Question about Cars & Trucks

Open Question

On my 2000 Hyundai accent the brake & battery light is lite up on the dash

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
maklean
  • 1665 Answers

SOURCE: installing new brake pads on 2000 hyundai Accent GL

REMOVAL 8118049.gif 1. Remove the lower bolt and lift the caliper assembly up and secure it with a wire or some other retaining method. 2. Remove the pads. CAUTION: Do not depress the brake pedal while disassembling the pads 30c09b4.gif

INSPECTION 1. Check the pads for wear or oil contamination and replace, if necessary. caution_icon.gif The pads for the right and left wheels should be replaced at the same time. Never "drop" or intermix brake pad sets. All four pads must be replaced as a complete set. When replacing the brake pad, check for deformation. When replacing the guide spring, use a new one or the used one after cleaning away foreign material. 2. Check the pad for damage or deformation. Brake pad thickness: Standard value: 9 mm (0.354 in.) Service limited value: 2 mm (0.0787 in.)21873bf.gif
INSTALLATION 1. Install the pad clips. 2. Install the pads onto each pad clip.
3. Insert the piston in the cylinder using the Special Tool (09581-11000).b3dcdee.gif 4. Install the new pads. The shims are attached to each pad as illustrated5efc485.gif caution_icon.gif Be careful so that the disc or pad isn't contaminated by grease. 5. Install the bolt and tighten to the specified value. Tightening torque Guide rod bolt: 22~32 Nm(220~320 kgf·cm, 16~24 lb·ft)

Posted on Jun 11, 2008

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why dont we have no dash board lights and brake lights not working checked fuses are ok ?


dashboard lamps or bulbs in cluster may be burnt or bad dimmer switch.for the stop lights, check brake switch located behind brake pedal

Dec 16, 2014 | 2000 Hyundai Accent

1 Answer

Hyundai Accent 2000, brake light


Could be the switch for the hand brake. You might try unplugging it to see if the light goes off.

Feb 23, 2013 | 2000 Hyundai Accent

1 Answer

Hyundai accent won't start hooked up to jumper cables


First off remove the ground cable from the battery and at the body mount and CLEAN both area that the cables ground to
charge the battery fully and recheck if the car will start

Mar 25, 2017 | 2005 Hyundai Accent

1 Answer

2000 Hyundai accent. Trunk open warning light on dash looking to disable this warning on dash to prevent draining battery again. Have removed light temporarily from the trunk to slow down the drain however...


You should have a switch in the trunk area or on the trunk latch it makes contact to ground to turn on the light in trunk if you disconnect the switch should take care of it temporarily.

Nov 29, 2017 | 2000 Hyundai Accent

1 Answer

HOW DO I REMOVE BRAKE LIGHT 2000 HYUNDAI ACCENT


1. Disconnect the negative(-) battery terminal. 2. Remove the tailgate trim. d9919dc.jpg
3. Remove the 5 bolts, disconnect the wire connector and then remove the center high mounted stop lamp
8cda00a.jpg
4. Installation is the reverse of removal.

Jun 06, 2009 | 2000 Hyundai Accent

1 Answer

Connect injector node lite to injector no pulse while cranking, where do the injectors get their power?


The power to the injectors comes from the Engine Control Relay located in the the driver's side dash
Here's a photo:
e809bfa.jpg

May 10, 2009 | 2000 Hyundai Accent

1 Answer

2000 Hyundai accent dash lights wonky.


you need to replace the headlight switch

Jan 18, 2009 | 2000 Hyundai Accent

4 Answers

DASH LIGHT CAME OFF


there are a couple of diodes under the hood that need changing at about 12 dollars each.should solve your problem

Jul 12, 2008 | 2001 Hyundai Accent

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14398 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...