Question about Chevrolet Corvette

1 Answer

Procedure use reset car s computer

1993 corvette a/c unit stops working and when disconnect negative battery cable for a few minutes and re-connect everything works fine until i stop and restart engine.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 585 Answers

Does the ac unit fans come on? Also if it does come on is it only on bottom floor vents, or defroster only.

Posted on Dec 21, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 78 Answers

SOURCE: Car turns OFF

I dnt know the name of the sensor, probably its name is ignitiator, or the one directly attached to the spark plug ..............it may cost some 5000 to replace one!!

Posted on Sep 22, 2008

Testimonial: "Very good"

  • 104 Answers

SOURCE: Car loses power while driving

You must replace the distributor cap and rotor button- easy fix. Do not mix wires up. Message me I will guide you through it. definitely know my stuff here.

Posted on Nov 06, 2008

  • 1 Answer

SOURCE: Montero sport stalls at stops after battery change.

remove the cable again. Then when you start it allow it to idle for 20 mins in park.

Posted on Jan 07, 2009

  • 32 Answers

SOURCE: speedometer has quit working.

check all fuse make its all good. Might have a power surge while jumping

Posted on Mar 09, 2009

  • 39 Answers

SOURCE: I have an 03 saturn

sounds like a throttle sensor fault do to the fact that the saturn vue doesnt idle at 500 normally its uaually between 600-800. i suggest getting it hooked to a diagnostic machine to find wat the codes are cause im sure it will be several.

Posted on Nov 15, 2009

Testimonial: "not too sure, since the idle speed is always constant, it may in fact be 750, anyway the shutdown occurrs at random times without relation to the idle"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do I get the brake light in dash to go out after brakes have been repaired


Disconnect the battery negative cable for a few minutes then re-connect it. That will reset the computer.
Hope this helps.

However, resetting the computer will require about 40 starts for the computer to re-learn the car.

Feb 26, 2015 | Cars & Trucks

1 Answer

How do you make the computer relearn the system?


To reset the computer, disconnect the negative battery cable and let it sit for about 15 minutes. Most all codes will clear. Connecting the battery cable again and the computer will begin re-learning the system automatically. I've heard that some hard-set codes may stay in the system and need cleared using a code scanner but, I've not actually come across this before as disconnecting the battery cable has always worked for me.

Jun 21, 2014 | 1999 Chevrolet Tahoe

1 Answer

Reset immobilizer theft-system


I'm not sure if this will work, but you can try it; disconnect the negative cable from the battery. wait a few minutes. Place the ignition key in ON position. Re-connect the negative cable....That may reset the system.

Apr 08, 2014 | 2006 Honda Accord

2 Answers

89 vette, 48k, car starts fine, runs about a minute or 2, then shuts down, then wont restart, probably vats, after a few minutes, starts right up only to do the same thing.


Sounds like ignition control module (small plastic piece in bottom of distributor). When it gets warm it's shorting out. Easy fix, disconnect battery, pull cap & rotor - gin module is 2 screws in bottom of distributor and 4 wires - replace wires in exact order and coat bottom of middle with dielectric grease, replace rotor, cap & connect battery NEGATIVE CABLE LAST!

Apr 02, 2011 | 1989 Chevrolet Corvette

1 Answer

How do i reset the service light for the BMW 320i 2006 model. The key is a slot in type. To start, there is a start and stop button.


If you had work done on the car, they should have disconnected the battery. This "re-sets" the on-board computer to adjust to the new changes.

If you are referring to the "check engine" light as the "service light", here's what you can try:
disconnect the negative battery cable. Wait for 15 minutes, then re-connect. Hopefully that re-sets your on-board computer.

Some cars require a few more starts before the computer resets, so maybe you just haven't started it enough times since it was serviced.

Otherwise, I don't have enough info for a complete answer.

Feb 17, 2011 | 2008 BMW 3 Series

2 Answers

Reset check engine light 93 jeep


The easiest way to do this is take the negative battery terminal and leave it off for a few hours. Or if you have an autozone close they can reset it for you for free.

Nov 20, 2010 | 1993 Jeep Grand Cherokee

1 Answer

Wheres my voltage regulator. 89 dakota 2.5lt


On ALL gasoline models there is no separate voltage regulator. The regulator circuitry is contained in the engine controller. If this circuitry is found faulty, the entire engine controller computer must be replaced as a unit.

REMOVAL & INSTALLATION
(see Figure 1)

This procedure covers diesel models only.


58a0c54.jpg

Fig. 1: Pull on the connector body, not the wiring when removing the electronic voltage regulator
  1. Disconnect the negative battery cable.
  2. Release the spring clips and pull off the regulator wiring plug.
  3. See if your bolts are rusty or hard to remove, if so use lubricant and allow to sit for a few minutes before removing.
  4. Remove the regulator.
To install:
  1. Install the regulator and secure using the hold-down bolts.
  2. Hook the spring clips to the wiring plug. Make sure the clips are fully engaged.
  3. Connect the negative battery cable.

Hope this helped. (remember comment and rated).

Apr 10, 2010 | 1992 Dodge Dakota

1 Answer

Unlocksystem tailgate does not work, cables OK, fuses OK, relais Ok. I don,t no anymore


Try disconnecting the negative battery cable wait a few minutes and reconnect. This resets the computer.

Aug 15, 2009 | 2001 Volvo V70

1 Answer

How do you reset the alarm system on a 740i


Take the negative battery cable off overnight. This should fix it it.

Aug 10, 2009 | BMW 750 Cars & Trucks

1 Answer

98 corvette 5.7 eng., harmonic balancer needs replacing!


Crankshaft Balancer: Service and Repair
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Release the accessory drive belt tensioner (3).
3. Remove the drive belt (5) from the engine.
4. Remove the power steering gear from the vehicle.
5. Remove the starter motor.
6. Remove the power steering cooler bolts from the front crossmember.
7. Remove the power steering cooler from the front crossmember and reposition.
8. Release the air conditioning (A/C) belt tensioner (10).
9. Remove the A/C drive belt (1) from the engine.
10. Remove the crankshaft balancer.
INSTALLATION PROCEDURE
1. Install the crankshaft balancer.
2. Install the A/C drive belt (1) to the engine.
3. Install the power steering gear.
4. Install the power steering cooler to the front crossmember.
5. Install the power steering cooler bolts.
^ Tighten the power steering bolts to 11 Nm (97 inch lbs.)
6. Install the starter motor.
7. Lower the vehicle.
8. Install the accessory drive belt (5) to the engine.
9. Connect the negative battery cable.
^ Tighten the negative battery cable bolt to 15 Nm (11 ft. lbs.).
10. Program the Transmitters.

May 11, 2009 | 1997 Chevrolet Corvette

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...