Question about Cars & Trucks

1 Answer

Turn signals dose not work

Turn sigal and fleshers dont work cant seem to locate fuse

Posted by on

  • tom_burgher
    tom_burgher Jul 18, 2013

    this is 2004 buick rendezvous

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 21,873 Answers

Depending on the make model and year, the turn signals and emergency flashers should be on two different circuits.

Posted on Jul 18, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75787 Answers

SOURCE: 1997 sonoma turn signal flasher

it is inside, under dash, on left side is a plastic sound protector, mine had 3 screws holding it up, drop this down and straight in you will see a 1" round thing - this is the flasher, pull it out and replace with new one (there are two flat prongs that plug in). It appears this is a well guarded secret!

Posted on Aug 26, 2008

  • 73 Answers

SOURCE: turn signal fuse location

Sounds like the turn signal flasher is your problem.

Posted on Sep 10, 2008

cranegang
  • 21 Answers

SOURCE: Turn signals dont work headlights dont dim heater fan doesnt work

Did all these problems happen all at one time?? If so you may have a bad body ground. Try running a electrical wire from the (-) negative side of the battery to the body and see if this works. Be sure this wire is to a place with no paint as low voltage electricity will not flow through paint.
A). If not try replacing the turn signal flasher for the turn signal problem. This is usually the culprit and it's easiest and cheapest to replace. The turn signal flasher will be found under the driver side dash next to the hazard flasher. Turn the hazard flasher one to locate it. If you want try swapping the turn signal flasher with the hazard flasher to see if this fixes it. They are the same style flasher.
If this doesn't work you may a faulty turn signal switch or some wiring issues.
B). It could as simple as the head lights bulbs need to be replaced, it's rare but I have seen when both bulbs blew at or near the same time. If your able check the voltage at the head sockets.
C). Could be a bad blower motor or switch. I'm not sure if these models have a resistor block or not. The resister block controls the electrical current going to blower motor which controls the speed of the blower fan.

Posted on Jan 19, 2009

  • 1118 Answers

SOURCE: turn signals dont work/dont light up on dash board either

There is also a turn signal flasher fuse, chg. that and they will work.

Posted on Mar 16, 2009

  • 272 Answers

SOURCE: 1997 sonoma turn signal flasher

The flashers are located behind the instrument panel trim, roughly between the base of the steering wheel and the ashtray, just to the left of the car lighter. To access the flashers, you need to at least loosen the lower instrument panel trim. Just under the steering column there are two screws with star heads. One to the left of the column and one to the right. You need to remove both of these screws. You will need to remove your ashtray. On the upper left corner of the hole left by removing the ashtray is a 9/32 hex head screw. You need to remove it. Once these three screws are removed you should be able to pull down on this portion of trim under your instrument cluster. When you do this it may cause trim around your instrument cluster to loosen that you can just pop back into place with your hand. You won't need to pull down to far on this trim piece as there are still some screws holding the bottom. You should be able to pull it down far enough to see the flasher units behind and just to the left of the cigarette lighter. There are two flasher units and I found that the one on the right is for the turn signals.On the left the other is for the hazard flashers. It may be a hand scraping experience to replace the flasher but it beats paying someone to do it for you. They are easy to recognize because the are silver and round metallic plug ins. The flasher unit on the left is for the emergency flashers and the one on the right is for turn signals. You can place the emergency flasher unit into the slot the turn signal unit belongs until you get a replacement. These flasher units are pretty cheap.

Posted on Jun 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Turn sigals dont work but hazard lights do


Yes they have separate flash turn signal also have a relay

Feb 05, 2013 | 1989 Ford Tempo

2 Answers

Signal and hazard lights do not work fuse is good


It is usually located near the fuse boxunder the dash on the driver's side. Simple way to find is go buy a new one and ask the counter peson to show the diagram showing its location. Cheaper than have a mechanic do it.

Aug 18, 2012 | 2000 Ford Focus

2 Answers

Turn sigal lights want come on but the emergency lights come on and head lights


Hi..my name is Keith...and if your bulbs work with the hazard/emergency ..then the bulbs are fine..and the turn signal and hazard lights should share the same fuse.my best guess is the turn signal switch is bad..and its mounted inside of your steering collum..i hope this helps

Jun 28, 2009 | 1990 Chrysler LeBaron

1 Answer

Turn sigal trouble


first check for grounding wires, beware of shortcircuits, lastly replace stick. If you replace stick without checking wires, u will throw money to trash

Jun 29, 2008 | 1997 Hyundai Sonata

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...