Question about Toyota Tacoma

Open Question

Fuel gauge problems

Fuel gage and speed rpm not working

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

husni_g2002
  • 112 Answers

SOURCE: Gauges will not work 2004 aztec same problem with 2002 aztec

Switch ig. on, ground the sender unit wire for about 3 seconds see if the temp. gauge moves, if so change sender unit, if not then it is a faulty gauge reader.
also check instrument voltage stabilizer.

Posted on Jan 20, 2009

  • 1596 Answers

SOURCE: speed,rpm,gas,odometer gauges not working

Sounds like a body control module. It is located on top of the glove box. Unfortunately, the miles are stored in this module, so you have to go to a dealer to have it programmed.

Posted on Jan 24, 2009

  • 58 Answers

SOURCE: 2004 ford focus

you need to check your fuses

sounds like a popped fuse to the cluster

if that don't work dis-connect the battery for a sec

good luck

Posted on Jan 27, 2009

  • 1 Answer

SOURCE: speedometer, gas gauge, odometer, rpm gauge not working

My gas guage, speed odometer and tempiture does not work
The speed odometre is reading 9999999 what should i do

Posted on Oct 21, 2009

  • 5 Answers

SOURCE: Electrical Problem with speed gauge, RPM and dash board lignts.

That is a manufacturing defect associated with your instrument cluster. My local dealer replaced my entire instrument cluster for free (truck was out of warranty) when my speedometer showed 100 mph in a parking lot and my oil pressure gauge read 0.

Posted on Jan 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuel gage not working


Fuel gauge problems are commonly the result of faulty electrical grounding at the tank or a problem with the sending unit inside the tank but can also be caused by faulty wiring or a bad fuse.

What causes fuel gauge problems? ' Reference.com

https://www.reference.com/vehicles/causes-fuel-gauge-problems-ac4e6a2ffe8399a9 Fuel gage not working Google Search

Dec 10, 2016 | Cars & Trucks

1 Answer

My 2000 Chevy s15 Rpm and Gas Gauge is not working


I didn't see an s15 in that model year, in my database?
If the speedometer works but the tach doesn't, I think something is wrong with instrument cluster?
GM has had a problem with fuel gage sending units. The sending units are not hard wired to instrument cluster, they send signal to pcm, the pcm sends serial data to instrument cluster, telling the cluster the gage settings.
It may be possible to use different size resistors in place of the fuel level sending unit, to see if fuel gage reacts properly to different resistors, if the gage reacts properly, then I think the problem is the fuel gage sending unit.

Nov 02, 2016 | Chevrolet Cars & Trucks

1 Answer

My mph, gas, and temp gauges are not working


That's why you don't let you husband work on your car ! Unless he does it for a living .. For MPH there is a VSS - vehicle speed sensor , for the gas there is a sending unit in the fuel tank, for the temp. gauge there is a temp. sensor located in coolant stream on the engine .You more then likely need to have you instrument cluster repaired . GM had a problem with step motors inside the instrument cluster . A step motor is what controls the individual gauge. The sensors are all inputs to the PCM - powertrain control module (engine computer ) .
Engine Coolant Temperature Gage
The IPC displays the engine coolant temperature as determined by the PCM. The IPC receives a class 2 message from the PCM indicating the engine coolant temperature. The engine coolant temperature gage defaults to C or below if:
?€¢
The PCM detects a malfunction in the engine coolant temperature sensor circuit.


?€¢
The IPC detects a loss of class 2 communications with the PCM.

Fuel Gage
The IPC displays the fuel level as determined by the PCM. The IPC receives a class 2 message from the PCM indicating the fuel level percent. The fuel gage defaults to empty if:
?€¢
The PCM detects a malfunction in the fuel level sensor circuit.


?€¢
The IPC detects a loss of class 2 communications with the PCM.

When the fuel level is less than 14% (84ohms), the low fuel indicator illuminates.
Odometer
The IPC contains a season odometer and a trip odometer. Momentarily press the trip select/reset switch in order to toggle between the season odometer and the trip odometer. Press the trip select/reset switch for greater than 1.5 seconds, while the trip odometer is displayed, in order to reset the trip odometer. The IPC displays the vehicle mileage and trip mileage as determined by the IPC. The IPC calculates the mileage based on the vehicle speed information from the PCM. The odometer will display 'error' if an internal IPC memory failure is detected.
PRNDL Display
The IPC displays the selected gear position as determined by the PCM. The IPC receives a class 2 message from the PCM indicating the gear position. The PRNDL display shall flash all gear positions if:
?€¢
The PCM detects a malfunction in the transmission range switch circuit.


