Question about 2003 Mitsubishi Montero Sport

Open Question

Codes p0456 I get code p0456 found no leaks run evap test with computer passes. drive for about 500 miles and comes back on same code

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
short shadey
  • 421 Answers

SOURCE: Large vacuum leak

look under the back end of the car where the smaller lines come off the fuel filler neck look for any broken, dissconnected,or rusted lines, or sensors follow these lines back to the fuel tank and up to the front of the car and under the hood repair as needed good luck and please rate -jeff

Posted on Sep 05, 2008

Ad
  • 9 Answers

SOURCE: Will not pass inpection, 5 sensors not ready--V6 3.0

Drive the car for 2 miles non-stop and take it to smog inspection WITH OUT TURNING OFF THE CAR!! the key is that the car goes threw the test while the engine is running ...

if the car is turned off ... u will have to repeat procedure ...

Posted on Apr 17, 2009

  • 172 Answers

SOURCE: what is an error for P0456. Found this code when i

This is an evaporative emmisions - small leak detected. Sometimes caused by fueling with the engine running (the fuel cap has to seal the fuel tank for the pressure sensor to read correctly), but can be a leak at the evaporative canister, Check valve on top of the fuel tank cracked and a host of other components, fittings or leak points. Best bet is to have a diagnostic done by a shop which should include pressurizing lines, etc.

Posted on Jan 07, 2010

jesiquiux
  • 168 Answers

SOURCE: evap code p0456

P0456 - Evaporative Emissions System - Small leak detected
The Powertrain Control Module (PCM) at different times performs various tests on the EVAP system. OBD II Enhanced EVAP systems are in place to keep fuel tank vapors from venting into the atmosphere, and instead purges them into the engine to be burned. Regular pressure tests are conducted by the PCM to monitor the sealed system for leaks. The PCM monitors the EVAP system pressure by watching the fuel tank pressure (FTP) sensor. When the sensor indicates a small leak in the EVAP system, this code is set.
Potential Symptoms

There will likely be no noticeable symptoms other than the Malfunction Indicator Lamp (MIL). This is because the EVAP system is a closed system and only controls fuel tank vapors, not engine management.

Causes: Usually this P0456 code is caused by an incorrect or faulty gas cap. Filling the fuel tank with the engine running could conceivable cause this code as well or if the cap wasn't properly tightened. Any of the following could also be the cause:
* A small leak in any of the EVAP hoses or fuel tank hoses
* A small leak in the purge valve or vent valve
* The EVAP Canister may be leaking

Possible Solutions: First, using a scan tool activate the vent solenoid, sealing the system. Then monitor the fuel tank pressure (FTP) sensor. If the system is sealing properly, the number will stay consistent. If is isn't, the pressure sensor will show that as well. If the system slowly leaks, use a smoke machine and watch for smoke exiting the system at any EVAP component. Any where there is smoke exiting the system, that is the faulty component. Do not pressurize the EVAP system with air pressure. Doing so can damage the purge and vent solenoids in the system.


Hope this helps.

Posted on Mar 24, 2011

  • 118 Answers

SOURCE: I have a 2003 Mitsubishi Eclipse Spyder. the

Have the code cleared and wait until it come on again. when and if it returns, have the codes retrieved again, the reason for this is to make sure that it was not a fluke. If the same code return then you may want to make sure that you're not leaving the ignition switch on while refueling and if that's not the cause, then you may want to start looking around your fuel tank for evidence of fuel or vapors at the gas tank seals

Thanks
Rodney

Posted on Jun 15, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why my 2004 chrysler pacifica stop running at stoplight?


code - po442=evap leak medium detected

code-po456=evap leak small detected
look at fuel cap or leaks in rubber hoses

Aug 20, 2014 | Cars & Trucks

1 Answer

Check engine codes


P0456 = small leak in EVAP system. First check the seal on the fuel cap and if the cap is installed well. When ok, check the rubber EVAP system hoses, which pass the rear axle, they tend to dry rott and start leaking.

Aug 12, 2013 | 2002 Jeep Grand Cherokee

1 Answer

Im getting a fault code p0456


Code 456 means the computer has found a small leak in the EVAP system. The computer vents the gas tank to the vapor canister several times while the engine is running. The system has to be sealed to work properly.
Someone would need to test the venting system for leaks. It could be the gas cap or a valve or hose.

Feb 26, 2013 | 2002 Volkswagen Jetta TDI

1 Answer

I have codes P0422 and P0456 found a hole in Vacuum line by air cleaner box, hard plastic. I think the line is part of the evap control system. Question is how long until the computer will clear the code ?...


You do not have to drive any miles at all
if you repair OBD2 issues ,they either clear
themselves or you clear them with a scanner
or code reader,disconnect the battery on some veh

The PO456 -- is a Small Evap Leak - you have to find & repair

The PO422- May be a bad exhaust converter on Bank 1

Jul 12, 2011 | 2004 Chrysler Pacifica

1 Answer

Engine scan codes are P0442, P0456 , can you please help me with these codes


P0442 - Evaporative Emission Control System Leak Detected (small leak)
This indicates a fuel vapor leak in the EVAP control system. It means a very small leak has been detected. In fact, the leak can be from a hole as small as 0.04" in diameter. The (EVAP) emission control system prevents the escape of fuel vapors from a vehicle's fuel system. Fuel vapors are routed by hoses to a charcoal canister for storage. Later, when the engine is running a purge control valve opens allowing intake vacuum to siphon the fuel vapors into the engine.

