Question about Cars & Trucks

Open Question

How To Install a new power input board 28667-G01 in a older Battery Charger for a E-Z-GO Golf Cart It has a black wire it go to the dc cord but on this charger it done has a wire going to dc cord. what do i do with the black wire. You can Email me at carollalangley@windstream.netThank you: Carrlll

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 1982 e-z go electric golf cart needteck sheet.

I have a 96 EZ GO gas golf cart with loose steering. What parts are normally needed to correct this problem and are special tools required for me to replace the parts.
Thanks,
Bob

Posted on Jan 22, 2009

Ad
  • 82 Answers

SOURCE: I have 2004 EZgo electric golf cart. When I plug

Check for a tripped circuit breaker. usally at inline with the positive cale of the battery

Posted on Mar 25, 2010

  • 34 Answers

SOURCE: Rear axle fluid for 1983 ez go electric golf cart?

Regular 90 weight gear oil. Fill until it reaches the fill hole.

Hank, The cart man

Posted on Apr 22, 2010

  • 34 Answers

SOURCE: 1999 ezgo golf cart.need to know the whole wireing

When you removed the batteries, a certain procedure MUST be followed. Key switch off, switch to tow position and shift lever in reverse. You must wait until the beeper unit sound dies out then remove the wire from the most NEGATIVE cable. Place in Neutral before installing new batteries. There is a specific sequence to putting the batteries in an EZ-GO cart. Failure to follow this procedure will kill the controller. The Key switch must be off and the maintenance/tow switch MUST be in the tow position when connecting the batteries. Any of the above will cause the controller to fail, due to improper discharge of the PRE-Charge capacitors.

Posted on Apr 22, 2010

  • 34 Answers

SOURCE: EZGO golf cart won't go forward

Your batteries have died. The reason it will barely move in reverse is that current is being supplied to the motor is a direction that it spends very little time using. There is a slight change in the armature over time, and reverse tends to work better over time. Check the voltage when under load. (run jumper wires from the + and - of the battery bank. If it is a 36 volt cart and the voltage drops to below 36 volts, you do not have enoug current to run the cart. Plug in the charger and watch the ampmeter. If it goes up to about 20 amps, then it is charging. It should take a good charge after 10 hours. If the cart charges and only runs a short distance, the batteries need replacing.

Posted on Apr 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need help putting new batteries in 1980 club car can't figure out how to connect wiring to new batteries


https://www.golfcarcatalog.com/golf-cart-blog/golf-cart-battery-bank-wiring-in-series/
This should solve your problem.
Next time you want to take something apart, be sure to take a picture or 2, before you disconnect anything. That will help you put it back like it was.

Jun 16, 2017 | Cars & Trucks

1 Answer

Where would I find charger for org. Battery in LIL DRIVER 902?


read on the side of the battery the rating for it (voltage -amperage-and any other details and take them to an electronic shop like Jaycar and find the charger for the batteries. Or have the details on hand and go to E-bay and find a charger that matches what you have.

Aug 16, 2014 | Cars & Trucks

1 Answer

Golf cart wiring


Its been a wile but if I remember right it goes from the solenoid under the cart (pass side) to the key switch (the other wire is probably volt meter) then micro switch,green wires from micro switch to controllern. Inspect all spade connections

Jan 30, 2013 | Cars & Trucks

1 Answer

Golf Cart (Gas Powered) Stereo Installation


What I did was to buy a good blue tooth speaker and connect to my cell phone. 3 hrs on the golf course and 10% of the cell battery

Jul 06, 2017 | Cars & Trucks

2 Answers

EZGO golf cart won't go forward


Your batteries have died. The reason it will barely move in reverse is that current is being supplied to the motor is a direction that it spends very little time using. There is a slight change in the armature over time, and reverse tends to work better over time. Check the voltage when under load. (run jumper wires from the + and - of the battery bank. If it is a 36 volt cart and the voltage drops to below 36 volts, you do not have enoug current to run the cart. Plug in the charger and watch the ampmeter. If it goes up to about 20 amps, then it is charging. It should take a good charge after 10 hours. If the cart charges and only runs a short distance, the batteries need replacing.

Apr 09, 2010 | 1993 Acura Vigor

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...