Question about 2009 Chevrolet Traverse

Open Question

Ac low pressure valve charge located high - 2009 Chevrolet Traverse

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
mcgyver468
  • 710 Answers

SOURCE: location of low pressure ac valve and type of

SHOULD BE IN THE FRONT OF THE ENGINE SORT OF LOW, IN FRONT OF THE FAN. IT HAS A BLUE CAP ON THE FITTING AND THERE IS AN "L" ON IT. I HOPE MY MEMORY SERVES ME WELL. IF ALL ELSE FAILS, THEN LOOK FOR THE LARGER OF THE TWO LINES MADE OF ALUMINUM, COMING FROM THE CONDENSER. WELL I HOPE THIS HELPS YOU. PLEASE KEEP ME POSTED. THANKS FOR AN HONEST RATING AND FOR USING FIX-YA. GOOD LUCK

Posted on May 19, 2009

Ad
emissionwiz
  • 76846 Answers

SOURCE: need to service ac

THE VALVE U WANT IS IN THE LOW SIDE OF THE AC SYSTEM, THE LOW SIDE IS THE LARGER OF THE 2 LINES FROM THE AC COMPRESSOR, IT WILL BE NEAR THE REAR OF THE ENGINE COMPARTMENT.

Posted on May 26, 2009

ginko
  • 19396 Answers

SOURCE: AC Low Pressure location on 2004 Chevy Suburban

You find the AC low pressure at the top of the compressor, orientated toward you , facing the front of the vehicle. You can also follow the compressor line to reach the port.

The valve is covered a plastic cap covering it.
Near the compressor you find two ports, the high port and low port.

To find out which one is the low port, run the air conditioner for a couple of minutes withthe engine on.
Then turn off the care and touch the lines from compressor to the two ports covered with plastic caps. Only one of the pipes will be cold, the cold line will lead you to the low port.

Regards.

Posted on Jun 18, 2009

  • 82 Answers

SOURCE: Where is the low pressure line AC for Express 1500

Look for the accumulator(silver can a/c lines go to) on the passenger side of engine area. The Low side charging port cap should be on the side of the accumulator.

Posted on Jun 23, 2009

co7196
  • 3433 Answers

SOURCE: I need a wiring diagram for the ac to find the high and low pressure valve and the compressor switch .

No you don't. The hi/lo awitch is on the tubing at the drier.

Posted on Jun 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the low pressure for AC located on 2000 Lincoln Navigator


The low pressure port is the only one that your AC charging tool will fit on if you are planning to charge the AC unit with refrigerant. The high side port is much larger and the quick connect tool won't fit it. Look up high toward the firewall on Fords and Lincolns.

Aug 16, 2010 | 2000 Lincoln Navigator

1 Answer

Audi A4 Ac charge valve.


On that year a4 and a6 there is no low side charging port. (sucks)
The way you charge those systems is by evacuating all of the refrigerant, then with the vehicle off, add the correct amount of refrigerant to the high side port (turning the compressor over by hand occasionally)

Sep 11, 2009 | 1996 Audi A4

2 Answers

Where is low pressure port located on 1999 acura


look for the large ac line/hose and follow it untill u come to the small service port this is wher u charge the small ac line/hose has the large port this is the high side

Jun 29, 2009 | 1999 Acura 3.5RL

2 Answers

2004 Lincoln LS A/C Valve


In order to charge, you must locate the low pressure valve to install the refrigerant. The low pressure valve is between the compressor and the evaporator. Do not charge on the High Pressure side, The high pressure valve is between the compressor and the condenser. To locate the low pressure valve, follow the line that comes from the compressor and routes toward the firewall. The valve will be somewhere on that line. Do not overcharge. The amount of pressure that is needed on the low pressure side will depend on the ambient outside temperature.

Jun 21, 2009 | 2004 Lincoln Town Car

2 Answers

I want to put some freon into the AC but cannot locate the "low" valve. The RedTek guage will not fit onto the "high" valve.


follow the lines coming out of and into the compressor. The line leading from the firewall to the compressor is the low pressure line.
the line going from the compressor to the condenser located in front of the radiator is the high side.
Always charge with can in upright position through the low side line into the compressor.

Jun 05, 2009 | 2003 Toyota Corolla

2 Answers

AC Wont charge after replacing components


whenever the ac system has been opened it should be hooked up to a vacuum pump designed to evacuate the ac system of any foreign debris and oil etc and after should be able to hold a vacuum to show that there are in fact no leaks then if all is ok at this point you can then charge your ac with the proper freon specified for you car when the pressure reaches satisfactory level the ac compressor will then cycle on you should not bypass the low pressure switch

May 30, 2009 | 1999 Chrysler Town & Country

1 Answer

2000 ford taurus low end ac valve


please rate as fixed if this helps you.

The low pressure service gauge port valve is located on the evaporator to accumulator/drier suction line.


The evaporator to accumulator/drier suction line contains low pressure refrigerant gas and is equipped with a serviceable low pressure A/C charge valve port.

Apr 28, 2009 | 2000 Ford Taurus

2 Answers

AC has stopped blowing cold air. Compressor is working. Where is the recharge valve located?


There are two A/C refrigerant lines. The small line is your high pressure line and the larger line is your low pressure line.
Start at the fire wall and follow the "large " low pressure line to the compressor. The low pressure charge port will be some where on that line.
DO NOT try to recharge on the high pressure side ( small line )
Good luck, let me know.
Regards,

Apr 26, 2009 | 2001 Saturn L-Series

3 Answers

How can I charge the AC system is possible to install a low pressure valve?


This website has all the information you need including videos:
http://www.id-usa.com/how_to.asp
I just sorted out the aircon on my wifes Pontiac using the info here.

Aug 28, 2008 | 1996 Audi A4

Not finding what you are looking for?
2009 Chevrolet Traverse Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6924 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...