Question about 2008 Chrysler Pt Cruiser

1 Answer

2008 PT Cruiser Wiring schematic for Power seat

Red wire disconnected (snapped) from pin under the Drivers' seat. need to know where the RED wire goes. Any FREE schematics would be nice

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chrysler Master
  • 21,873 Answers

There's a red and lite green wire going to the seat motor, and a red and dark green going to the seat heater.
Do you know where the wire popped off at ? Or what no longer works ? It could be something with the seat belt sensor or the air bag sensor too.

Posted on Jul 19, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Bubbabear64
  • 2794 Answers

SOURCE: pt cruiser aerial

At the base of the antenna, take a small crescent wrench or pliers and unscrew the antenna from the mounting bracket. Any Chrysler dealer should have a replacement antenna.

Posted on Oct 06, 2008

JShreader
  • 50 Answers

SOURCE: NEED WIRING DIAGRAM FOR 2002 PT CRUSIER STARTER

Hello chk614, my name is JShreader. Thank you for choosing fixya.com.

Here is a picture showing the Wires connecting to the Starter...
42ff1ef.jpg
If you are looking for the formal Wiring Diagram...see below...
8f3c163.jpg
I hope this helps you. If you have any more questions or need any more diagrams, please don't hesitate to ask...Thanks again, JShreader!

Posted on Apr 01, 2009

  • 7353 Answers

SOURCE: I need a schematic diagram for the radiator fan on

I dont have a diagram, but these have 2 speeds and they are a common problem. the fan will need to be replaced (complete unit)

Posted on Oct 03, 2009

egstriker23
  • 44 Answers

SOURCE: pt cruiser seat adjuster problems

You might have a problem with the wiring under the seat. The best thing to do is to reach under the seat and move some of the wires away from the track that the seat moves along. Most likely there is a short to ground because the wires are rubbing against the seat track as it is moved back and forth. You need to grab a flashlight and look under the seat for wires touching the seat tracks. When you find them, you can most likely use some electrical tape to wrap the exposed wires and keep those wires from touching each other and that area from touching the seat track. Make sure you route the wires away from the seat track tight enough to the seat's underside, but loose enough to allow the wires to move with the seat as it travels the full length of its track. The fuse for the seat has probably blown so you would need to replace the power seat fuse AFTER you wrap and reroute the wires to prevent blowing the new fuse.

Hope this helps!

Posted on Sep 07, 2010

  • 1 Answer

SOURCE: need a wiring diagram for

i have wiring digrams for 2001 PT Cruiser from Mitchell On Demand. Just need to know which specific part needed diagram for.
for example here is charging system for 2001 PT Cruiser
61384d5.jpg

Posted on Oct 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need horn wiring diagram for 2006 pt cruiser


http://www.bbbind.com/free_tsb.html Ok here is a wiring diagram for the horn circuit on your 06 PT Cruiser . Enter your vehicle info year , make , model and engine size . Under system click on interior & driver Amenity . Under subsystem click horn . You will see

1 diagrams found. with a search button under it , click search . Click on the blue link and then your horn diagram will pop up . It's probably nothing your going to understand . Do you have a air bag light lit on the instrument cluster ? Do you know anything about computer controlled systems on automobiles ? C.A.N - controller area network ? You should read this before you mess with any wiring How to Diagnose Controller Area Network CAN Also google chrysler TIPM - totally intergated power modul problems .

Feb 13, 2017 | 2006 Chrysler PT Cruiser

1 Answer

2006 pt cruiser with code P0882. car seems to be running in 2nd gear all the time and won't shift to high gear.


the answer from atp1962 was complete and correct. The TCM is not getting any or the correct voltage to operate correctly. The electric connections between/as well electronic components need to be checked out.

Sep 24, 2014 | 2006 Chrysler PT Cruiser

1 Answer

Wher can i get a wiring diagram of starter circuit on a 2003 pt cruiser?


