Question about Cars & Trucks

Open Question

Cost to replace 1997 honda crv fuel line

Fuel leaking near rear wheels.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: leaking brake line

I end to fix it on my way i bough universal brake steel tube and one connector and i disconnect from the rubber flex pipe and cut flash the old pipe one foot from front before fuel tank where old pipe still in good shape i put connector between old pipe and new pipe on back end i put regular universal tube fitting.
works good .

Posted on Aug 29, 2008

SOURCE: Repair/Replace 1994 Isuzu Rodeo Fuel Line

Is the line plastic or steel? They make repair kits for plastic lines, if you can find them. They are hard to find. If it is a steel line, you can go to the parts store and buy a pressure fitting. Cut the line and put the pressure fitting on. If it is the end of the lines, where they hook together or hook to fuel filter, it could be bad O-rings. Need more info.

Posted on Nov 19, 2008

shocktroop40
  • 155 Answers

SOURCE: Replace a fuel pump on a 1993 Chrysler Fifth Avenue

It sounds like a fuel line broke, most likely because it rusted through. The fuel pump is running otherwise you wouldnt see any fuel spewing out from under the car. Get under the car and see where the line broke. In most cases, you can replace the broken section of line and it will be fine.
To answer your question though, to replace the fuel pump, you will need to remove the fuel tank from the car, as the pump is attached to the sending unit inside the tank. To remove the tank, you will need to disconnect the fuel filler neck, the fuel lines, and unplug the electrical connector, then get a jack under the tank and remove the straps holding the tank in the car. Lower the jack and you will be able to access the top of the tank where the sending unit is located. Romove the lock ring holding it in, and remove it from the tank.

Posted on Nov 21, 2009

Testimonial: "Got exactly the information I suspected was my problem."

  • 2002 Answers

SOURCE: need diagram of fuel system for 1995 chevy s10

The only way I know of to get the diagram you are looking for is to acquire a "build book". Even dealer service manuals don't have this diagram. I got one from faxonautoliterature for $49 plus shipping. A better bet would be to find a spot on either end of the leak where you can work on it easily and work from there. Hope this helps.

Posted on Dec 02, 2009

  • 96 Answers

SOURCE: where is the fuel filter located honda crv 2002

normally for honda it should be located to the firewall close to the battery...

Posted on Jun 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ford probe 1994 gas slowly leaks out the drivers side close to the wheel


Justin, The gas leak is probably a rusted out fuel line, the location you pointed out is one of the first places fuel lines deteriorate and leak. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Fuel leak near rear driver side tire Chevy Cobalt Forum Cobalt Reviews...
Fuel line leak DIY replacement options don want to burn up my Olds...
How to Fix Leaking Fuel Lines eHow

May 13, 2016 | Ford Cars & Trucks

1 Answer

My honda crv B20B engine of 1996 fails to start at first attempt but will start at third try also drags at rear wheels when turning either side


Maybe the fuel cut relay, or fuel pump? For the dragging, if it is all wheel drive then try replacing the rear differential fluid, make sure it is genuine Honda Dual Pump fluid.

May 29, 2015 | Honda CR-V Cars & Trucks

1 Answer

Where is the location of a fuel filter on a honda crv 2004?


The 2004 CRV doesn't have a stand alone in line fuel filter, most manufacturers have gone away from that, the filtering is done by the fine mesh nylon strainer screen which serves the same purpose of filtering the fuel, this screen is located at the inlet to the electric fuel pump, the fuel pump is located inside the fuel tank. The screen is replaceable, it cost less than $10.00. Here is a picture of the part.


emissionwiz_222.jpg

Sep 13, 2011 | 2004 Honda CR-V

3 Answers

Where is the fuel filter located honda crv 2002


normally for honda it should be located to the firewall close to the battery...

Jun 12, 2010 | 2002 Honda CR-V

1 Answer

How do you replace the fuel pump on a 1993 hondalx


If your engine has a carbuerator, then these are the steps:

Externally Mounted Fuel Pump
  1. Disconnect the negative battery cable.
  2. Remove the gas filler cap to relieve any excess pressure in the system.
  3. Loosen the lug nuts of the left rear wheel.
  4. Elevate the rear of the car and support it safely on properly placed stands. Remove the left rear wheel.
  5. Use a pair of suitable fuel line clamps to pinch shut the fuel hoses leading to and from the pump.


9a57f69.gif

  1. Disconnect the positive lead wire and ground wire from the pump.
  2. Remove the fuel pump retaining bolts, taking care not to lose the spacers and bolt collars.
  3. Remove the fuel pump and its protective cover as a unit.
The pump cannot be disassembled and must be replaced if defective.
To install:
  1. Install the fuel pump and cover. Make certain the mounting collars and insulators are in the proper location. Tighten the mounting bolts to 7 ft. lbs. (10 Nm).
  2. Engage the wiring to the fuel pump.
  3. Connect the fuel hoses, making certain the lines are correctly placed and the clamps are secure. When in doubt, use new clamps; they are cheap insurance against leaks. Remove the fuel line clamps.
  4. Install the left rear wheel. Lower the car to the ground.
  5. Install the fuel filler cap. Connect the negative battery cable.
  6. Turn the ignition ON for 3 seconds, listening for the fuel pump operation. Switch the ignition OFF, then ON again. This will build pressure within the fuel lines.
  7. Start the engine. It may crank for several seconds until the lines are completely filled.

