Question about 2000 Pontiac Bonneville

Open Question

Front seat belt buckle for 2000 pontiac bonneville

Seat belts will not buckle because there is a piece sticking down inside if the male buckle. how do I fix this?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

autodr
  • 260 Answers

SOURCE: serpentine belt diagram for a 1996 pontiac bonneville?

42ff945.gifhope this is what youre looking for

Posted on Dec 02, 2008

johnny5846
  • 379 Answers

SOURCE: 1999 Pontiac Bonneville serpentine belt installation.

if you look by the crankshaft pulley to the right you will see a tubular looking shaft about 1" diameter , you will notice you can't get the belt out from under this piece , it has a nut on it , once you take the nut off , you will notice it has a star shaped point on the tip of the stud , it requires a reverse torx socket or wrench to remove the stud , when you get the stud out the tube piece it can be removed , then the belt comes off , replace the belt , now comes the tricky part , fitting that tube spacer back into its spot , it can be difficult , once its in place put the stud back in , and put the nut on and tighten it , your pretty much a pro now . thanks.

Posted on Dec 30, 2008

ewashmidas
  • 362 Answers

SOURCE: 1999 pontiac bonneville ssei supercharged belt routing diagram

This is the one for the supercharger.

b0520da.png

Posted on Mar 14, 2009

greg_margo
  • 1959 Answers

SOURCE: Serpentine Belt diagram for 2001 pontiac

Below is the diagram you requested. Please return to rate this solution. Thank you very much.
74f4847.jpg

Posted on Sep 04, 2009

Testimonial: "Thank you. You helped alot. Took off the belt not knowig their was not a diagram label on the car somewhere or in manual. Thanks again. J. Seats"

ZJLimited
  • 17970 Answers

SOURCE: need a serpentine belt diagram for a 1999 Pontiac Bonneville

1999 Pontiac Bonneville V-6 3.8L

861b5c7.jpg

From Gates.com / Part Locator

I hope help you with this. Good luck.

Posted on Oct 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where are the fuses located for the air conditioner in a 2001 pontiac bonneville


The interior fuse box in a Pontiac Bonneville is underneath the backseat on the driver's side.

To remove the rear seat cushion:
1. Pull up on the front of the cushion to release the
front hooks.
2. Pull the cushion up and out toward the front of
the vehicle.

To reinstall the rear seat cushion:

1. Buckle the center passenger position safety belt, then
route the safety belts through the proper slots in the
seat cushion. Don't let the safety belts get twisted.
2. Slide the rear of the cushion up and under the
seatback so the rear - locating guides hook into the
wire loops on the back frame.
3. With the seat cushion lowered, push rearward and
then press down on the seat cushion until the spring
locks on both ends engage.
4. Check to make sure the safety belts are properly
routed and that no portion of any safety belt is
trapped under the seat. Also make sure the seat
cushion is secured.

Notice:
The battery and main fuse blocks are located
under the rear seat cushion. The battery's ground
terminal and some relay wires are exposed.
To help avoid damage to the battery and wires,
be careful when removing or reinstalling the seat
cushion. Do not remove covers from covered
parts. Do not store anything under the seat, as
objects could touch exposed wires and cause
a short.

Jul 22, 2014 | 2001 Pontiac Bonneville

1 Answer

Broken seat belt buckle


If I had the problem I would look at a junkyard or on line at e-bay for a replacement. You will need to get the buckle and the belt that it is attached to that goes down to the floor down through the crack in the seat.
Remember the buckle receiver is made for the certain belt in the front and rear seats. I have often tried to put the wrong belt in a buckle and it would not fit. ( Example: the right belt goes in the right buckle.)
Be blessed.

Nov 08, 2013 | 2002 Nissan Xterra

1 Answer

1995 Pontiac bonneville sea t belt chime won't turn off


sounds like a bad wire or sensor in one of the seats or connections. Check grounds and broken wires. Check inside connectors for blockage of some type.

Jan 27, 2013 | 1995 Pontiac Bonneville

1 Answer

I have a 2007 G6 and the seat belt light keeps coming on even when I have my seat belt buckled and it continues to show that its not buckled and starts beeping


check at the base of the buckle where it meets the floor and check the electrical connector there is a switch inside the buckle also check to see if the wire has rubbed against the track

Apr 13, 2012 | 2007 Pontiac G6 GT Convertible

1 Answer

Seatbelt on passenger side want work


sounds like you have a buckle failure....this is the removal procedure...


  1. Remove the front seat.

110881806


  1. Disconnect the front safety belt buckle electrical connector.

110881807


  1. Remove the front safety belt buckle.
NOTE: The front safety belt buckle retaining bolt is part of the safety belt buckle and should not be separated.
Installation


110881808


  1. To install, reverse the removal procedure

Aug 11, 2011 | 1989 Jaguar XJ6

1 Answer

The seat belt won't buckle unless you press down the red release tab first .


the red release tab is sticking on the buckle take it to toyota to fix i believe it was a recall in 2000

Feb 12, 2010 | 2000 Toyota Camry Solara

1 Answer

Front passenger door lock wont work, seat belt light on


Sounds like the plastic clip that connects the lock has broken however regardless of fault the inner door panel has to be removed to diagnose and repair.It could also be inner door lock assembly.

Dec 28, 2008 | 1989 Pontiac Bonneville

Not finding what you are looking for?
2000 Pontiac Bonneville Logo

Related Topics:

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...