Question about Cars & Trucks

1 Answer

1998 gmc jimmy

What are symtoms of bad flywheel

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

AUTOMATIC TRANSMISSION? GRINDING WHEN STARTING, NO TRANS MOVEMENT, NOISE

Posted on Jul 21, 2013

Testimonial: "Automatic hear a rattle at idle but not when u give it gas"

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

bryant329
  • 125 Answers

SOURCE: TPS in a 1998 GMC Jimmy

the tps is ususally at the side of the throttle body opposite where the throttle cable / tv cable mount.
sometimes it won't start, run, or run erratically. there are ways of testing this unit (by output voltage) before you commit to buying a new one. to test it you will need a dvom (digital volt ohm meter).

just a note: straight from the book... "a broken or loose tps can cause intermitten burst of fuel from the injector and an unstable idle because the ecm thinks the throttle is moving."

Posted on Sep 22, 2008

psds4
  • 293 Answers

SOURCE: 1998 GMC Jimmy Vortec V6 4.3L 4WD

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800bfc68
hope this helps

Posted on Oct 17, 2008

  • 1 Answer

SOURCE: how do i bypass security on 98 gmc jimmy 4.3

I experienced this problem, intermittant failure to start. This procedure must be done with the truck RUNNING.

Remove the cover off of your ignition switch. On the top there is a small wire connector that, once the truck is running, should be disconnected. This will turn on the 'SECURITY' light. All will be better, except the security light will be on at all times, much cheaper than replacing the ignition switch, however.

Posted on May 10, 2009

  • 126 Answers

SOURCE: 1998 gmc jimmy shifts fine through 3 gears wont shift into overdrive

check transmission fluid .

Posted on Jun 03, 2009

CPU solution
  • 164 Answers

SOURCE: 1998 GMC Jimmy won't start.

could be bad ignition, leak in the fuel line, master coil that powers sparkplugs, sparkplugs, sparkplug wiring, electrical fault there could be a number of things but this is were i would start....a mechanic will help more! i hope this helps

Posted on Jan 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1998 GMC JIMMY WANTS TO STALL OUT AND BACK FIRE WHEN I PRES ACELARAter


bad mass air flow sensor , maybe ! have it checked !

May 26, 2015 | 1998 GMC Jimmy

1 Answer

Knock sensor on 1998 gmc jimmy


it is located beside the crank pully. it controls the timing, a bad one will give you bad fuel mileage and could get a knocking sound when going up step hills. it keeps the engine from knocking by adjusting timing.

Mar 06, 2013 | 1998 GMC Jimmy

1 Answer

Need to repair a flywheel on a 1998 gmc jimmy


Hello, what is wrong with the flywheel??? Your are looking at a major repair here. stewbison
get back to me.

Sep 24, 2011 | GMC Jimmy Cars & Trucks

1 Answer

1997 GMC Jimmy car wont turn over when instument panel warning lights don't come on. After a mechanic replaced my fuel pump. What did he do?


have you tried putting it in neutral and trying it. is your solenoid on the stater clicking, if not i would checkand make sure your nuetral safety switch isnt bad if it is clicking i would make sure the starter isnt hung up in the flywheel or could be a possibility the starter is bad

Aug 07, 2010 | 1997 GMC Jimmy

1 Answer

My 1998 Jimmy ac motor is working but it is blowing hot air out the vents


Check to see if the compressor is coming on if not check the blend door actuator behind the glove compartment. If it is bad it is $59 at autozone

May 20, 2010 | 1998 GMC Jimmy

2 Answers

1998 GMC Jimmy won't start, just cranks.


did you check fuel pressure,check for spark

Jan 09, 2010 | 1998 GMC Jimmy

1 Answer

Turn over but wont crank up


check your E.C.M. fuse, then you could have a bad E.C.M. or coil packs on the vehicle

Oct 26, 2009 | 1998 GMC Jimmy

1 Answer

Fan stopped working in my 1998 gmc jimmy wont blow out any air


Try checking the fuse's, if the fuse's are good it could be a bad blower motor.

Apr 13, 2009 | 1998 GMC Jimmy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...