Question about Ford Escape

1 Answer

Rotor noise when driving

My 2006 Ford Escape keeps making noise almost like a scraping/skreaching noise only on the passenger rear. It just got new brakes and rotors the mechanic did get the noise to go away temporarily by pushing on the plate behind the rotor. How do I get rid of this noise cause sometimes it is really loud! And I can only notice it at low speeds

Posted by on

1 Answer

Find a repair shop that knows how the work on brakes
I have never had one issue in 50 years working on brakes
It is obvious that you got sloppy work,almost impossible
to do if you have any skills.

Posted on Jul 22, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: 1999 Chev Blazer 6cyl 4.3L

I replaced the rotors and pads on my right hand drive Blazer and had the same problem ,dont worry in a couple of days normal running the pressure goes away and you dont get the heat problem.
Its just the new pads bedding in.

J.C.
U.K.

Posted on Jul 19, 2008

jmgldsmth
  • 1869 Answers

SOURCE: R&R rotors and calipers on 2005 Ford 500 to do brake job

use a large c-clamp to bottom out the caliper pistons remove the caliper bolts .slip out the pads and remove the caliper from the disk
hang the caliper from a coathanger wire to avoid damaging the brakeline after replacement of the pads;brake bleeding is not needed Rotors are held on to the axle like a wheel; with bolts

Posted on May 29, 2009

AUTODOC01
  • 216 Answers

SOURCE: Changing the back rotors and brake pads. The

its more or less and backing plate you can drive without it it keeps brakes cool and gravell free > speaking as a tech you should replace it?

Posted on Aug 27, 2009

collegetutor
  • 125 Answers

SOURCE: Horrible scraping/scratching noise coming from wheel

Hello, this would be an easy thing to diagnose. All you need to do is jack up the front of the car, so that you can turn the wheel and listen to it while you wiggle and turn it manually. You're also checking for any wobble and wear in the front end parts at the same time. Next, remove the wheel and inspect the rotor for any scratching to the shiny surface, which could determine where the problem is. If no problem there, rotate rotor and listen for the scratching sound and you will see where its coming from by looking at the brake pads which are visible when the wheel is off.

Posted on Sep 16, 2009

githinji
  • 72 Answers

SOURCE: My 2006 subaru outback has a grinding front brake

try skimming your rotors

Posted on Feb 04, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2009 ford escape will not unlock sometimes and it makes a growling noise when driving.


the central locking works from a pump that mounted in rear side panel
your problem is possibly an air leak so the pump keeps running causing the noise while driving

Nov 21, 2016 | 2009 Ford Escape

1 Answer

Whirring Noise from Right Front While Driving


If you have access to a lift put it on and look at the area where the noise is coming from if you have a small camera try and put it somewhere you may be able to see what it is doing.
Good luck.

Feb 19, 2014 | 2005 Ford Escape XLT

1 Answer

How to change broken wheel stud on 2007 ford escape


Some just pound out of the rotor. Take wheel off and then see if you cant drive out broken stud with a hammer. Usually this is how it's done and then you can drive a new one in the back side.

Dec 31, 2011 | 2006 Ford Escape

2 Answers

I have two issues with my Ford Escape. First, the airbag light will blink for a while, then just stays on. The sequence is 4,6,4,6,4,6,4,6,4,6, then stays on. Second, when I go to stop at a stop light/sign...


You need to have the Airbag System serviced because you have a bad sensor or fault with the Airbag. You need to service the brakes most likely you will end up replacing both front rotors as well as the Front pads. The passenger side caliper tends to dig into the back side of the rotor in the escape for some reason and since you always want to replace these in pairs so they have even pressure you will need to replace both.

Aug 11, 2011 | 2003 Ford Escape

1 Answer

Rear Brake on passenger side makes a noise like a high speed rub


Thanks for the inquiry.
This sounds like the either the tattle-tail is giving you a signal the the brakes are worn and need to be replaced before they wear the drum/rotors. Depending on the extent of the sound it may also mean the shoes/pads are worn down far enough you have metal on metal scraping the rotors/drums making this noise when you apply the brake. In either case it's time to re-build your rear brakes.
Kind regards,
TF

Jun 04, 2011 | 2007 Pontiac Vibe

1 Answer

My ford escape makes whining noise and noise at the back passenger side


I HAVE AN 01 ESCAPE, MAKES POPPING SOUND WHEN USING 4X4. RUBBER MOUNT BUSHINGS IN REAR SUSPENSION.

Aug 06, 2010 | 2005 Ford Escape

1 Answer

I have a clicking and grunting noise from rear brakes, also a scraping noise on a 2006 NISSAN ALTIMA. i was told by one mechanic that cheap brakes and rotors make noise like this and that I should change...


this could be true. if the rotors are worn down(if it looks and feels as if there is a lip on the edge of the rotor) then most likely you may need to have them replaced.

Jul 30, 2010 | 2003 Nissan Altima

1 Answer

2002 Ford Escape 2WD. No drive on passenger wheel.


the reason you could do that was because it does not have positraction in the differential and it is designed that way for when you take turns so each axle can spin at a different speed. and the ginding noise with the brakes can be misinstalled hardware or a warped rotor.

Apr 10, 2010 | 2002 Ford Escape

1 Answer

Ford F150 2004 4x4 passenger side rear wheel noises


You can try the bearings but I think if you take off the rear rotors and look at the emergency brakes you'll find the problem. You might want to ride the emergency brake a little in lieu of removing the rotors to confirm the problem. Also some wheel covers make noise-drive without them and see if it helps.

Jun 18, 2009 | 2004 Ford F150

1 Answer

R&R rotors and calipers on 2005 Ford 500 to do brake job


use a large c-clamp to bottom out the caliper pistons remove the caliper bolts .slip out the pads and remove the caliper from the disk
hang the caliper from a coathanger wire to avoid damaging the brakeline after replacement of the pads;brake bleeding is not needed Rotors are held on to the axle like a wheel; with bolts

May 29, 2009 | 2006 Ford Five Hundred

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...