Question about Cars & Trucks

Open Question

Can rear difriential gears be removed on a 2001 ford escape and still driven to get it home

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
fknstart
  • 404 Answers

SOURCE: removal of rear brake drum 2002 ford escape

make sure handbrake is off take wheel off hit the drum with a mallet not steel,as it will brake,hit on outter diametter face of drum, try and rotate as you twist off

Posted on Jan 05, 2009

Ad
bunnydawg
  • 5158 Answers

SOURCE: Ford Escape rear wiper doesn't remove anything

rear wipers are horrid for that... i just bent the wiper arm a little toward the window... works fine

Robert

Please take a moment to rate this solution thanks

Posted on Jan 30, 2009

landsend
  • 1066 Answers

SOURCE: ABS on 2001 Ford Escape .

could you have a low or odd sized tire on the car?  have you bumped a sensor?  Is the light on?

Posted on Apr 01, 2009

motor1258
  • 6674 Answers

SOURCE: what is throubleshot p0113 at ford escape 2001

Intake air temperature sensor faulty. Depending on what engine, may be in side of air cleaner or air intake hose , or may be part of the MAF (mass airflow ) sensor. You can try cleaning MAF with tuner cleaner from radio shack or TV repair place.

Posted on Jun 28, 2009

  • 3600 Answers

SOURCE: rear axle seal leak 2001 ford escape xlt

First check if the vent cap is plugged, to do that find the T shaped object on the housing spin the top of the tee if it does not move freely then pull it off and clean it. If it's leaking out of the front seal it's the drive line seal is leaking and will have to remove the drive line put Emergency brake on and block wheels and loosen 24MM nut to get to the seal you have to pop the seal off with a screw driver and you have to replace the crush bearing when you do this. However recommend you leave that to a professional or purchase a www.alldatadiy.com susbscription for your car so you know how to set up the bearings if it is needed, you will also have to have a tork wrench to tork the nut down. You will a new Nut for the pintal shaft that comes out of the front of the axle as well the nut is nut reusable once you remove it. Another note you have to have air impact to get the nut off or a torch t heat it just enoungh to get it off but warning fuel tank is right there so if your all thumbs don't mess with it. If it's not leaking from the front seal and is leaking from the back side of the differential then you must drain the oil and replace the gasket on the rear plate, this job is not to difficult but you mus be sue you put silicone on the cover and gasket and put silicone on the bolts as you put them in because if not you will get bolt leakage, these also require a tork wrench. the front seal nut and crush bearing will cost $45.00 the rear will cost $15.00 for the silicone and gasket. And warning if the differtal is leaking from the seal it is quite possible that the bearings will need to be replaced or set up again and this takes experince or it could cost you $750.00 to rebuild the differital. hope this helps.

Posted on Oct 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rear axel removal on a 2006 Ford Escape


If the axles are C-clipped in place, you will have to remove the differential cover to access the clips, which are on the inside of the spider gears.
However, I am just taking a guess, because I cannot see the vehicle you are working on, nor am I familiar with a Ford Escape.

Jan 26, 2014 | Cars & Trucks

1 Answer

2005 ford escape how are the axles removed from diff? similar to front end, or is there a fastener on the inside of the diff/carrier?


The axles are held in place by "C" clips inside the of the gear carrier, you must remove the rear cover and then center spider gears to access them.

Sep 19, 2011 | 2001 Ford Escape

1 Answer

Where are the spark plugs for the 2001 v6 ford escape


Three in the front under the engine cover, then under the coil packs, there are three more in the rear of the engine at which you must properly remove the intaker manifold and do this by procedure or risk warping the head and manifold. If you must ask, I highly suggest taking this to a pro. Sorry

Jul 13, 2011 | 2001 Ford Escape

1 Answer

What weight rear axle differential gear oil is required for a ford 2001 escape?


4 wheel drive? size motor? shows either 75-90 or 80-90 depending if its 4 wheel or size motor

Jan 30, 2011 | 2001 Ford Escape

1 Answer

2001 Escape XLT. When first using car, when I shift from Park to Reverse or Drive the car hesitates for about 1 second then a pop is heard in the rear and car moves. This does not happen if the car is...


Sounds like it could be a sticky brake on one of the rear wheels. this would only happen after the car has stood still for a while, nothing to worry about if this is the case but if you want it to stop you can inspect the rear calipers or ask a mechanic to check them.

Dec 27, 2010 | 2001 Ford Escape

1 Answer

I tried to put my Ford Escape 2001 in gear yesterday and the gear shift just slid up and down the shaft without catching on a gear.


sounds like the link on the box has poped off have a look under the car at the selector arm if its not moving the shaft its the gear linkage in the car

Oct 30, 2009 | 2001 Ford Escape

1 Answer

Ford Escape rear wiper doesn't remove anything


rear wipers are horrid for that... i just bent the wiper arm a little toward the window... works fine

Robert

Please take a moment to rate this solution thanks

Jan 30, 2009 | 2005 Ford Escape

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...