Question about Cars & Trucks

Open Question

Mazda bongo spare wheel removing

How to remove spare wheel from beneath car

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
TLRogue
  • 99 Answers

SOURCE: REMOVING THE SPARE WHEEL ON A RENAULT MEGAN

The spare wheel is located under the rear boot carpet.BUT some meganes do not come with a spare as its an optional extra when the car is purchased. If there is no spare, then a can of foam and a small compressor to repair and inflate the punctured tyre, should be fitted.

TL

Posted on Jan 24, 2009

Ad
  • 1 Answer

SOURCE: fuel starvation mazda bongo

Bongo 2.5 Tdi. WL-T.
Everything fine untill 20 minutes after fueling up the engine started to run rough when stopped(at idle). I shut down. Couldn't restart. Next morning started up and ran fine. later on, wouldn't start easily and when it did couldn't rev above 800rpm. another time started but no power.
Seems like fuel starvation. I just bought the van and have sent away for workbook, fuel filter, glow plugs etc. Where is the fuel filter located? I see where the fuel line goes in to the FCU (or flow devider) is this where i should check presssure. I know a little about petrol engines but nothing about TDI. Any help would be greatly appreciated!
Thanks,
Rowan

Posted on Apr 29, 2009

hdsoft
  • 80 Answers

SOURCE: headlight

Well according to my mitchell manuel you don't have to.here is the procedure.
1. open the hood.
2.Remove the push-pin retainer's that secure the top of the upper facia and grill assembly to the upper tie bar to allow the upper facia and grill assembly to flex forward.
3. remove ther bolt and push-pin retainer that secures the top of the headlight assembly to the upper tie bar.
4. Gently pull the upper facia and grill assembly forward to access the bolt on the inboard side of the headlight assembly
5. Pull the headlamp assembly straight out to disengage the the snap in retainer at the lower outboard back surface of the assembly. Turn the assembly so that the inboard assembly clears the front facia.
6. pull the assembly out and away from the veh.From there you'll be able to access bulbs.
be careful not to touch the bulb with fingers or oil in skin will blow bulb.
Good luck.

Posted on Aug 19, 2009

  • 1 Answer

SOURCE: hi in need of a wiring diagram fuse box Mazda bongo

look here: http://www.bongoforum.co.uk/forum/Blah.pl?

Posted on Dec 06, 2009

  • 27 Answers

SOURCE: mazda bongo manual

there is a bongo owners site, try them

Posted on Feb 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove a spare wheel on a bongo van


where is it located . we do not have that model in the US

Nov 21, 2015 | Cars & Trucks

1 Answer

Is 1.8lt mazda bongo efi sohc 1789cc motor a free runner if timing belt breaks


Most cars are free-runners if the timing belt/gear breaks, except if the vehicle has automatic transmission. Auto transmission vehicles should have the drive wheels lifted during towing. NB! Only transport a "permanent" four wheel drive vehicle on a flat bed vehicle carrier.

Jul 25, 2014 | 2005 Mazda B 3000

1 Answer

I have a Mazda Bongo Brawny Van 2007 model, I have just changed the oil, it was pulling nicely but it has just started not pulling, I do not what to do, please help.


drain ? what is the meaning pull?drn oil to remove the drain plug & change oil filter as well,fiil oil & check oil level by dip stick

Jan 27, 2014 | 1996 Mazda Pickup

1 Answer

Change glow plug relay mazda bongo


Follow the glow plug wires to a common box where all the glow plug wires congregate. This should be the timer.

Oct 16, 2013 | Cars & Trucks

1 Answer

Is there any problem arise after running a mazda bongo v6 petrol engine when the cooling fans are running condinously in hot african countries.


The cooling fan motor is bad,replace,it's by the fan,remove electrical connector,then remove part.

Aug 17, 2013 | Cars & Trucks

1 Answer

How do I remove rear bumper?


Hi i believe you remove the rear bumper by taking out the spare wheel and removing the rubber bungs exposing the bolts that are hidden beneath

Mar 30, 2011 | 2000 Subaru Outback

1 Answer

I need an english version of Mazda Bongo 2007 diesel van user guide


i need an english version of the mazda bongo 2007 user manual,,, the user guide,,

Jan 02, 2011 | Mazda B-Series Cars & Trucks

1 Answer

Mazda bongo manual


there is a bongo owners site, try them

Feb 07, 2010 | 1994 Mazda MPV

2 Answers

Hi in need of a wiring diagram fuse box Mazda bongo


look here: http://www.bongoforum.co.uk/forum/Blah.pl?

Apr 07, 2009 | 1997 Mazda MPV

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

532 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...