Question about Cars & Trucks

Open Question

How to remove headlight cover pajero 2002

How to remove headlight plastic cover on pajero 2002

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1861 Answers

SOURCE: Chg Passenger Low Beam Headlight 02 Toyota Celica

Remove the plastic cover. No need to remove the assembly.

Posted on Sep 29, 2008

Ad
  • 99 Answers

SOURCE: Remove rear plastic bumper cover

please email me at meanness628@aim.com with any other info or questions if you have already gone to a body shop

Posted on Sep 29, 2008

  • 1 Answer

SOURCE: How do I remove headlight cover in Subaru 1998 brighton wagon?

Hi ' this sounds a bit daft but it works ' put the light unit in the oven on a low heat for about 45 mins ' this should be enough to soften the seal and allow the light to be opened ' you need to re-seal again after bulb replacement

Posted on Jan 02, 2009

  • 408 Answers

SOURCE: remove headlight cover for 2002 elantra

You shouldn't need to.  If you pop your hood open, you can unplu the headlight hardness from the bulbs.  Then you should be able to turn the bulb assembly about a 1/4 to 1/2 turn and they will come right out.

Posted on Mar 21, 2009

  • 2 Answers

SOURCE: How do I remove the plastic headlight covers to clean them?

Remove the screw on top of the lamp assembly. The lamp assemble come off as one unit. There are three contact clips that hold the lamp on. They may be frozen fast. Try spraying oil to loosen before removing lamp assembly. To remove the lamp, push down on the top of the lamp, this should loosen the top pin from the holder,then try to pull the assembly straight out. It takes some tugging and pulling if the light assembly has been in for a few years. In fact the clips may snap off and need to be replaced before putting in a new lamp assembly. Good Luck

Ed

Posted on May 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you replace the headlight on a 2002 Daewoo Lanos


Hi there, together with providing you the solution to the problem, I also took the liberty of going one step further in giving you steps on how to remove the headlight bulb.

  • Find the hood release handle and activate it, the hood should pop open.
  • Once the hood is popped open locate the hood secondary or safety latch and release it. Then finish opening the hood.
  • Locate and remove mounting clips for any plastic shields that cover the headlight lens mounting screws or clips.
  • Some headlight bulbs can be replaced by simply grasping the bulb socket behind the headlight lens and turn it counter clockwise to remove it. This will expose the headlight bulb.
  • If the headlight bulb socket is not accessible the headlight lens may need to be remove or obstructions behind the bulb removed to gain access to the headlight bulb socket.
  • To remove the headlight lens remove all mounting screws and clips that hold the headlight lens in place.
  • After the headlight housing has been removed from it's mounts, release the headlight bulb from the headlight lens housing (turn counter clockwise) the bulb will then come out of the headlight assembly. Once removed, visually verify that the replacement bulb is exactly the same as the failed bulb before to ensure a proper repair.
  • Clean the headlight lens free from all debris to help maintain the seal from the bulb to the lens. This will keep moisture out of the lens.
  • Install the new headlight bulb by turning the retainer ring or bulb clockwise.
  • Re-install the headlight lens housing and reinstall electrical connector.
  • Re-install plastic covers.
After the job is complete turn the ignition key to the "on" position and activate the headlight switch. Observe the newly replaced headlight bulb to ensure proper operation.

Glad to be of help!!!

Jan 21, 2011 | 2002 Daewoo Lanos

1 Answer

How to remove headlamp assambly in a volvo s60 2002


Hello,

This should be fairly simple,one may have to remove the grille.

  • Remove trimmings on the front bumper cover to allow access to the bolt for removal of the front bumper. The trimming can be removed simply by prying the trimming from the center of the bumper cover using a Philips screw driver.
  • After removing the 2 bolts on the bumper cover, you may open the hood and remove the plastic fasteners on the top of the bumper.
  • To remove the plastic fastener, simply depress the center until click. Do not press too far or the fastener will be damaged.
  • Turn the Torx screw in the wheel well counter clockwise to loosen the catch plate on the bumper. Lift the bumper cover over the catch plate and push the bumper cover forward. This completes the removal of the front bumper cover.
  • To remove the headlight assembly, you will need to loosen the bolt on the retainer near the wheel well. You will then remove the 4 bolts that hold the headlight assembly.
  • There is one bolt on the side of the headlight assembly. Two bolts on top and one at the corner of the lens. They all have the same size bolt.
  • In order to remove the headlight assembly, after removing the bolts, the headlight harness needs to be removed.
  • The next step is to remove the trimming on the lens and removing the clips that hold the lens in place. There are 4 clips. One clips on each side.
  • Once the clips are removed, the lens can be pry open with screw driver. You may want to heat the edge to soften the glue or use an utility knife to scrape the edge. Be extra careful, as the glass can be very sharp if shattered. Please also wear protective gear such as safety goggle and gloves. After this, just reverse the steps to put the headlight back together.
Take care and good luck

Nov 06, 2010 | 2002 Volvo S60

1 Answer

I need to replace low beam head light lamp, right side. 2002 dts


Pop the hood, remove the plastic cover over the radiator, remove 3 screws holding headlight assembly, yank forward, remove plastic plate on the back of the assembly, carefully twist and remove old bulb, replace new one the same way. Remember to change both headlights (even if the other one still works!) Changing only one will cause the older one to burn out quickly and besides, you'll have different brightness levels. Hope that helps.

