Question about Chrysler Sebring

Open Question

Codes p1296 1996 sebring just stops running when driving,,,got this code what could it be

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2005 Sebring runs fine until I spend more than 10 min in stop and go traffic, then engine light comes on and engine stumbles as soon as it hits 2200 rpm, will not exceed that rpm driving or in park....


Scan the engine computer for trouble codes, and go from there. with the light on, there will be a code or more to follow. Some stores, like Autozone, will do code scans for free. If you get a lot of codes, first attend to those that indicate the problem you are having.

Mar 14, 2015 | 2005 Chrysler Sebring

1 Answer

2001 sebring 2.4L - car runs smooth, but idles rough intermittently.. not bad in neutral. but worse when in drive a stop, and very bad in reverse backing out.


Hey Miles ,did you get any codes from computer ? with car off put key in ignition and turn it off and on 3 times fast without starting motor and stop with key on ,that will activate on board diagnostic watch where speedometer millage counter is it will show codes ,example =P0442
when you see them wright them down ,when all codes have been retrieved dash will say DONE that's a start. most part stores can tell you what codes mean. I hope this helped if it did please check box below (helpful), thanks Woody.

Oct 12, 2014 | Chrysler Sebring Cars & Trucks

1 Answer

No wipers or turn signals on 2002 sebring


bay 15, 10 Amp (red Fuse) under dash at driver side door end (door marker "pull") ... U really do gota Pull!

Dec 29, 2012 | 2002 Chrysler Sebring

1 Answer

2003 chrylser sebring 3.0 transmission suddenly stop work. No troubleshoot codes show up when tested


transmission fluid filter been changed every 60000 miles. intervals.if all is good transmission oil pump could have failed if lost all drive ranges.

Dec 15, 2012 | 1998 Chrysler Sebring

1 Answer

2002 sebring sudddenly will not rev over 1500 rpm


start car, try to rev (try to cause error)... allow to idle for 30 secs
shut off car, with car stopped, turn key, on-off-on-off-leave on. codes will be displayed in odometer readout.

if code P0340 it is the cam sensor, very easy fix, one bolt.

Apr 16, 2012 | 2002 Chrysler Sebring

1 Answer

My 2000 Chrysler Sebring stops running. After a few minutes it will start again and run fine. This situation just started happenning a few months ago and is increasing in frequency


is the check engine light on??
i've done a few that had no light/codes.the most common problems are crank or cam sensor failures. really need to check when car stalls.
replacing crank sensor 6 mths ago & car has'nt had a problem. if you search these sensor on the sebring you'll find alot of info.

Jul 12, 2011 | 2000 Chrysler Sebring

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...