Question about Cars & Trucks

Open Question

Peugeot 5008 my peugeot wont lock with the remote key. I can hear the locking mechanism move, but it wont engage

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: peugeot 406 central locking

you need to reprogram the fob

Posted on Oct 07, 2008

Ad
  • 328 Answers

SOURCE: 1994 chevy 1500 $ wheel drive wont engage

your problem is probably the front axle solenoid. it is in the center of the truck on the front axle and it is really easy to change. Simply unplug the electrical connector and use a wrench to loosen it. Spin it counter clockwise until it comes out........Manual hubs i believe are not available for this truck but i think there is a aftermarket cable you can buy and install to lock the front diff in.

Posted on Feb 17, 2009

  • 1 Answer

SOURCE: Central Locking to Ford Focus LX 2001

Problem with 2001 1.6 Focus which i was going to purchase for the wife, but problem with central locking! key fob totally dead even when i tried the reprogramming trick (key in ignition press button several times) and when locking/unlocking manually, central locking only working intermittently! Please help regards steve

Posted on May 30, 2009

pippall
  • 1486 Answers

SOURCE: 406 hdi pass door lock wont lock so car wont lock

Remove the door pannel and spray releasing oil over the central locking solinoid.That should sort it for you good luck.

Posted on Sep 02, 2009

  • 1 Answer

SOURCE: my key wont unlock the trunk anymore but the remote opener does.

There is a cable that runs from the key cylinder to the latch mechanism. There are clips that hold the cable housing in place, and if one of those comes loose then turning the key just moves the housing without releasing the latch. Check the clip closest to the latch. To get the trunk open drop the back seat, crawl in, and pull on the cable.

It is also possible that the cable is broken or damaged and needs to be replaced -- I assume you will then need to replace the enrite assembly.

Posted on Sep 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do i reprogram my key on peugeot 307 hdi 2001


Many cars have a different process to enabling passive systems, some require turn the key on and off 3 times then hold it in the on position while holding down the remote, or you may hear a chirp to start the calibration process, the safest way of course to marry the unit to the vehicle is to scoot down to the Peugeot dealer and get them to do the program, it may cost, but they also have to make sure everything works correctly too, so they will stand by the service they provide you. hope this helps, happy holidays.

Nov 29, 2014 | 2001 Peugeot 307

1 Answer

How to program key on peugeot 307 hdi 2001


put key in icnition turn on but don"t start engine,press door lock and hold for a few seconds,then turn off,key fob should now work,if not try again,also make sure you have the correct battery in key fob.

Nov 29, 2014 | 2005 Peugeot 307 HDi

1 Answer

Ignition switch will not engage/turn to start car


Hi Beth usually when shifter is stuck there is a locking mechanism and keeps shifter from engaging unless brake is depressed to release the lock. If you hear a clicking sound when pedal is depressed then switch is probably ok and its probably the steering wheel lock. First try with your spare key to start the vehicle(old key may be worn ). If that doesn't do it then try with WD 40 a very little in ignition key hole or on the key work it slowly and see what happens. If none of these suggestions work its probably the steering wheel lock and that requires surgery. Keep me post best of luck

Mar 27, 2014 | 1999 Toyota Avalon

1 Answer

Car doors wont lock with remote


Sounds like the rod that goes from the lock to the key came off. There is usually a little plastic clip that holds it together and they break and you get what you are experiencing. You have to take the inside panel off of the door to get inside it.

Jul 05, 2017 | Peugeot 406 Cars & Trucks

1 Answer

Car wont lock


spray excess WD 40 or similar onto the key whilst moving it in & out of the lock or dribble it down a toothpick/cocktail stick in to the lock or hold the lock open with the stick and spray into the lock barrel

Sep 02, 2009 | 2006 Peugeot 604

2 Answers

Peugeot 406 HDI 2001. O/S rear door dead locked.


Deep joy. This can be a royal pain. The only way I have successfully done this is to put a battery charger on the car overnight, locked, and then when the battery is sitting at about 15v unlock it with the remote - when the lazy deadlock is stirred into action. It can take a couple of attempts. It really is incredibly difficult to get to. Otherwise, its most easily a case of breaking the unit...though you could try taking the leads off and applying 18v to the solonoid directly. That was my next move, but never needed to get there. You can however stop the deadlock from locking, by cutting one of the wires, test using a multimeter which one is live when you arm the alarm/deadlock the car. Thats also the one to apply 18v to if you want to.

Jul 05, 2009 | 2006 Peugeot 604

1 Answer

Fob wont work the locks


I have done this procedure for my peugeot 307, but you can give it a try for your Pug expert and let me know if it works.
Disconnect the battery for 5 minutes then after connecting the battery perform the following steps
1. Turn the Ignition switch to the ON position using your key.
2. Press the LOCK button for 10 seconds. It will set your ECU in programming mode.
3. Remove the key and wait for 10 seconds.
4. Press the buttons on the key repetedly for operation (lock und unlock doors) to synchronise the key signals.
5. Again turn the ignition on and start the engine.
6. Turn the ignition OFF

If fails in step 4, then disconnect the battery and reconnect it and wait about 10 minutes to check the remote. Some new ecu units synchronises itselfs if you disconnect the battery while in programiing mode.

May 23, 2009 | 2005 Peugeot 405

3 Answers

I need to reset my peugeot 406 key fob


Had same trouble with my 406, fixing no problem, with new battery in fob, insert into ignition, turn key, BUT DO NOT START ENGINE, hold button for about 10 seconds release button and remove key from ignition, then try and see if doors lock on remote, if not try again, had to do this a couple of times, and it worked, sorry to say that now my key fob button has completely fell apart, through ware and tare

May 19, 2009 | 2005 Peugeot 405

1 Answer

Peugeot 406 estate, locking problem


HI,THIS IS VERY COMMOM ON ALL PUGS AND CITRONS,TRY GOOD OLD WD40 SPRAYING ON THE KEY AND KEEP WORKING KEY IN/OUT OF LOCK,IT WILL START TO TURN LOCK WHEN ALL THE WORKS ARE CLEAN,THANKS.

Dec 18, 2008 | 2006 Peugeot 604

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...