Question about 2001 Toyota Camry

1 Answer

Inertia shutoff switch - 2001 Toyota Camry

Posted by on

Ad

1 Answer

Only on a Ford Product--well known fact,
worldwide, for decades
Fuel Safety Shut Off ??

Posted on Jul 17, 2013

Testimonial: "does it have a inertia switch"

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I can't find my kill switch on my expedition 2003


Inertia Fuel Shutoff (IFS) Switch Removal and Installation
  1. Disconnect the battery ground cable. For additional information, refer to Section 414-01 .
  1. Remove the LH rear interior trim panel.
  1. Disconnect the inertia fuel shutoff (IFS) switch electrical connector.

Jul 11, 2015 | 2003 Ford Expedition

1 Answer

How do you turn the fuel pump shut off button back on a 99 Ford windstar


  • The inertia fuel shutoff switch is located behind the driver side scuff panel. An access hole is in the scuff panel to access and reset the fuel shutoff switch.
NOTE: In the reset position, the button can be pressed an additional 1.59 mm (0.0625 inch) against a spring. This is a normal condition.
To reset the inertia fuel shutoff switch , press button on top of inertia fuel shutoff switch .


saailer

Apr 16, 2015 | 1999 Ford Windstar

1 Answer

How do I troubleshoot the ford f150 fuel shutoff inertia switch?


need to ck for power at the inertia switch caming form relay

Sep 25, 2014 | 1998 Ford F150 Regular Cab

1 Answer

1998 3.8 has fire and 40 psi fuel pressure but will not syert


Hello! When you say does not start; Does the starter motor crank?...If the starter motor cranks the engine the anti-theft is clear...If such is the case, lets eliminate the Inertia Fuel Shut-off Switch...The inertia fuel shutoff switch is located on the LH side lower back panel in the luggage compartment and is manually reset...To reset the inertia fuel shutoff switch; press button on top...Send a comment...Guru...saailer

Feb 13, 2012 | 1998 Ford Mustang

1 Answer

No power to fuel pump or feul shutoff


Fuel shutoff? Are you talking abouty the inertia switch? Are you aware that you will only have power to the inertia switch and to the fuel pump for about 2 seconds when the ignition switch is turned from OFF to RUN? If you are checking for voltage here after that time, you are not SUPPOSED to find any.

If you are not getting any voltage there during the 2-second "fuel prime" cycle, then you need to check your fuel pump relay circuits. (Primary AND secondary)

Nov 15, 2011 | 1999 Ford Econoline

1 Answer

Where exactly is the inertia switch on a 99 mercury villager


go to villager-quest yahoo group for more help

Inertia Fuel Shutoff (IFS) Switch Removal
  1. Remove the LH scuff plate.
    gh2340a.gif
  1. Remove the LH lower A-pillar trim panel.
    gh2341a.gif
  1. Remove the inertia fuel shutoff (IFS) switch.
    1. Disconnect the electrical connector.
    1. Remove the screws.
    gv1421a.gif

Sep 30, 2011 | 2000 Mercury Villager

1 Answer

Wheres the reset button on a 1997 ford explorer thanks!!


The Inertia fuel shutoff switch (IFS switch) is in the top right corner of the passengers side carpet. It is below the dash but above the carpet in the right hand corner. The Inertia fuel shutoff switch (IFS switch) is number 1 in the following diagram, and the button to reset is on top of the switch:

pctech1_48.jpg

Mar 17, 2011 | 1997 Ford Explorer AWD

1 Answer

Turned of car, will not start it turns over, but doesn't seem to be getting any fuel


Try A SMALL SHOT Of Starting Fluid Sprayed into the Snorkel
Intake @ Air filter. If it Starts and Does NOT Run After Burning Starting Fluid the Fuel Pump Has Failed. (My Personal Hunch) is (FUEL PUMP FAILURE) BE SURE TO ELIMINATE THE INERCIA SWITCH< it is a fuel shut off switch >>>>> WARNING: Do not reset the inertia switch button if you see or smell fuel.

  1. Turn ignition switch to OFF.
  2. Check for leaking fuel in the engine compartment, fuel lines and fuel tank.
  3. If no fuel is apparent, reset the inertia fuel shutoff switch by pushing the reset button on top of switch.
  4. Turn ignition switch to START for a few seconds, then to OFF.
  5. Again, check for leaking fuel.
LOCATION


  1. Open luggage compartment door.
  2. Remove two screws retaining inertia fuel shutoff switch.
  3. Disconnect wiring harness connector from inertia fuel shutoff switch and remove inertia fuel shutoff switch.
  4. To install, reverse removal procedure.

Aug 17, 2010 | 1996 Mercury Cougar XR7

Not finding what you are looking for?
2001 Toyota Camry Logo

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8265 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...