Question about Cars & Trucks

1 Answer

95 deville rear shocks replaced abs is now lit

Replaced rear shocks 95 deville with Monroe 90009 now abs light is on. Why and how to fix

Posted by on

  • Mike Trexler Jul 18, 2013

    could it be that factory shocks had plug in top shocks

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

U probably either disconnected a wire or broke a wire , check connect at wheel

Posted on Jul 18, 2013

Testimonial: "Do you think it could be the wires that went in top of factory shocks and now are in hooked"

  • Mike Trexler Jul 18, 2013

    only thing i unhooked was wires going into top of shocks

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 1998 Saab 900se turbo

This happend to my car and it was the ABS module that failed. It does not harm your car you just don't have ABS. Try to replace the ABS sensor first since it is a lot less expensive and a lot less work. If that does not do the trick you will most likely have to replace the module itself. That cost big $$. A new one is about 1200-1500. I bought one from a wrecked card for 300 and it has worked fine for years.

Posted on Aug 06, 2008

  • 1779 Answers

SOURCE: replacement shocks and struts

Check out autopartswarehouse they list front and rear KYB product. Not much out there, probably because of the year of the Murano, not too many people replacing shocks/struts yet, there will be much more available in a couple of years. I had to search for some time to find something.

Posted on Nov 27, 2008

  • 27 Answers

SOURCE: ABS LIGHT AND TRACTION CONTROL LIGHT ON DASH

make sure u didnt break a wire, there are sensors on the brakes, make sure theyre plugged in

Posted on Jun 10, 2009

  • 1 Answer

SOURCE: 98 cadillac deville needs rear shocks

I have a 1998 Deville and both rear coil springs are broken.. It also has the air shocks that I dont think work.. Can I put regular shocks in and is there a after market coil spring out there for it ??

Posted on Aug 07, 2009

  • 2309 Answers

SOURCE: abs break light off and on 2003 explorer. replaced senser in rear

if i remember right the are built into the bearing assembly

Posted on Nov 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1999 Cadillac Deville , the situation the car is raised high in the back rear suspension, with two lights on . The ABS light and the Stablize Traction lights on. What is the problem ?


HAVE VECHICLE CODE SCAN,SOUND LIKE YOU HAVE PROBLEMS WITH ABS BRAKES AND THE TRACTION CONTROL,SEEM LIKE YOUR AIR SHOCKS ELC HEIGHT SENSOR COULD BE BAD CAUSING AIR SHOCKS TO OVER EXTEND CAUSING CAR TO RAISE HIGH ON BACK END.WHICH COULD BE THE CAUSE OF ABS AND TRACTION LIGHT TO COME ON, TO FIX THIS PROBLEM HAVE CAR CODE SCAN AND YOU CAN FIND OUT WHAT CAUSING THE ABS AND TRAC LIGHT TO TURN ON.

Apr 03, 2011 | Cadillac DeVille Cars & Trucks

1 Answer

I have a 2001 cadillac deville. cylinder 6 and 8 supposedly have burned out ignition coils . are both cyl on the same side? in the matter of am i needing front and rear coil packs and does the whole pack...


no they are not ,in some motors the numbers are stamped on top of engine if you do not see them go to your local auto part store they can give you a print out of the firing order good luck

Mar 29, 2011 | 2001 Cadillac DeVille

1 Answer

Abs light came on after i replaced rear air shocks. how do i fix


Check the rear hub abs sensor connectors. its possible the one of them got knocked loose while you were installing the air shocks. the sensor and connectors are on the back of the hub in the center

Dec 20, 2010 | Buick Park Avenue Cars & Trucks

2 Answers

Rear air ride is flat on 95 deville....what do i


the first thing is the fuses. i've seen many of these that the rear air shocks are bad but customer doesnt know and the pump runs until it burns out,after checking the fuses start the car and listen under the hood for the pump to turn on, if pump turns on then check shocks for leaks, also you would have to make sure the pump is producing air as it runs and the last thing is the level sensor located under the rear of car.

Jul 13, 2010 | 1995 Cadillac DeVille

3 Answers

The service stability system light came on in my cadillac deville 2002.what do i have to fix on the car?


My Service Stability System Message along with the (ABS) Brake Light lit up on my dash, what can i do to fix it...Or what does this mean ?

Mar 04, 2010 | 2002 Cadillac Deville

1 Answer

Rear auto leveling system shock replacement. Can you use Monroe gas shocks? Monroe air shocks?


Gas shocks won't work but the air shocks should get you "up" and running again.

Dec 07, 2009 | 1991 Chrysler New Yorker

2 Answers

"check ride control" /suspension problems?


That is an indication that your air shocks at the rear needs to be replaced or there is a sensor that may have gone bad, event the air pump mey not be working. Most owners replace the more expensive air shocks with good conventional shocks like Monroe Reflex Shocks if there not towing heavy trailers. You can have the conventional shocks installed and have the ride control system deactivated. First check your fuse just t make sure the fuse to the air compressor has not gone bad, and the air ride leveling sensor, wire harness has not been damaged due to corrosion. 

Jul 02, 2009 | 2003 GMC Yukon Denali

1 Answer

ABS LIGHT AND TRACTION CONTROL LIGHT ON DASH


make sure u didnt break a wire, there are sensors on the brakes, make sure theyre plugged in

Jun 10, 2009 | 1999 Cadillac DeVille

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...