Question about Cars & Trucks

Open Question

2003 honda odyssey egr valve

Need to locate where the egr valve is

Posted by on

  • Mary Nativio Jul 20, 2013

    Need to know where to locate egr valve in my 2003 honda odessey van????? 1 Site tells me it on the passenger side under intake manifold cover another site says its on the drivers side, CONFUSED!



6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 5568 Answers

SOURCE: EGR valve & 3rd gear pressure switch

I highly recommend you buy an aftermarket service manual from Haynes or Chilton.
They are based on a complete tear-down and will not only help you with this problem but will give you an idea if the service shop is being honest about the amount of labor involved.

EGR valves are normally found on the exhaust manifold or header.
This is where they get the gases that are recirculated into the intake.

The other problem I can't comment on but the manual would surely help.

Posted on Jun 18, 2008

  • 496 Answers

SOURCE: 2003 Honda Odyssey Brake light replacement

open the rear hatch. Between the tail light housing and the rear hatch opening there is a trim strip with two flush fitted flap doors. Insert a small straight blade screwdriver into the small slot on the tail light side of the flap. Pry gently inboard and the small flap will open (the hinge side of the flap is on the side of the rear hatch opening.) Now you can remove the screws that hold the tail lamp assembly in place. Finally, there is still a "spear point" clip that fits into a socket near the front outboard corner of the assembly. Gently pry with a tape wrapped screwdriver (avoids scratches) and force the assembly straight back. The clip should release and free the assembly so you can change the bulb(s).

Posted on Jan 24, 2009

  • 398 Answers

SOURCE: egr valve location

The EGR Valve Location is typically housed on the intake manifold this schematic may help you

Posted on Mar 07, 2009

  • 496 Answers


the turn signal and hazard flasher unit is located on the backside of the driver's side fuse/relay box under the left end of the dash. to access, remove a nut on the left side of the fuse box and release two locking tabs from the upper and lower mounting brackets and remove the fuse box. Now you can access the backside of the box and change out the signal flasher unit. Its a black square plastic unit that pulls straight out.

Posted on Jul 19, 2009

  • 1 Answer

SOURCE: 2000 Honda Odyssey Fuel Vapour Canister location

It is located at the top of the gas tank. You are going to have to drop the tank in order to check it, so it is best to do this when there is not a lot of gas in the tank. Hope this helps you out.

Posted on Aug 21, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Where is the wiper relay in a 2003 honda odyssey

the relay box in under the hood near to the battery , remove the cover flip over it has a diagram showing the position to find the relay wiper switch fuse. small cube shape can easily be removed or replace

Feb 16, 2015 | 2003 Honda Odyssey

2 Answers

I have a 2003 honda Odyssey. Does it have a releif valve or nut to release trapped air in my cooling system? I just drained my radiater and replaced my therastat and its running hot when im driving.

locate the coolant temperature sensor nearto the thermostat housing. Unplug, loosen then plug back up. To bleed, loosen slightly to release trapped air. Once air is relieved, only liquid will come out at this time the air bleeding is done.

Dec 21, 2014 | 2003 Honda Odyssey

1 Answer

I replaced EGR valve twice one infact today with dealer part but still the check engine light came on after driving my 2000 Honda odyssey van for 25 miles? any suggestions?

I had an egr code. there is a honda service bulletin out about clogged egr ports. The service bulletin involves putting some kind of sleeve in the port. I just followed the service bulletin to clean out the port, I didn't put in the sleeve or any parts. Seems to be working good for the last six months. It took a couple of hours and some gaskets for the intake manifold.

Sep 23, 2010 | 2000 Honda Odyssey

1 Answer

How do you get to front expansion valve on 2003 honda odyssey, and where is ther rear valve located?

the front expansion valve is located with the evaporator ,
a big job. the rear is the same , just easier.

Aug 13, 2010 | Honda Odyssey Cars & Trucks

2 Answers

2001 Honda Odyssey with a TCS and check Engin light on

you should have the codes pulled but its prob gonna be an EGR code. when the vehicle has an egr problem it will have decreased power that will cause the tcs light to come on due to the system being shut off by the check engine light code. prob just needs a new egr valve and the light cleared.

Mar 12, 2010 | 2001 Honda Odyssey

1 Answer

Egr valve insufficient flow detected

clean the exhaust ports where the egr valve fastens to the tube and check the EGR valve for being out of range sounds like is it defective

Jan 14, 2010 | 2000 Honda Odyssey

1 Answer

Where is the egr valve located in a 2003 honda pilot

its on the rear of engine, but caution theres a updated egr kit for these vans due to lots of egr problems,also the waterport should be remove to clean all egr ports and drilling the intake is needed to use updated your dealer lots of these have recalls on them.hope this helps.

Jan 03, 2010 | 2003 Honda Pilot

2 Answers

Location and replacement of egr valve on honda odyssey

two 12mm nuts and youll need a new gasket if your replacing it.b1ebf84.jpg

Dec 31, 2009 | 1999 Honda Odyssey

1 Answer

How do I replace an EGR valve?

it should be located by the head of the engine it has two bolts and a sensor on the top of it make sure that you have the gasket for it should be a 12MM wrench or socket if you can get it on

Nov 02, 2009 | 2003 Honda Odyssey

1 Answer

2001 Honda Odyssey EX Idles rough

sound to me like a vaccume leak but a bad or stuck EGR will act the same way. does it use oil ? cause if it is this could be what is sticking your EGR.

Aug 24, 2008 | 2001 Honda Odyssey

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15427 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides