Question about Cars & Trucks
The light means the alternator is not charging the battery.
You would need to get the alternator and charging system checked out.
Posted on Jul 21, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The system needs to be checked for cades. Airbag codes are pulled out
of the ECU with the use of a scanner tool. A good auto mechanic shop
will have this or you can go to the dealer. YOU SHOULD NOT TRY TO
REPAIR THIS YOURSELF,YOU COULD ACTIVATE THE AIRBAG!!!!!
Posted on Nov 11, 2008
IT COULD BE SOLENOID PACK OR THE GOVERNOR AND TRANSDUCER OR LOW FLUID OR THE MOST COMMON REPAIR SPEEDS SENSORS INPUT/OUTPUT. ALL OF THESE CONTROLS THE SHIFTING. START WITH THE SENSORS FIRST, VERY COMMON.
Posted on Jan 02, 2009
It probably will cost a few bucks to get the code reset, but you don't need to go to the dealership, most shops with a good scanner equipped for air bag code reading will be able to diagnose and reset the light. The most probable reason for the code is the battery being dead for a while, there is a capacitor in the airbag circuit to make sure the airbag can go off in a collision even if the battery disconnects itself in the process. There is a slim chance it might be something else but either way the shop should be able to tell you what the problem is, and get it fixed... But, just for fun, before doing all this, i'd disconnect the battery for 30 minutes to an hour and reconnect it back, some systems do effectively reset themselves this way.
Posted on Jan 13, 2009
It is the blower motor resistor. Look under the passanger side dash and locate the fan housing (looks round and black in color. Then locate the resistor it will be in that housing usually withtwo ten millimeter nuts or two simple screws holding it in. unplug the harness to the resistor and remove the resistor. Part store price is approx. 50.00. Note: on aftermarket (not Jeep) resistor sometimes you have to modify the housing a little to get it in. Hope this helps.
Posted on Feb 01, 2009
SOURCE: Jeep Liberty Clicking Noise
Check the wheel bearings. Run the car and check where the noise is coming from. the wheel bearings make a gravelly, clicking noise if the bearing is bad. Lift the car and move the wheels up and down , to the sides etc. Listen or if the wheel moves , your bearing may be bad.
Posted on Feb 06, 2009
Tips for a great answer:
Dec 02, 2016 | Jeep Cars & Trucks
Dec 08, 2015 | 2005 Jeep Liberty
Nov 29, 2013 | 2003 Jeep Liberty
Oct 28, 2013 | 2003 Jeep Liberty
Jun 22, 2013 | 2003 Jeep Liberty
Feb 05, 2013 | 2003 Jeep Liberty
May 17, 2010 | 2003 Jeep Liberty
Mar 16, 2010 | 2003 Jeep Liberty
Mar 06, 2009 | 2005 Jeep Liberty
58 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: