Feb 17, 2010 | 2003 GMC Sierra 1500

1 Answer

I need a diagram of the underhood fuse block for my 2002 ford explorer. I don't have an owners manual.


Fuse/Relay Location*Fuse Amp Rating* Description
1 60A** PJB 2 30A** BSM 3 20A** Not used (Spare)
4 30A** Rear defrost 5 40A** ABS (pump)
6 60A** Delayed accessory circuit breaker
7 20A** Power point #2 8 — Not used 9 20A** Power point #1
10 30A** ABS module (valves) 11 40A** PTEC
12 50A** Ignition relay/Starter relay
13 40A** Trailer tow battery, Trailer tow turn signals
14 10A* Foglamps 15 15A* Memory (KAPWR)
16 15A* Headlamp switch 17 20A* 4x4 (v-batt 2)
18 20A* 4x4 (v-batt 1) 19 20A** High beam relay
20 30A** Electric brake 21 30A** Front wiper motor
22 20A** Autolamp; Low beam 23 30A** Ignition switch
24 20A* Rear Fog Lamps 25 – Not used
26 15A* Fuel pump 27 20A* Trailer tow lamps
28 20A* Horn relay 29 60A** PJB 30 20A** Rear wiper motor
31 — Not used 32 — Not used 33 30A** Auxiliary blower motor 34 30A** Power seats, Adjustable pedals
35 20A** Rear power point 36 40A** Blower motor
37 15A* A/C clutch relay/Transmission
be7a74c.jpg

Nov 15, 2009 | 2002 Ford Explorer

3 Answers

Both brake and abs lights are on. I've replaced both front wheel hubs, and checked all fuses.cant seem to locate the problem


you have an ABS code in the ABS computer. You most likely damaged an ABS sensor. even after myouo fix this you will need to get the code cleared
NOTE: autozone wont be able to access the ABS computer.

Aug 03, 2009 | 2001 GMC Sierra 1500HD

1 Answer

99 gmc sierra... seems like the abs is taking over while stopping, usually while pulling into a parking spot. Pedal gets stiff and no matter how hard I push, it resists. Let off and hit the pedal again and...


It sounds like it's the ABS module has gone bad, your going to have to take it to the dealer and have them service it. There are special tools that the average person don't have in there tool box. You can go to Auto Zone and see if there are any DTC codes, but if there are no light on the dash. It may not show any and the dealer will have to test the module. Good luck and hope this helps. keep me posted, be glad to help.

Jun 09, 2009 | 1999 GMC Sierra

3 Answers

97 sierra ABS problem


ABS comes on all by it self at low speed braking, A GM defect with their brakes!!!! Sensor thinks the tires are locking up an puts on the ABS, my advice pull the ABS fuse the brakes work better!!!!! Sensor is **** never had a problem with my Honda's ABS I sent a letter to GM 0 response, never will buy one again!!!

Feb 28, 2009 | 1998 GMC Sierra

2 Answers

ABS Pump wont shut off


go to www.modulemasters.com

The dealer will charge you $1300 - $2000. Contact Module Masters. They are great to deal with. You have to ship it to Moscow, Idaho. It cost me about $15 to ship it (with box, packing, and insurance at a UPS store). They charged me $130 to rebuild it and gave me a 5 year warranty. It cost $8 to ship it back. To in total, it cost me $153....totally turn-key.

Jun 30, 2008 | 2002 GMC Yukon XL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...