Question about 2004 Dodge Dakota

1 Answer

Turn signal just replaced the signal module on my truck. the left turn signal wont come on at all and the right one stays on constantly hazzard lights wont come on. had the same problem before but the oem module was burnt

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 88 Answers

Hi, check you flasher switch first. Or earth wire is not connected.

Posted on Jul 20, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

pops296
  • 174 Answers

SOURCE: dodge trailer wiring

Check the owners manual to be sure of the location of the trailer fuses. Most have several locations for the fuses. Other than that, look for a loose or corroded connection. Also check http://www.etrailer.com/faq-wiring.aspx.

Posted on Feb 03, 2010

  • 38 Answers

SOURCE: turn signals won't blink

relay is bad turn signal relay

Posted on Jul 31, 2009

motor1258
  • 6674 Answers

SOURCE: LEFT TRAILER TURN SIGNAL DOES NOT WORK

I'd get a 12vdc test light if you don't have one already & start from plug, and keep probing back from there. It may be as simple as a bad connection under truck where joined into harness.

Posted on Nov 29, 2008

  • 3 Answers

SOURCE: 1997 dodge avenger turn signal probs and location

replace the turn signal switch it self, mine did the same thing with the left turn signal, put in fuse and it will continue to flash... went to junk yard pulled one out of a 97 avenger just like mine, swapped them out and now it works fine. looked to be like some corrosion... to repace: 3 screws under columb, 2 screws on side of signal switch (black plastic side). unplug and replace

Posted on Jun 26, 2009

pops296
  • 174 Answers

SOURCE: LEFT TRAILER TURN SIGNAL DOES NOT WORK

I have seen once before that the fuse box was bad on a 2003 Dodge 3500. I had power in and nothing out. We had to replace the box. Not cheap! Hope it is simple like a loose connection though. I think I had to pull the inner fender on the drivers side to access the bottom of the fuse box. Pain in the ****, but...

Posted on Oct 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No turn signals. hazard lights work only when button is held in. Hazzards will not stay on. Is problem in turn sig switch or hazard light switch


If hazard switch wont stay engaged and the turn signals run through it I would replace hazard switch then retest

Apr 11, 2015 | Cars & Trucks

1 Answer

Jeep turn signals buzz


shorted turn signal lines.
hazzard fails and both left and right,
wiggle the haz switch, a few times, they can get dirty. from non use.
if all are dead, then bad blinker module.
read the manual? its all here
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

Feb 05, 2014 | 1996 Jeep Grand Cherokee

1 Answer

Where can you locate the turn signal flasher unit on a 1992 plymouth acclaim


There are two flasher relays under the dash in the car. One for the hazards and one for the turn signals. They are next to the fuses under the steering wheel right by the hood release

Nov 05, 2012 | Cars & Trucks

1 Answer

Turn signal wont flash, hazzard lights and turn signal just stay on, left side started blinking fast, then went back to normal, now they just stay on.


it may be the flasher unit is faulty & needs to be replaced, you should find it under the dash on the drivers side it could be a square or round unit with a connector plug on it, when you remove the connector plug the unit has three pins on it........hope this helps.......cheers.

Sep 23, 2011 | 2003 Ford Expedition

2 Answers

My 2008 Chevy Cobalt coupe has a passenger side turn signal that flashes fast on the instrument panel. However, no turn bulb is burnt out in either the front or rear. The rear passenger turn blub just...


It is as simple as your hazzard switch needs to be replaced yes your hazzard switch as now turn signals are built threw the hazzard switch my PT Cruiser had same problem as my s10 replaced hazzard switch fixed the problem

Aug 18, 2011 | 2008 Chevrolet Cobalt

1 Answer

Stop and TS problem


there is a flasher
.the hazard is wired to constant power so it works with the ignition off.
the turn signal works off of a switched power,to the turn switch and either the right or left turn signal.
if a bulb burns out,the light stays on steady

Jan 29, 2010 | 1998 Mercury Grand Marquis

2 Answers

Right turn signal is slow and left just stays on 1977 ford F100


wouldn`t hurt to have a look at the flasher unit, hazzard light are adifferent unit .you may even be able to see where it hasbeen getting hot------------ adios-ben

Aug 03, 2009 | 1981 Ford F 150

1 Answer

All 4 signal lights go on(hazzard) when signal light is used left or right


You have a short to power somewhere in the wiring harness. (most likely) Check your wiring for chafed wires that are touching.

May 27, 2009 | 1995 Mercury Sable

1 Answer

Clicking noise from the blinker wont turn off!


There are 2 common things that cause this.
1. the hazzard flasher is faulty. the hazzard button and the turn signal flasher are all in one. Sometimes pushing the hazzard button in slightly will get the noise to happen, and is an indication it is faulty.
2. The turn signal switch in the steering column is bad. Turning the turn signal from left to right- very fast and harshly, will sometimes clear it up for awhile.
Tech JK
--------------

Jan 21, 2009 | 2004 Pontiac Grand Am

Not finding what you are looking for?
2004 Dodge Dakota Logo

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...