Symptoms: You likely won't notice any drivability problems.

Causes: A code P0442 most likely means one or more of the following has happened:
A loose or improperly affixed gas cap
A non-conforming gas cap (i.e. not factory/original brand)
A small leak/hole in a fuel vapor hose/tube
Other small leak in EVAP system
Faulty vent o-ring seal

Possible Solutions: With a P0442, the most common repair is to:
Remove and reinstall the gas cap, clear the codes, and drive for a day and see if the codes come back.
Otherwise, replace the gas cap, or
Inspect the EVAP system for cuts/holes in tubes/hoses



P0456 - Evaporative Emissions System - Small leak detected
The Powertrain Control Module (PCM) at different times performs various tests on the EVAP system. OBD II Enhanced EVAP systems are in place to keep fuel tank vapors from venting into the atmosphere, and instead purges them into the engine to be burned. Regular pressure tests are conducted by the PCM to monitor the sealed system for leaks. The PCM monitors the EVAP system pressure by watching the fuel tank pressure (FTP) sensor. When the sensor indicates a small leak in the EVAP system, this code is set.

Potential Symptoms: There will likely be no noticeable symptoms other than the Malfunction Indicator Lamp (MIL). This is because the EVAP system is a closed system and only controls fuel tank vapors, not engine management.

Causes: Usually this P0456 code is caused by an incorrect or faulty gas cap. Filling the fuel tank with the engine running could conceivable cause this code as well or if the cap wasn't properly tightened. Any of the following could also be the cause:
A small leak in any of the EVAP hoses or fuel tank hoses
A small leak in the purge valve or vent valve
The EVAP Canister may be leaking

Possible Solutions: First, using a scan tool activate the vent solenoid, sealing the system. Then monitor the fuel tank pressure (FTP) sensor. If the system is sealing properly, the number will stay consistent. If is isn't, the pressure sensor will show that as well. If the system slowly leaks, use a smoke machine and watch for smoke exiting the system at any EVAP component. Any where there is smoke exiting the system, that is the faulty component. Do not pressurize the EVAP system with air pressure. Doing so can damage the purge and vent solenoids in the system.


Test it; keep us updated and remember to rate this answer.

Jun 03, 2011 | 2005 Dodge Grand Caravan

1 Answer

PO456 trableshooting


Info found at: http://www.obd-codes.com/p0456

Maybe try cleaning, tightening, or replacing the gas cap first?


P0456 Article by Dale Toalston ASE Certified Technician

Evaporative Emissions System - Small leak detected

The Powertrain Control Module (PCM) at different times performs various tests on the EVAP system. OBD II Enhanced EVAP systems are in place to keep fuel tank vapors from venting into the atmosphere, and instead purges them into the engine to be burned. Regular pressure tests are conducted by the PCM to monitor the sealed system for leaks. The PCM monitors the EVAP system pressure by watching the fuel tank pressure (FTP) sensor. When the sensor indicates a small leak in the EVAP system, this code is set.

Potential Symptoms:

There will likely be no noticeable symptoms other than the Malfunction Indicator Lamp (MIL). This is because the EVAP system is a closed system and only controls fuel tank vapors, not engine management.

Causes:

Usually this P0456 code is caused by an incorrect or faulty gas cap. Filling the fuel tank with the engine running could conceivable cause this code as well or if the cap wasn't properly tightened. Any of the following could also be the cause:

- A small leak in any of the EVAP hoses or fuel tank hoses

- A small leak in the purge valve or vent valve

- The EVAP Canister may be leaking

Possible Solutions:

First, using a scan tool activate the vent solenoid, sealing the system. Then monitor the fuel tank pressure (FTP) sensor. If the system is sealing properly, the number will stay consistent. If is isn't, the pressure sensor will show that as well. If the system slowly leaks, use a smoke machine and watch for smoke exiting the system at any EVAP component. Any where there is smoke exiting the system, that is the faulty component. Do not pressurize the EVAP system with air pressure. Doing so can damage the purge and vent solenoids in the system.

Apr 13, 2011 | 2004 Volvo XC70

2 Answers

Ihave 3 error codes on my 02 new beetle they are: P1171, P0456, 01314. The EPC light and the ASR light come on after driving for approx 17miles then after shutting the car off then the next time I start it...


Sounds like you have and issue with your throttle sensor from the 1171, not sure of the others as they are not on the list so please verify. Here is a link to the codes for future reference, scroll to the bottom which list the DTC's..
http://www.bentleypublishers.com/tech/vw/vw.dtc.table.htm

Nov 11, 2009 | 2003 Volkswagen New Beetle Convertible

5 Answers

Diagnostic code P0456 for 2003 Dodge Ram 1500 5.7


P0456 = EVAP Emissions Control System Leak Very Small

Is the gas cap on tight or is the seal damaged? If it needs replacement, get it from the dealer.

Aug 22, 2008 | 2004 Dodge Ram 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...