Question about 1993 Mazda Protege

1 Answer

Gear speeds Have a 1993 Mazda Protege' DX with 5-speed manual. In third gear I am getting a vibration mainly when under load climbing a hill Seems most noticeable around 35 MPH.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

You may have a bearing in the trans that has failed allowing the main shaft to sag

Posted on Jul 20, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Blown main fuse on 2003 mazda protege 5.

There are two bolts on the side of the fuse itself. Under the fuse box on each side. Unbolt those and it will come out.

Posted on Dec 23, 2008

  • 334 Answers

SOURCE: Need confirmation that 5 Speed Transmission out 1993 Mazda Protege SOHC 1.8 liter Will Bolt up to the Same L-4 Block Engine /Mounts in the 1990 Mazda Protege LX 1.8 liter DOHC

try calling a junkyard and see if they will tell you the enterchange ok good luck

Posted on Apr 18, 2009

breddi2
  • 126 Answers

SOURCE: 91 mazda protege, grinding lower gears?

More than likely the synchronizers are going out,they allow you to move from gear to gear without damaging transmission.

Posted on Apr 20, 2009

  • 636 Answers

SOURCE: oscillating vibration around 60-70 mph in 6th gear

sounds like a cv joint to me. That is what usually occurs when one is showing wear. C.V joints usually wear out between 80,000 and 120,000 k.m.

Posted on Oct 14, 2009

the_king1914
  • 7 Answers

SOURCE: i have a 1989 mazda truck 4clyin. 5 speed and the

most of the time that is the clutch causing it to do that. trying going up a hill again in frist and push the gas to the floor if the rpm rev up real high like the truck is in neutral then you need a new clutch. try the engine restore it comes in a sliver can your local auto store will have it. it is about $6 a can. but other than that you might just have to rebuild the motor. hope this helps

Posted on Oct 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to restore power back to normalg


O2 may be bad or damaged causing a false rich reading resulting in a too lean condition.

May 10, 2016 | Mazda Cars & Trucks

3 Answers

Why does my 98 dodge caravan have trouble climbing hills?


A transmission issue would give vibration tremendously during uphill. If you're not getting the vibration, or burning smell of transmission fluid, suspect clogged catalytic converters.

May 09, 2014 | 1998 Dodge Caravan

1 Answer

93 Maxda Protege 5-speed problem


If it is only a 5th gear problem then it is at the rear end of the box and can be associated with a failed rear bearing on the cluster shaft or a chipped tooth on one of the 2 gears involved. This is a larger gear driving a smaller gear and is subject to extra load . This problem was fairly common in the easi-loader vans when the capacity of the van was exceeded (overloaded) and driven considerable distances. The gears them selves in most cases were wearing out. Check the drain plug magnet for metal bits.

Jul 20, 2013 | Mazda Protege Cars & Trucks

1 Answer

Car doesn't kick down gear going up hills


A/T
The modern A/T has 4shift methods.
Foot (passing) called detent TV kick down cable.
the shift lever.
the Vacuum modulator (load, = hills)
and tail shaft RPM (speed)
so seems like the MOD on the A/T is bad.

Apr 06, 2013 | 1992 Geo Storm

1 Answer

I have a 1990 toyota pickup DLX ext cab V6 5-speed


If it seems to run well otherwise, you might have a partially obstructed catalytic convertor. Usually if this is the problem, the engine will also bog down even if you try to rev it up when it is in neutral.

Feb 25, 2010 | 1990 Toyota 4Runner

1 Answer

Starts O.K. Lacks pulling power. Will not rev to full power.


check for a clogged exhaust look at catalytic converter it could be stop up.

May 24, 2009 | 1999 Suzuki Vitara

1 Answer

Clutch or transmission


if your lucky it might be a linkage or control arm between the shifter and the gearbox that has come off or broken climb underneath and see what is going on between shifter and gearbox get someone to move the shifter while you have a look glenn......

Dec 25, 2008 | 1993 Mazda Protege

1 Answer

Running rough


most likelly when your fuel pump gets hot it looses the pressure going to engine replace fuel filter and if this dont help then have the fuel pressure test done when problem is present
and if not good replace fuel pump

Jun 01, 2008 | 1993 Mazda MX-6

Not finding what you are looking for?
1993 Mazda Protege Logo

Related Topics:

153 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...