Question about 2003 Hyundai Santa Fe

Open Question

2003, 2.4L Santa Fe jerks when accellerating

Jerks especially in 2nd and 3rd, less in 4th and 5th. It will also ocassionally stall for a couple of seconds when driving

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 134 Answers

SOURCE: Hyundai Santa Fe 2005 won't shift into first gear

Most likely the o-ring seal between the torque converter and the transmission is going bad. Get that transmission rebuilt pronto before serious damage is done! But first, have a mechanic drop the transmission pan and look for signs of a very thin silvery film coating the inside of the pan. If found, then the transmission definitely will have to be rebuilt, and the torque converter will also have to be replaced since embedded metallic particles in the old torque converter will eventually come loose, due to wear of the clutch plates within the torque converter, and eat up the rebuilt transmission. Now, here is the deal once the transmission has been rebuilt:

Change the transmission fluid and filter once a year -- no matter what! If you do this, then you should never have any more problems with the transmission.

Posted on Apr 20, 2009

Ad
  • 1348 Answers

SOURCE: Santa Fe makes jerking motions

the air conditioning changes your idle speed when the compressor cycles on and in some vehicles will cause the problem you have.
it is the design and there is nothing you can do about it

Posted on Aug 19, 2009

ghost45
  • 1280 Answers

SOURCE: my 2002 Hyundai Accent goes into 1 gear smoothly,

CHECK ENGINE light??? Whenever the 'CHECK ENGINE' (Service Engine Soon) light comes on, the ECU (Engine Control Unit) sets a Diagnostic Trouble Code (DTC). These codes identify the particular engine management system which caused the light to come on.
You'll need to use/find an OBDII (On-Board Diagnostic) Scanner to retrieve any code which have been stored in the ECU computer. Afterward, we might be able to help you DIAGNOSE the problem and perhaps eventually fix the problem.

Posted on Oct 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2002 santa fe auto 4 speed it well all way to 4th gear after about 10 miles itwill dropin to 3rd gear and lock in and stay in 3rd til you turn it off. Can you help.


Your transmission probably has electric solenoids controlling the various gears. You need to have them checked out for proper operation especially the one responsible for your 4th gear..

Feb 23, 2017 | 2002 Hyundai Santa Fe

1 Answer

What is causing a couple of second judder when accelerating away after changing from 2nd to 3rd and 3rd to 4th gear ?


it may be from failing engine mounts allowing the engine to misalign the drive shaft under acceleration and allowing problems in the cv joints or "U" joint

May 12, 2016 | Ford Cars & Trucks

1 Answer

My 2004 Hyundai Santa Fe hesitates when I start to drive at times - after that initial couple of "jerks" hesitation it's fine?


cud be a failing fuel pump or ignition system needs tuneup--get car scanned at a partsplace

Sep 10, 2013 | 2001 Hyundai Santa Fe

1 Answer

2003 4cyl Santa Fe has intermitent jerking that sometimes results in stalling. Increasing in frequency. Recently had tune up, new belts and fuel line clean out. This jerking was happening before tune up...


Scan for codes. Discribe when it jerks! Under a load,going up hill,pulling away from a stop? Does it shift okey? Possibilities--Bad ignition coils, Bad Throttle Position Sensor, Bad EGR Valve,Dirty Throttle Body ETC.

Mar 11, 2010 | 2003 Hyundai Santa Fe

1 Answer

When i shifts from 1st to 2nd it jurks hard and


you may not have trans problem at all. most of the time your motor mounts when worn out or broken can cause a hard ****. Put your car into gear with your foot on the brake and give some gas abrubtly and see if your engine jumps. do the same in reverse. remember to use the brake and have your hood open to see if your motor jumps.

Feb 13, 2010 | 1998 Honda Accord

3 Answers

Renault Megane Scenic 1.6 petrol jerking in 1st & 2nd.


check hoses for splits...i had the same problem.

Jan 29, 2010 | 2000 Renault Sportwagon

1 Answer

1st, 3rd & 5th gear


how about the 4th gear?

if its fine in the 4th gear, its your transmission. if you have automatic I would try to replace the auto trany computer if you could find it at the wrecking yard.

Aug 14, 2009 | 2003 Hyundai Santa Fe

1 Answer

What different gear box can fit honda integra xsi vtec 1600cc b16a? i want to change my gear box ,and i want to know what exactly other gear box can fit my car?thanks its a integra bot the product can show...


J1/S1 Found in: Integra XSI/RSI (DA6) Type: Cable 1st: 3.230 2nd: 2.105 3rd: 1.458 4th: 1.107 5th: 0.848 R: 3.000 FD: 4.400 Y1 Found in: CRX/Civic (optional LSD) Type: Cable 1st: 3.166 2nd: 2.052 3rd: 1.416 4th: 1.103 5th: 0.870 R: 3.000 FD: 4.266 YS1 Found in: Integra 92-93 XSI/RSI (DA6, DA9) Type: Cable 1st: 3.307 2nd: 2.105 3rd: 1.458 4th: 1.107 5th: 0.880 R: 3.000 FD: 4.400 S80 Found in: Integra Type R 98+ (LSD) Type: Hydraulic 1st: 3.230 2nd: 2.105 3rd: 1.458 4th: 1.034 5th: 0.787 R: 3.000 FD: 4.785 S80/Y80 Found in: JDM SiR-G (optional LSD) Type: Hydraulic 1st: 3.230 2nd: 1.900 3rd: 1.360 4th: 1.034 5th: 0.787 R: 3.000 FD: 4.400 Y21/Y80/S80/S4C Found in: JDM 96-97 Integra R(LSD) JDM Civic R [EK9](LSD) JDM Civic SiR [EK4, EG6] JDM CR-X DEL SOL SIR (EG2)(optional LSD) USDM DEL SOL VTEC (EG2)(OPTIONAL LSD) Type: Hydraulic 1st: 3.230 2nd: 2.105 3rd: 1.458 4th: 1.107 5th: 0.848 R: 3.000 FD: 4.400

Jun 08, 2009 | 1990 Honda CRX

2 Answers

Clutch slipping?????


yeah it could be full of water in the gas you bought. see if you can pull a sample and check. start looking at the filters.

Mar 21, 2009 | 1996 Chevrolet Cavalier

Not finding what you are looking for?
2003 Hyundai Santa Fe Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...