Question about Cars & Trucks

1 Answer

When I press in the break I heard noise - Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

It could be you need new pads

Posted on Jul 19, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Whinning noise heard from inside car on idle and acceleration


Might be a bearing in one of the accessories, such as the alternator or power steering pump. Try to isolate to a specific location, especially as it gets worse.

Aug 14, 2017 | Cars & Trucks

1 Answer

2005 kia optima...was driving at 70 mph when i heard a whirring noise of sorts then died. tried starting it up again and all i hear is one clicking noise. smells strong of coolant, but not leaking any...


Have you changed the timing belt? It is supposed to be replaced every 65,000 miles. That would be the first thing to check. IT will cost about 500 USD to have a dealer change it if there is no damage from it breaking. When they break, the pistons can hit the valves and cause lots of damage.

Jan 25, 2014 | Cars & Trucks

1 Answer

98 vw Jetta GL 2.0 5 spd manual. Grinding noise/crackling coming from front left wheel side. Both at start up but when the car is driving does it as well. Video is of me on the highway I heard break p


hi there is the timing belt covers on the same side as the noise ??? i just wondered as i have heard that sound a few times and it has always been the cover for the timing belt or ift could be a timing chain?? hope this helps

Jan 20, 2013 | Cars & Trucks

2 Answers

My ford explorer starts fine but will not shift out of park


sounds like your shift interlock has malfuctioned....press the brake and listen for a clicking noise at the base of the shifter if no click is heard...its solenoid has failed...if it does click...try taping breaks several times while trying to shift it out of park...

Apr 21, 2011 | 2004 Ford Explorer

2 Answers

Passenger rear wheel bearng needs to be replaced.does this require special tools? I've just had a complete brake job ,new pads new rotors new drums and I have a recurring grinding noise coming from the...


You can do this job your self with common tools. Auto zone carries the wheel bearing you need and can give you the step by step instructions to replacing the bearing. Here is a tip, to try to break the old wheel bearing from the axle. Just loosen the 4 bolts 3 mm that hold the bearing to the axle and put the wheel back on and drive the car back and forth a few times, hard on the brakes to break it free from the axle. Once the bearing breaks free from the axle, it should take you under 45 min to get the job done. Good luck and be safe.

Nov 17, 2009 | 2001 Toyota Corolla

1 Answer

My car wont start, fuel pump problem?


fast high pitched noise? never seen or heard of this, done 100's of belts, this noise is caused by a belt being adjusted to tight, belts just break. do you have fuel pressure, what engine do u have?

Sep 28, 2009 | 1997 Chrysler Sebring

1 Answer

Engine dies while driving.


the noise you heard in the rear was the electric fuel pump working but it sounds like you have an electrical issue check your wire harness for areas that wires chaffed on metal and cause break in the electric current some known areas are inbetween the radiator and the transmission down towards the tranny pan also check fuse panel might have a loose fuse

Jul 02, 2009 | 2001 Dodge Neon

1 Answer

Cracking or breaking sound when turning mainly when parking


I doubt it. I heard the same noise from my old Accord when the CV boot was going out. If you heard breaking from the drive shaft I believe the next thing you'd see is it rolling down the street. If the drive shaft were making that sound you would not be able to continue driving.

Aug 28, 2008 | 2003 Toyota Corolla

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...