Question about 1991 Ford F150

1 Answer

Wont restart after engine warms up

When shut of and hot it wont start till 5 mins

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 133 Answers

Maybe you should use obd2 scanner to check engine system first.

Posted on Jul 19, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Restating 2000 odyssey after warmed up


not sure what that means.
lets start over.
your saying car runs great, cold then hot.
then hard to restart a hot engine, right?
the light thing i dont understand
first off, when you stall and engine or just key ON.
the lamps all self test (read the operators guide there)
this is only a lamp test.
odd, the most important is skipped the CEL, check engine light.
is the engine stalling?
hot restarts, fails are: many.
  1. injector leaking at shut down.
  2. ECT reads to cold when hot. can be below caused
  3. Engine thermostat stuck open and restarts are over rich and floods. that hot engine must be at 180F or more,
  4. never did a 60,000 mile tuneup this decade?
  5. Fuel pressure too high.
i do tune ups first.
then check coolant temperatures, hot. 180F min, and holding or i kick the thermostat to the curb (new stat time)
if it sill dont want to hot start
out comes the scan tool
i scan it, got DTC errors.
is ECT reading 180F ? or above?

that is start on diagnosis.

Feb 25, 2014 | 2000 Honda Odyssey

1 Answer

2000 suzuki vitara runs 15 min stalls wont start till cools down


Did they figure out if you are loosing fuel or spark when it fails to start up ? You would need to know which to proceed.

Feb 13, 2014 | Suzuki Grand Vitara Cars & Trucks

1 Answer

How do I adjust my Holley 4 barrel on a 4.3 liter chevy engine. Starts and runs fine till it warms up then dies and won't start for 30 min.


sounds like your coil is getting hot then when it cools down the engine re starts check coil look for hot spot or touch it see if it is hot it should be cold.

Nov 20, 2013 | Cars & Trucks

1 Answer

Quits after warm up wont restart


sounds like you have a fuel pump problem, fuel pumps will usually get hot and then shut off allowing it to sit 30 mins lets the pump cool down allowing it to start pumping, the way you can test it is get a can of starting fluid the next time it quits raise your hood and spray some fluid down into the throttle body and if it starts and then dies it is most likely your fuel pump, hope this helps.

Feb 02, 2013 | 1999 Dodge Dakota

1 Answer

HOW TO BLEED THE RADIATOR ON A FORD TAURUS 2002


Warm the car up till the cooling fan comes on then about another 3 to 5 min. shut the engine off for about 10 min. keep repeating till the coolant flows. The upper radiator hose will get hot close to the radiator and the air from the fans is hot. Leave the radiator cap loose or off while doing this and keep the antifreeze full. Be very carefull antifreeze can go up to 230 degrees and servely burnt If you are getting air bubbles and the antifreez doesn't go down you have combustion getting into the cooling system. The most common reason for this is a blown head gasket.

Nov 28, 2010 | 2002 Ford Taurus

3 Answers

2000 vw cabrio runs normal and shuts down, takes 5 to 20 minutes to restart, engine cranks but doesnt start, changed ignition coil, pulled diagnostic codes getting short to ground codes on cylinder...


On some models, the Engine Control unit has a power supply relay. These relays some times get internal dry solder points. After driving for some time the the solder will get hot and separate. When it cools down it makes contact again. You will have to replace this relay or open it up and re- solder the solder joints. The relay is usually located on the main relay station in position 3. the relay station is located behind the right dash panel.[right hand drive vehicles]. You may need to refer to a manual for your specific model to find the exact location of the relay.

Jun 04, 2010 | 2000 Volkswagen Cabrio

1 Answer

2000 silvarado 5.3 vortech runs good for awhile after it gets hot it shuts off and wont crank until it cools off


do you mean wont crank over and start till it cools off? if thats the case it sounds like you got a bad crankshaft position sensor,,thge sensor is fine when its cold and warm but when it gets hot it goes open and the cars computer cant see the rpm and shuts the engine off,and then when it cools off the sensor works again and the car starts and is ok till it gets hot again,if thats the case thats what it is,,,hope this helps,,,about $100 for the part

Oct 07, 2009 | 1985 Chevrolet Chevy

2 Answers

Volvo 245 engine shuts down when warm.


done the same in my volvo it was disrubitor but make certain that replacement one the same part number.

Jun 26, 2008 | 1982 Volvo 240 Series

Not finding what you are looking for?
1991 Ford F150 Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...