?€¢
The IPC detects a loss of class 2 communications with the PCM.

Speedometer
The IPC displays the vehicle speed based on the information from the PCM. The PCM converts the data from the vehicle speed sensor to a 4000 pulses per mile signal. The IPC uses the vehicle speed signal circuit from the PCM in order to calculate the vehicle speed. The speedometer defaults to 0 mph (0 kph) if a malfunction in the vehicle speed sensor circuit exists.
Tachometer
The IPC displays the engine speed as determined by the PCM. The IPC receives a class 2 message from the PCM indicating the engine speed. The tachometer will default to 0 rpm if:
?€¢
The PCM detects a malfunction in the engine speed sensor circuit.


?€¢
The IPC detects a loss of class 2 communications with the PCM.

May 22, 2016 | 2002 Buick Century

1 Answer

When I go to crank 2000 jeep Cherokee limited the fuel gage works sometimes and it will only run for about three seconds what's wrong?


The computer grounds the fuel pump relay for 3 seconds to boost fuel pressure on start-up. If the computer does not see oil pressure or RPM it will not continue to ground the relay.
You would need to bypass the relay and see if the pump continues to run, then check the relay and the ground signal from the computer.
The gas gauge problem may be connected or something different.
The connector at the gas tank may be faulty which would affect both the power for the pump and the fuel gauge sending unit.

Sep 21, 2012 | 2000 Jeep Cherokee

1 Answer

My rpm gage is not working, my speedometer is not working, my gas gage is not working, and my oil gage is not working, and my temperature gage is not working pretty much when i start up my car and drive it...


I'd wager that the fuse that controls the gauges is shot, or one of the internal connectors got unplugged (Fuse sounds more likely). Radio, Lights, and Turn Lamps are usually on seperate circuits.

Dec 28, 2010 | Ford Explorer Cars & Trucks

1 Answer

For the past year, my gas gage needle has not moved off of 3/4 full. Just lately the RPM gage has stopped working on my 2004 Buick LeSabre. How do I get them repaired or replaced?


the 2 problems are not related, the gas gauge problem is caused by a defective gas tank fuel level sending unit, here is the part number for that.
ACDELCO Part # SK1030 {replaces 25326326 #25326326, 88963639}
SENSOR KIT,FUEL LEVEL SINGLE PRONG LOCKING FEATURE W/O LOOSE CPA CLIP $144.00

AS FAR AS THE TACH GOES YOU WILL NEED TO PULL IT OUT AND HAVE IT REPAIRED BY A DELCO ELECTRONICS AUTHORIZED REPAIR CENTER.

Oct 27, 2009 | 2004 Buick LeSabre

3 Answers

Speedometer, gas gauge, odometer, rpm gauge not working


My gas guage, speed odometer and tempiture does not work
The speed odometre is reading 9999999 what should i do

Jul 29, 2009 | 1998 Nissan Frontier

1 Answer

My RPM gage on my mustang saleen isn t working


the tach uses the same fuse as the other gauges, so if the other gauges have no problem then the tach is defective, Ford does not really repair these we just replace them.

May 28, 2009 | 2005 Ford Mustang

1 Answer

Electronic power steering


It could be the electronic power steeirng module . With the gauges dropping out like that , the module could be bring down the data bus . Don't know how much you know about automotive electronic's an how the insturment cluster know's what speed to set speedo at an how full fuel gauge is an rpm on the tach .
Speedometer
The instrument panel cluster (IPC) displays the vehicle speed based on the information from the engine control module (ECM)/powertrain control module (PCM). The ECM/PCM calculates the vehicle speed based on the class 2 message indicating the wheel reference speed from the electronic brake control module (EBCM) if:
• The ECM/PCM detects a malfunction in the vehicle speed sensor circuit.
• The IPC detects a loss of class 2 communications with the ECM/PCM.
The speedometer defaults to 0 km/h (0 mph) if the IPC detects a loss of class 2 communications with both the ECM/PCM.

012 GM Class II Communications

Checking the vehicle modules for DTC'S - diagnostic trouble codes is the first place to start .
The Power Steering Control Module (PSCM) receives a class 2 vehicle speed message from the Engine Control Module (ECM) via a class 2 serial data circuit. The PSCM uses this vehicle speed message, and other inputs, to determine the desired amount of steering assist.
DTC C0000
DTC C0475
DTC C0476
DTC C0545
DTC C0847
DTC C0848
DTC C0896
DTC C0899
DTC C0900

your best bet ,take it to a qualified GM repair shop .

Jul 12, 2017 | 2004 Saturn ION

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...