Question about 1995 Geo Metro

1 Answer

Running issues I have a 1995 geo Metro. this car sit for over a year and was only started a few times. it had a 1/2 of a tank of gas in it. now that im driving it again. it started out running very rough, not wanting to start or stay running. I noticed that there is a white bubbling mixture coming out of the intake area of the carborater. I was advised to put seafoam in the gas, I did that and it is running better to a point but now when starting it up first thing of the day it starts right up and runs but shows signs of dying out when you try and pullout at times. once you get going the car runs great, stopping it show signs of dying out. then once you turn the car off, it will not start back for bout 30 minutes or so. when trying to start it almost starts spits and sputters but doesn't. to add to this it blows steam out of the over flow area from the radiator, no water really just steam. the head gaskit was replaced all new sensors belts hoses last year. I replaced air filter and replaced air filter this week. I have drove the car about 300 more or less miles this past week. it seems to run better everyday, but I cant keep it running any ideas?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 352 Answers

BASICS, BASICS, BASIC......
**CHECK PLUGS, WIRES, FUEL FILTERS, RUN CAR AT HIGHER RPM AND SPRAY CARB CLEANER DIRECTLY INTO CARB, CHECK (WITH SPRAY CAN OF CARB CLEANER) FOR VACUUM LEAKS BY SPRAYING ALL AROUND INTAKE AREA, VACUUM LINES ETC...
IF IDLE SMOOTHS OUT OR RAISES..CHANCES ARE THERES A VACUUM LEAK

Posted on Jul 21, 2013

Testimonial: "Plugs and wires were replaced sorry I forgot to add that. "

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why will my 1995 Geo Metro not start?


You have a pick-up coil in the distributor that tells the computer when to fire the injectors, I would guess this might be your problem, you are getting fuel to the injectors, but not into the engine.

Aug 09, 2014 | 1995 Geo Metro

1 Answer

1995 geo metro running issues


a GM suzuki swift.
G10 or G13 engine? both are EFI no carbs here, in USA. 95.
last carb usa 1994 Isuzu.
OLD gas goes bad clogging that Injector or if MPI ? injectors.
Old spark plugs cant burn old gas, like a double bad effect.
give a tuneup> last decade?
Nix, that sEA-Floam, use Chevron, Techron injector cleaner
its got the REAL clearer called Benzene, costs more but is MORE.
all that said , i never use additives. (snake oil ever)
after all cleaning and injection system correctly is hard work.
so I offer this comment based on, (fast and dirty fix)

sure, ISC dirty, they love to jam parked for a year.
EGR and PCV gasses, there form gunk,
Gunk cloggs, ISC, valve, (electric) idle speed valve
i cant drive car, see if right for overcomes a dead isc easy
if the lower RPM is from MISFIRE< i can hear it and feel it.
and Misfire has over 50 causes, spark plugs bad tops the list.
when it wont start to the operator guide , stated unflood method work. cranking wide open throttle, work?
I bet the PCV is clogged to. valve

steam, is a whole other matter, non of which is good
do a hard leak down test?
new head, was it milled (shaved) or put back not checking
for warp-age like the Service manual directs?
warped head bust be de-warped using baking oven.
Ask your machinist this is knows this very well on alumin, heads.

Id work steam issue, hard and not drive too far, like that,
Most heads replaced, DIY fail.
for 2 reasons,
not dewarped, and not surfaced correctly and other reasons.

Mar 04, 2017 | 1995 Geo Metro

1 Answer

I have a 1997 geo metro and I want to use parts from it to keep my 1995 geo metro running. Is this possible? specifically an alternator.


Body parts change ever so much from year to year, but the engine parts(if same size engine) should. On the body parts, you will just have to check.

Dec 29, 2010 | 1995 Geo Metro

1 Answer

I took motor/tranny out of well maintained/well running 1994 Geo metro xf and installed them in a 1995 geo metro LSI. everything went well i had to use the 1995 intake and throttle body due to wiring...


Yes, because the specs are different... most manufatures change the specs on vehicles every four years, so 90-94 is most likely all the same, but then you will have 95-99 an so on an so on.. Good Luck

Oct 23, 2010 | 1995 Geo Metro

1 Answer

1996 geo metro dies when gas is applied. its runs but then it dies when you give it gas, but there was a new gas filter that was just put on,


try holding a lit match near the gas tank to see if the gas is good. if it explodes bad gas was not your problem

Jun 13, 2009 | 1996 Geo Metro

1 Answer

Geo Metro 1994, diagnose no fuel presure problem.


Quite a few things can cause a car to die after idling for awhile, but if you have verified that the fuel pressure is actually dropping when the motor dies, the likely culprits are:
1) Electric fuel pump in the gas tank is bad
2) The fuel pressure regulator (on the throttle body) is bad
3) An electrical problem in the power to the fuel pump (like a bad fuel pump relay or lose ground wire to the relay's circuit)

Apr 04, 2009 | 2006 Geo Metro

3 Answers

1992 geo metro cranks but does not start. Will


check compression on all cylinders or the timing. both could cause puttering but no starting.

Mar 29, 2009 | 1992 Geo Metro

1 Answer

High-beams not working


U are going to have to replace the mulitfunction switch if the bulbs are not the problem

Nov 16, 2008 | 1995 Geo Metro

3 Answers

Need 2 get truck started


I had a geo metro that sat a long time and the gas turned to varnish. You will need to drop the tank, clean out the gunk, put in a new fuel pump and and filter and flush the fuel lines out to the injectors.

Sep 05, 2008 | 1990 Ford Bronco II

Not finding what you are looking for?
1995 Geo Metro Logo

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8211 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...