Question about 2003 Chevrolet Impala

Open Question

How to reset factory amp in 2003 chevy impala

The radio works in my 02 impala but there is no sound i have the factory deck and i was wondering how to reset the amp

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
  • 5 Answers

SOURCE: Radio works (tuner, volume control, cd) but no sound

If your radio looks to be working and no sound, open trunk and mounted underneath the deck lid you will see your amp or sound booster. It should have two plugs that plug into it. Unplug the one with two orange wires and with the car switch turned on, check to see if the two orange wires have power on them. If they don't get ready to take out the rear interior and underneath the rear carpet almost at the front seat you will see a big plastic sleeve full of wires on the passenger side. Inside this sleeve there will be one orange wire branching into two orange wires, check to see if it is corroded. That would be where I start.

Posted on Sep 25, 2011

Ad
  • 4 Answers

SOURCE: radio unlock coed for chevy impala

• A module which communicates on the class 2 serial data circuit which supplies VIN information to the radio is replaced and not properly setup with the correct VIN information for that vehicle. The only way to unlock the radio is by using a scan tool.

Posted on May 15, 2009

  • 314 Answers

SOURCE: serpentine belt diagram for 2003 chevy impala

send an email to chuckie12_87@yahoo.com and I will send the diagram to you

Posted on Jun 23, 2009

edwardjwoods
  • 372 Answers

SOURCE: how do i reset the security system on my 2003

Are you reffering to the alarm or the pass lock system that put the theft light on.....If its the alarm the put the key in the door and unlock it. If its the pass lock system put the key in the ignition and turn it on and try to start the vehicle. After it shuts itself off leave the key on for ten min until the theft light stops flashing the turn key off and try to start it again. This may take a few times....

Posted on Jul 25, 2009

ZJLimited
  • 17970 Answers

SOURCE: radio fuse box 2003 chevy impala

c00f856.jpg

c1f686a.jpg


Also can check other details in the 2003-Chevrolet-Impala-Owners-Manual

Hope this help (remember comment and rated this) TY for using Fixya.

Posted on Apr 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I no longer have the factory radio in my 2004 Impala how do I reset the sensors with a different deck


reset the sensors ??? What sensors ?? What problem are you having ? Car not starting ? Did you use a interface module ? Do you know about vehicle computer data network ? Class 2 serial data ?

Apr 14, 2017 | Cars & Trucks

1 Answer

02 f-150 factory amplifier location


depends on the make of vehicle I would look in the trunk ares as well as the dash area check all of your fuses it may not be an external amp it may be in the radio itself depends on vehicle

Aug 29, 2012 | Cars & Trucks

1 Answer

What's a good after market radio for a 2005 impala


there are 100's of replacement radios for vehicles, what you need to keep in mind is,,, if your factory radio has the vehicle info on the radio screen, its connected to the computer and all that goes along with it, I have an 02 Malibu, and had a new radio installed, But they had to route wiring to the trunk, ( thats where they put the factory radio and wired it in ) so that all my factory functions still worked, I was a little displeased with Chevy for having this attached to a radio, and since the CD player stopped working in the original, I was able to purchase a new radio, amp , and have it and the old one installed , rewired, and it still cost me less than Chevy wanted for a replacement of the old radio, Just due to the CD not working, so be sure and check around when looking for a replacement,

Sep 27, 2011 | 2005 Chevrolet Impala

1 Answer

Factory car radio


thoes cars have a proble with the wireing in the factory sterio deck my sugeston would be to take it out and get an aftermarket sterio wnd put that in there that wil should solve your problem and last alot longer

Mar 09, 2010 | 2004 Chevrolet Impala

9 Answers

Radio works (tuner, volume control, cd) but no sound


If your radio looks to be working and no sound, open trunk and mounted underneath the deck lid you will see your amp or sound booster. It should have two plugs that plug into it. Unplug the one with two orange wires and with the car switch turned on, check to see if the two orange wires have power on them. If they don't get ready to take out the rear interior and underneath the rear carpet almost at the front seat you will see a big plastic sleeve full of wires on the passenger side. Inside this sleeve there will be one orange wire branching into two orange wires, check to see if it is corroded. That would be where I start.

Aug 29, 2009 | 2004 Chevrolet Impala

1 Answer

Tire pressure sensor stuck on


The tire senser can be reset with a skanner that most trie stores should do for free. You deck instaler may have unplugged the passager air bag, shame on them. Your deck man may have caused the other problems too and it may not have the tire moniter without the stock radio.

Aug 11, 2009 | 2003 Chevrolet Impala

1 Answer

Subs on stock radio


chev stock radio does not have extra plug in for sub. to run your sub, im assumed you also going to run an amp to it also. there are no addition plug in in the back, but that does not stop anyone if you know how to rig things. i would not recommend rig wires on your 2007. I would install a new radio before rigging that car; than add a sub. keep in mind most of GM radios come with stock amp built into the radio itself. If you cut the wires from the radio and wire it to your sub amp you will get nothing but distorted sound. anything sound goes to any amp need to be pre-amp in order to work properly. hope that help some

May 16, 2009 | 2007 Chevrolet Impala LS Sedan New Cars

1 Answer

Impala no sound ?


lol, the stock amp? if it blew its best to get an aftermarket one. better than the junky ones the dealer uses.

Apr 17, 2009 | 2005 Chevrolet Impala

3 Answers

03 chev silverado radio on but no sound


My van radio runs on 2 different fuses- both in the fuse box under the dash. One runs the lights the other the sound. Hope this helps.

Jan 11, 2009 | 2003 Chevrolet Silverado 1500

Not finding what you are looking for?
2003 Chevrolet Impala Logo

Related Topics:

1,776 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

79077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...