Nov 04, 2010 | 2002 Cadillac Deville

1 Answer

Can the factory headlight lens covers on a 2001 Mercury Cougar be removed and cleaned ? I can remove the entire healight assembly and change the bulbs, but the inside of the healight cover is dirty and...


The lincoln LS had the same problems, and the lens was held to the headlight assembly with a sticky glue.
To remove them, some guys were successful by warming the headlight assembly in the oven untill the glue softened up enough to be pulled apart.
Be careful if you try this, to much head and..oops I melted my headlight

Oct 13, 2010 | 2002 Mercury Cougar

1 Answer

2002 Chevy Cavalier(left light)! I know there is a clip somewhere on the headlight unit to take it out but where? I have taken off the slpash gaurd and the 2 bolts holding it in place so it wiggles but I...


dont these light have a splash guard on the inside of the engine compartment open your hood and usually theres a boot that covers the inside of your light take that off and youll see what your looking for sometimes you turn toggle counter clockwise and it should come out

Jan 24, 2010 | 2002 Chevrolet Cavalier Coupe

1 Answer

How to install headlamp on a 2002 chevy trailblazer


To change a headlight bulb in the 2002 Trailblazer: I writing this with the orientation of standing in front of and facing the Trailblazer.
Open the hood.
Remove the plastic cover that goes from the left to right over the headlight bracket, radiator, etc. It has 4 plastic pop retainers and 2 sheet metal screws. Remove the grill center bar that passes in front of both headlights. The grill and center bar come off as one piece. Start at one end and carefully pry it out, a little at a time. There are 2 clips at the headlight and 2 clips near the center top of the grill and 2 at the bottom. Two more in the other headlight.
Each headlight has 2 black metal clips that hold the assembly onto the bracket. One is above and behind headlight assembly, towards the right end if you're working on the left headlight (and visa-versa), and the other is under the fender (it pulls up OK, but may take some patience to push it back down when you're done).
Pull the entire headlight assembly forward. I only moved mine an inch or two. On the back of the assembly are round rubber covers. Pull off the one covering the back end of the bulb that needs changing. reach in and turn to bulb clockwise 1/4 turn and it will slip out.
Unhook the connector from the bulb. It has a little catch on it, otherwise it just pulls out.
Connect the new bulb.
Reassemble everything in reverse order.
As I said, the under fender clip that holds the headlight assembly on to the bracket may take some patience. It seemed to slip down OK once I had it in exactly the right position. Either that I needed to reach the required amount of cussing.
Good Luck...

Oct 24, 2009 | 2002 Chevrolet TrailBlazer

1 Answer

Remove headlight cover for 2002 elantra


You shouldn't need to.  If you pop your hood open, you can unplu the headlight hardness from the bulbs.  Then you should be able to turn the bulb assembly about a 1/4 to 1/2 turn and they will come right out.

Mar 21, 2009 | Hyundai Motor 2002 Elantra

1 Answer

How do I change the passenger headlight bulb on my 2002 Audi A6?


Here you will see the left headlight we are going to take out, but the same procedure can be applied also to the right one (click will open a bigger photo in a new window)
audi1small.jpg

First, remove the cover circled in green (just take it, it is not fixed with screws), then, with a Torx screwdriver, remove the two screws circled in red
audi2small.jpg

Cover removed
audi3small.jpg

Under (yes, almost hidden) the cables circled in red and yellow there are two more Torx screws, you don't need to unscrew them all, only make 2 or 3 rounds
audi4small.jpg

Particular of the screws under the circles in the previous photo (sorry for the bad focus)
audi5small.jpg audi6small.jpg

Last, we have to remove the power connector. To remove it, pull the little plastic block lever circled in green and then, while holding it, pull out the whole connector (in red). After that the headlight is free, and you can take it out from the chassis
audi7small.jpg

Et voila', headlight removed :) Red circles are for the vertical offset control, don't touch them unless you know what you're doing. Lights are located under the black plastic covers
audi9small.jpg audi8small.jpg

Mar 08, 2009 | 2002 Audi A6

2 Answers

2002 trailblazer


All you have to do is find the "round rubber cover" on the back of the headlamp, pry it out with a flathead screwdriver and the lamp is right there.
To remove the headlamp assembly on a Trailblazer, remove the plastic panel that covers the hood latch assembly.
Take the cover for the air filter in order to get to the low beam cover.
Take the 3 screws out of the air filter cover and remove. You will then be able to get to the back of the low beam lamp. The high beam is reachable without this hassle.


Oct 07, 2008 | 2002 Chevrolet TrailBlazer

1 Answer

Chg Passenger Low Beam Headlight 02 Toyota Celica


Remove the plastic cover. No need to remove the assembly.

Sep 28, 2008 | 2002 Toyota Celica

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...