At a local repair shop --off their data base

Free --from auto zone site, so i here,don't know
how that works

Jul 17, 2014 | 2003 Chrysler PT Cruiser

2 Answers

I have a 2003 pt cruiser the air bag light stays on , code for open driver's door retractor, clean connector and check wires, light went out till next start up the light came back on , removed con


The seat belt switch cannot be adjusted or repaired and, if ineffective or damaged, the entire front seat belt and retractor (drivers side) must be replaced.
For more details on this issue,click the link below:-----
http://technoanswers.blogspot.in/2012/06/pt-cruiser-seat-belt-and-retractor.html

-------
This will help.
Thanks.

Jun 25, 2012 | Cars & Trucks

1 Answer

Need to install remote starter and need wiring diagram for 2007 PT Cruiser


Hi drgghenso. Here is the starting system wiring schematic for a 2007 PT cruiser. Good luck with your installation!


pawdaddy_24.jpg

Sep 28, 2011 | 2007 Chrysler PT Cruiser Touring Hatchback

1 Answer

2002 pt cruiser. Just replace the battery a week ago and the cables, the car runs fine with the battery disconnected so it cant be the alternator. when you put the key in and turn it on without starting...


jonboy;
I had the same problem. Check the wire in the terminal on the starter. That terminal is not crimped well enough around the wire.
It is pretty hard to get to, but removing the air cleaner and battery helps. When the PT won't start, have someone get ready to turn the ignition switch to start, reach down the left side of the battery (facing it) And give those 2 red wires (about the size of a lead pencil) hard yank just after your helper turns to start. You'll pull them out of a snap in wire holder, (which you can put back later when it is repaired). This should put the wire to the starter in a bind thus letting it start. You may see some sparks as the contact is made, or if loose enough, pull the wire out of the terminal. If this happens, you found the problem. Hope this solves your problem.
mikeselectric

Sep 23, 2011 | 2002 Chrysler PT Cruiser

3 Answers

2001 PT Cruiser Limited Ed. Airbag light keeps coming on and off and chimes every time it does. Is there any way to turn it off for now, its driving me bonkers?


There may be some reasons of coming the airbag light on your PT Cruiser. Some connectors could be loose under seats or sensor of steering wheel could fail. However it is really rear. Your problem is probably caused by common problem in PT Cruisers - by broken wire on driver's seat.
Before you start doing anything disconnect a car battery. After 15 minutes remove a plastic panel from the seat (the one you can see when you open your door). Than you will see a wire in plastic cover. It connects an airbag in your seat and yellow connector under the seat. The wire breaks near to the second plastic T-shaped part (looking from the top of the seat backrest). It is located where is a pooling line and rising seat connector wire - somewhere in the center of lenght of the seat. Put the seat backrest to the vertical position, push up the black plastic cube of the line to remove it and have some room to repair the wire, cut a cloth tape. You should have ***** white and red wires. Inspect the wire about 1,5 inch from the center of the place where was the center of the T-shaped plastic keeper. The wire outside will be looking as new, but coper lines inside used to be broken. Strech slightly one by one of the 2 wires. When you find the break just cut the plastic cover in that place, remove 0,25 inch of the cover from each of cut end of wire and twist the ends or put extra 2 inch insert of the same wire. Wrap the coper wires in insulating tape neatly and tape all of the wires together with the T-shaped plastic keeper. Put on place the line udjusting a backrest of the seat, the keeper and plastic cover of the seat. Connect a battery and check it.
If you are not sure where is the place whre the wire could be broken, it is exactly 30 centimetres from the connector of the airbag. TomasS

Jun 14, 2009 | 2001 Chrysler PT Cruiser

2 Answers

Power windows


First off does the window switch on the passenger side? if it does then you may just need the drivers side window switch. The front and the back windows work seperate from each other.

Dec 31, 2008 | 2002 Chrysler PT Cruiser

Not finding what you are looking for?
Cars & Trucks Logo

471 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...