Question about Cars & Trucks

Open Question

How to fix brake light bulbs on ford falcon au serieis iii 2002

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
alicantecoli
  • 22156 Answers

SOURCE: Brake light change on Ford Focus, 2002.

piece of cake ,two minutes

Posted on Jan 27, 2009

Ad
  • 6 Answers

SOURCE: How do you replace a driving belt on a 1999 AU ford falcon

start by unplugin the electric fans then remove the two 10mm bolts holding them in, the bottom of the fans are held in by a slot that they sit in so after you remove 2 bolts just lift the fans out. then you will see a tensioner i think it has 3/8 drive square hole in it( could be 1/2'' drive) just pull it down with a long bar with a 3/8 end on it to release the tension, while doing that slide the belt of,. if your car doesnt have a picture diaghram on the under side of the bonnet for drive belt routing draw a picture incorprating all the pulleys an how the belt goes around them. once the belt is of put the new one on exept over the power steering pump pulley, then pull on the tensioner again to release tension and slide the belt over the p/s pulley. these instruction are for the 4.0l falcon motor, the 5.0 v8 is really similar

Posted on Apr 22, 2009

  • 66 Answers

SOURCE: My 2002 Ford Ranger Edge brake lights do not work

Brake light switch It is on the brake pedal

Posted on Jun 29, 2009

  • 1 Answer

SOURCE: changing rear brake bulb

I have a '98 build EL Falcon. If the tail light assembly hasn't been out before, inside the boot there are these 2 locating pins coated in plastic. These are attached near the outer edge of the assembly, running inside the boot. The square shaped hard plastic bits protruding inwards are for screws to attach to - so don't remove these. I had to get the plastic off to free the locating pins to remove the assembly. The second part is the 2 screws towards the reverse light end of the assembly. You access these from the outside of the car. Once these are undone the assembly should come out far enough to access the bulbs - as wiring is attached. There are 3 accessible bulbs available to replace. The brake light and the indicator bulb holders are in line with each other and you twist them out of the assembly, then remove the actual bulb and replace. To replace the assembly, put the locating pins into position and then the rest until sitting correctly and re-install the 2 screws.

Posted on Sep 29, 2009

kirkx
  • 2019 Answers

SOURCE: Ford Falcon Sedan AU model. The blinkers staying on

The flasher relay can get stuck. It is usually a 3 pronged, small, cylinder or cube plugged into the fusebox.

Posted on Jul 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Iut just bought a ford au 1999 with a remote but tonight I cannot open the car door..


if genuine au remote.. check the fob battery

could be a faulty door lock actuator or module fault

you will find the free AU falcon repair manual handy
Ford Falcon AU 1998 2002 Workshop Manuals Factory Service Manuals

Nov 24, 2016 | Ford Cars & Trucks

1 Answer

What is fuse layout for a 99 Ford falcon forte


AU
chasing fuses may be more issues

might be useful to have the full AU falcon repair manual


Ford Falcon AU 1998 2002 Workshop Manuals Factory Service Manuals

Nov 03, 2016 | Ford Cars & Trucks

1 Answer

How do i bypass the smartsheild on a 2001 au ford falcon ute.i cant start because the smartsheild comes on an jams the motor?


the problem was raised in the australian AU ford forum not so long ago
you cant bypass it
ripping out wires without knowing ... just causes more grief

have to use a scanner to re set system
or find which module of the smart shield has failed
AuII Smartsheild question
fordforums com au
i have the downloadable repair manual for that AU

one download only.. not for resale etc etc
Ford Falcon AU 1998 2002 Workshop Manuals Factory Service Manuals

Oct 17, 2016 | Ford Cars & Trucks

1 Answer

How to adjust parking brake on au ford falcon 1999?


ford park brakes are adjusted by a nut in the brake calliper and then self adjust. Get a ford workshop manual and see how it is done as it is a bit complicated

Jul 28, 2014 | 1999 Ford Falcon

1 Answer

Ford au stalling


how is it stalling idling ok ? 5-10 min of driving, stopping at lights etc would need more info please.

Mar 17, 2014 | Cars & Trucks

1 Answer

Reverse light work but brake light and rear turn signal doesnt


If your brake lights and turn signals are out, you most likely have a blown fuse, burnt bulb, or a problem in the steering column.----------------------------------------------------------------------
digimaster iii

Dec 21, 2012 | 2002 Ford Explorer

1 Answer

Ajusting hanbrake ford au111 2002 falcon


Hi Shannon, There is an ajustment nut at the base of the hand brake it's self, you pull the cover strait off the end of the handle and it is a 10mm nut on a treaded piece of metal rod/cable. If it's as tight as it can get you may need new brake boots for you handbrake. Just checked ebay and they are $66 plus postage for a set :)

Remember righty tighty lefty loosie :p
hope this helps :)

Nov 17, 2012 | Cars & Trucks

1 Answer

My brake lights won't work in my AU Ford Falcon


On vehicles that use a common bulb for signal and brake lights the brake light circuit runs through the signal switch. A problem in the signal switch can cause the brake lights not to function. Also check your Emergency flasher switch. Hope this helps.

Apr 11, 2010 | Ford F Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...