Question about Cars & Trucks

Open Question

2001 gmc YUKON POWER STEERING HOSE NEEDS REPLACING HOW

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 17 Answers

SOURCE: Replace power steering hose on 2000 Jeep Grand Cherokee

Parts are not cheap. I'm not sure how hard it is to get to your lines but line wrench/crows foot are probably needed. They are like a boxend wrench with cutout to go over line.

Posted on Dec 23, 2008

  • 196 Answers

SOURCE: light replacement

Just reach behind the bumper and grab the light/electrical harness and twist is either way and then it should pull out put in a new 194 bulb and you are set.

Posted on Jan 08, 2009

  • 37 Answers

SOURCE: How do I repair a leaking power steering hose?

ok thees instructions that i have is for replacing the power steering pump but it has a great pic witch shows the power steering hoses i hope it helps


NOTE The following procedure requires the use of the GM Puller toolNo. J-25034-B or equivalent, and the GM Pulley Installer tool No.J-25033-B or equivalent.

  1. Disconnect the negative battery cable for safety.
  2. Remove the air cleaner assembly for access.
  3. Release tension and remove the drive belt.
  4. Remove the power steering pump pulley using a suitable puller tool.
  5. Remove the power steering pump retaining bolts, then reposition the pump as necessary for access to the hoses.
  6. Position a fluid catch pan under the power steering pump.
  7. Remove the hoses from the power steering pump and drain the excess fluid into the catch pan.
    WARNING Be sure to cap all openings in the pump hydraulic system toprevent excessive fluid spillage and the possibility of systemcontamination.
  8. Remove the power steering pump from the vehicle.

    0900c15280227d22.jpg enlarge_icon.gifenlarge_tooltip.gifFig. Pump pulley removal and installation


    0900c15280227d23.jpg enlarge_icon.gifenlarge_tooltip.gifFig. Exploded view of the power steering pump mounting


    0900c15280227d24.jpg enlarge_icon.gifenlarge_tooltip.gifFig. Typical power steering pump hose routing

To install:
  1. Position the pump to the vehicle, then uncap and connect the pump hoses.
  2. Install the steering pump to the retaining bracket, then secureusing the retaining bolts. Tighten the nut to 30 ft. lbs. (41 Nm).
  3. Install the pump pulley using the GM Pulley Installer tool No.J-25033-B or equivalent. Press the drive pulley onto the power steeringpump.
  4. Hand-tighten the pivot bolt, the adjusting bolt and the washer.
  5. Install the drive belt.
  6. Install the air cleaner assembly.
  7. Connect the negative battery cable.
  8. Refill the power steering reservoir and bleed the power steering system.
  9. Road test the vehicle, then check and top-off the power steering fluid.

Posted on Apr 23, 2009

  • 81 Answers

SOURCE: replacing power steering hose and rack and pinion steering

when it comes to the power steering hose I would say just do it yourself. As for the rack and pinion it will probably cost you quite a few hours of labor. anywhere from 5-9. Its up to you!

Posted on Oct 19, 2009

  • 27 Answers

SOURCE: problems with acceleration - 2001 Yukon

Most likely it is due t5o dirty fuel injectors or bad mass air flow sensor

Posted on Jul 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the ac belt in a 2001 gmc yukon


You got two belts on this vehicle the serpentine belt which runs the power steering, water pump, alternator. Behind the serpentine belt toward the bottom if the engine compartment theres a smaller belt that runs frm the crank to the ac compressor and the belt tensioner.

Jun 20, 2012 | 2001 GMC Yukon

1 Answer

How do I get my power steering pump out of 2002 yukon


Hello walker_227,

Removal Procedure:

SPECIAL TOOLS: You will need a power steering pulley remover and installer tool, DO NOT USE A HAMMER.

1. Remove the power steering pulley.
2. Raise the vehicle.
3. Remove the oil pan skid plate from the vehicle, if equipped.
4. Place a drain pan under the vehicle.
5. Remove the power steering pressure hose from the power steering pump from underneath the vehicle.
6. Lower the vehicle.
7. Remove the return hose from the power steering gearbox and the power steering pump.
8. Remove the bolt retaining the rear bracket to the engine.(See picture below)
9. Remove the bolts from the front of the pump.(See picture below)
10. Remove the pump from the vehicle.
11. Remove the bracket from the rear of the pump

Installation Procedure:

1. Reverse above procedure
2.Fill and bleed the power steering system.

netvan_20.png

Mar 14, 2011 | 2004 GMC Yukon

1 Answer

Show me how to replace power steering pressure hose on 1995 GMC Yukon


It's very easy, undo screw one end from back of power steering pump, no need to remove pump, and unscrew other end of hose from steering gear box, replace hose and top off with power steering fluid, when you undo power steering hose have a pan to catch the power steering fluid that will drip out.

Aug 17, 2010 | GMC Yukon Cars & Trucks

1 Answer

I have A 2001 gmc yukon 1500 the rpm go up and down


The idle spped control needs replacing and I would change the plugs & wires as well if very old

Jun 30, 2010 | 2001 GMC Yukon

1 Answer

2001 5.3 yukon with no power steering.


well your power steering pump could have went out, but crank it up take the lid off and look inside while someone turns the wheel and see if the fluid is moving around and then have them do it while its in park wile giving it some gas and check again to see if its moving if not its probably went bad

Jul 07, 2009 | 2001 GMC Yukon

1 Answer

Steering issues


Find the leak and repair it...It is a sealed system, if you are adding large amounts of power steering fluid, it is leaking out somewhere. Hoses, reservoir, steering box, power steering pump are places to check. You should only have to add minimal fluid to the system for the entire year.

The immediate squeal you hear is most probably the unit is out of fluid or has leaked onto the serpentine belt and causing it to slip.
Fix the leak and check your serpentine belt for wear.

Apr 23, 2009 | 2001 GMC Yukon XL

1 Answer

Power steering on 2000 gmc qit working


Those are Notorius for the shafts in the pump itself breaking.. Remove the serpintine belt.. then grab the pulley on the ps pump and see if it pulls out.. if it does.. Pump Time Boys-n-Girls.. Hope this helps.. Thank you

Mar 11, 2009 | 2001 GMC Yukon

1 Answer

4LO problem


Sounds like you may have a problem with the power steering pump. Notorious for these pumps shaft to break, causing "armstrong" power steering. As far as the 4wd low problem, ick.

Dec 22, 2008 | 2001 GMC Yukon XL

1 Answer

2001 gmc yukon xl 1500


Check to see if the power steering pump is still turning. If you have a broken drive belt (serpentine belt or "fan" belt), and the pump doesn't turn, you have no power assist. If the pump is still turning, check the fluid level in the reservoir.

Oct 31, 2008 | 2001 GMC Yukon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...