HEATER FAN DOES NOT RUN. HOW CAN I CHANGE THE HEATER FAN OR IS IT THE MOTOR. DOES RUN FOR A WHILE WHEN I HIT THE DASH.
I would venture to say that if you hit the dash and the motor started running then the problem would be in the heater control assembly mounted in the dash, like bad wire to Heater switch connection. A bad connection can jenerate a lot of heat and start melting things unless you find the problem soon enough. The switch may already be damaged inspect switches and wireing for any vissible damage and replace as required. However if everything looks ok with the heater control assembly, Their are a few more things you can check to be sure of before relpacing the heater blower motor. Turn the heater controles to the high heat and fan on high as well, settings and remove the heater blower motor pig tail and check to see if power is getting to the motor,( use a 12 volt test light at the wire harness side of this connection ) also check for power going to and leaving the blower motor resistor assembly ( mounted to the side or top of the blower motor housing ). If so equipped. If you find no power getting to the motor at this point then you will half to start working your way back through the wireing towords the heater controles until you find the problem. Using your test light. Now if you did have power going to the motor then replace the motor. Good Luck From Ernie @ RedDeer, Alberta, Canada.
Jan 10, 2011 |
2004 Buick LeSabre