May 09, 2010 | 1993 Honda Accord

1 Answer

Where is fuel filter on 1997 Volvo 850 T-5


The fuel filter is located on the passenger side near the rear wheel well, just in front of the rear axle, around 60cm in front of the fuel tank. Look for the fuel lines running underneath the car. The filter is around 12-13cm in length and around 7cm in diameter, probably covered in road grime,

Nov 27, 2009 | 1997 Volvo 850

3 Answers

Honda 97 crv engine turns off while driving, and hard to


, pull a plug wire and ground it to the engine body and check for spark. if spark then
check your fuel system pressure, fuel pump

Aug 28, 2009 | 1997 Honda CR-V

3 Answers

1997 honda crv growling noise from rear wheels


from a local tyre and honda dealers, a growing noise at the back were caused by tyres profiles. According to them, CRV's come standards with certain brand ( Goodyear i think) and with certain size and certain profiles, so if you have got different ones at the back, it would create that noise. I've got myself honda crv 2005. hope its helpful.

Jun 17, 2009 | 1997 Honda CR-V

1 Answer

Basic service


Here are detailed instructions on the location, removal, and re-installation of your fuel filter. Hope it helps and have a great day!

REMOVAL & INSTALLATION
Carbureted Engines
These vehicles use two replaceable fuel filters. A small one is in the fuel line under the hood; a larger one is located at the rear, just inboard of the left rear wheel.
Whenever the filter(s) are replaced, take great care to avoid the entry of dirt into the lines. Also, pay attention to the correct installation position. It is possible to install the filter backwards.
FRONT
See Figure 2
  1. If applicable, disengage the filter or hose from its retaining clip.
  2. Using two fuel line clamps, pinch off both fuel lines. Take care not to crush the lines; just clamp them shut.
If the fuel hoses are hard or cracked, it is necessary to replace them.
0900c1528005f267.jpgFig. 2: Front fuel filter used on carbureted engines
  1. Loosen the fuel line clamps and slide them back.
  2. Using a twisting motion, remove the fuel lines from the filter.
  3. To install, use a new fuel filter and reverse the removal procedures. Start the engine and check for leaks. Correct any leaks immediately.
REAR
See Figures 3, 4, 5 and 6
  1. Raise and safely support the rear of the vehicle. Remove the left rear wheel.
  2. Remove the bolts securing the filter and its basket to the fuel tank.
0900c1528005f268.jpgFig. 3: Remove the bolts securing the filter and its basket to the fuel tank ...
  1. Push the fuel filter retaining tab and release it from the basket.
0900c1528005f269.jpgFig. 4: ... then release the basket from the filter
  1. Using two fuel line clamps, pinch off both fuel lines. Take care not to crush the lines; just clamp them shut.
0900c1528005f26a.jpgFig. 5: Clamp the fuel lines shut. If the lines are hard, cracked or brittle, they must be replacedIf the fuel hoses are hard or cracked, it is necessary to replace them.
  1. Loosen the fuel line clamps and slide them back.
  2. Using a twisting motion, pull the fuel lines from the fuel filter; remove the filter.
0900c1528005f26b.jpgFig. 6: After sliding the retaining clamps back, the filter can be removed from the linesTo install:
  1. Use a new filter and reverse the removal procedures.
  2. Make certain the retaining tabs are engaged when the filter is installed in the holder. Tighten the bolts until snug.
  3. Install the left rear wheel. Lower the car to the ground.
  4. Start the engine and check for leaks. Correct any leaks immediately.
Fuel Injected Engines
See Figures 7, 8, 9, 10, 11 and 12
The canister fuel filter is located in the engine compartment. When buying the new filter, also buy new washers for the banjo bolts and the service bolt. Failure to replace these washers invites high-pressure fuel leaks. Replacing the washers is required, not recommended.
  1. Disconnect the negative battery terminal.
  2. The fuel system is under pressure. Release pressure slowly and contain spillage. Observe "no smoking/no open flame" precautions. Have a Class B-C (dry powder) fire extinguisher within arm's reach at all times.
  3. Disconnect the banjo bolts and/or threaded fuel line fitting from the fuel filter. Use of a flare nut or line wrench is recommended for disconnecting and attaching this fitting.
0900c1528005f26c.jpgFig. 7: Fuel filter used on fuel injected Accords through 1989 0900c1528005f26d.jpgFig. 8: Fuel filter on 1990-93 fuel injected Accords 0900c1528005f26e.jpgFig. 9: Fuel filter used on fuel injected Preludes through 1991
  1. Loosen the fuel filter clamp bolt, then remove the filter.
To install:
  1. Install the new filter and secure the clamp bolt.
  2. The upper and lower washers on each banjo bolt and the washer on the service bolt MUST be replaced whenever the bolts are loosened. Install the washers and banjo bolts. Tighten the banjo bolts to 16 ft. lbs. (22 Nm) on all models except 1992-95 Preludes. On these models, tighten the bolt to 20 ft. lbs. (28 Nm). If applicable, tighten the threaded fuel line fitting to 27 ft. lbs. (37 Nm).
0900c1528005f26f.jpgFig. 10: Fuel filter used on 1992-95 Preludes 0900c1528005f270.jpgFig. 11: Fuel filter used on 1994-95 4-cylinder AccordsIt will be necessary to use a crow's foot attachment on a torque wrench to properly tighten the threaded fuel line fitting.
  1. Tighten the service bolt to 9 ft. lbs. (12 Nm).
  2. Start the engine and check for leaks. The engine may crank longer than normal until full fuel pressure is developed. Correct any leaks immediately.
0900c1528005f271.jpgFig. 12: V-6 Accord fuel filter

Nov 23, 2008 | 1985 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...