Question about Cars & Trucks

1 Answer

2004 BMW, where is the traction control sensor?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 1,975 Answers

Need to know the model of the BMW before I can try and help...

Posted on Jul 17, 2013

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

jeffsterrett
  • 98 Answers

SOURCE: 90 104 on bmw x5 4.4i sport

90 is an 'Intermittent System Down' code, meaning the system isn't always staying online.

104 should be a right-rear (passenger) wheel speed sensor failure. If a sensor fails the system shuts itself down, so this is likely what's causing the first code.

How did you test your ABS sensors? They normally should be checked for resistance to be within specifications and they also need to have the waveform checked on a graphing meter or have one person check the sensor signals with an appropriate scan tool while another person is driving.

Also check the tone ring (notched ring the sensor reads) for broken/missing teeth and check the wheel bearing for play, as both of these can disrupt the readings, even if the sensor itself is good.

Hope this was helpful to you.

Jeff

Posted on Oct 23, 2011

bunnydawg
  • 5158 Answers

SOURCE: traction control

and more fun too... should be a relay and or fuse in the fuse panel that's located in the engine compartment near the battery... as i've learned bmw also likes to hide a fuse panel in the trunk... locate the fuse/relay three and pull it.... make sure your abs and other things work and enjoy the snow.

Robert

Please take a moment and rate this solution.. thanks

Posted on Jan 24, 2009

  • 1071 Answers

SOURCE: bmw 530i 2001 abs and traction control light on

abs control module is bad

Posted on Aug 19, 2009

Testimonial: "thanks how much is an abs module cost and is it necessary to fix right away"

  • 1 Answer

SOURCE: 2004 grand prix no go with traction control light on.

My car is doing exact same thing! I flushed radiator and now I have traction control light, reduce engine power, and enigine light coming on! My car sounds like **** and won't idle and no power! 04 prix gt of course. It was fine until I flushed radiator and put new thermostat in! What do I do?

Posted on Sep 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Does the wheel sensor causes the ABS DSC to stop working?


Yes wheel speed sensors are tied into the interface with abs and driver stability controls or other lay known as traction control

Mar 28, 2017 | BMW Cars & Trucks

1 Answer

Traction control


run fault codes to find out which sensors are faulty. The ABS system use the same sensors so it may not be the traction control at all.. Repair what is faulty and then reset the CPU using the code reader.

Nov 10, 2013 | 1998 BMW 318ti Compact

1 Answer

Where are the sensors on the 2004 pontiac grand prix rotors


the abs sensor is in the frnt wheel bearing hub,and the traction control sensor is in the transmission

Jan 01, 2013 | 2004 Pontiac Grand Prix

1 Answer

Dsc warning light on , bmw e46


Dynamic Stability Control....a derivitave of ABS / Traction control. The control unit that monitors the dynamics will most likely be sensing a difference in the measured wheel speeds. Possibly defective ABS sensor, wiring, ABS exciter ring, ABS module or steering angle sensor. Can also be triggered by wheel spin.
Have a diagnostic scan done ( cost £30 - £50 approx at good local garage) to read the fault codes first. If you get a fault code relating to "ABS module pressure sensor" the module requires replacement (common issue). Used to be a £1400 job, but repair kit now available from dealer for £180 ish and 2 hours to fit.

Apr 27, 2011 | 2004 BMW 3 Series

2 Answers

Luck off power trasmission safe mode cames on code p0720


p0720 is usually a speed sensor. Newer BMWs have a speed sensor at each wheel, which also sends information to your traction control. If one of the sensors is giving a wrong reading, the vehicle thinks you are losing traction and it cuts power.
If you need further assistance, please let me know. I will need your vehicle year and model.

Mar 27, 2011 | BMW 750 Cars & Trucks

1 Answer

Traction control light comes on letting me no that I have an emissions control problem. Is my O2 sensor beginning to fail @ 115,000 miles it starts running rough and looses power


your dumb
what the **** your traction control light comes on to tell you you have low traction or a traction control malfucntion not a emissions problem where do peoplee get all this dumb information

Nov 04, 2010 | 2004 Honda Accord

1 Answer

Have bmw dtc of 5D66 looking for an explanation of what is involved


DTC - Dynamic Traction Control is it system takes care of that order, for example in winter into the snow when you need fast acceleration, wheels without DTC rotate,and traction is no good! DTC via the ABS sensors to monitor the movement of each wheel identifies the situation when: front-wheel stands, but the back spining = traction is poor and corrects output from engine, gearbox, braking and traction conditions that were ideal for smooth start!

May 06, 2010 | 2006 BMW 750Li

1 Answer

How to switch traction control off on a 2002 bmw 320d


When is ASC button - press to off traction , end warning control of traction lighting.
When is DSC button - pres and hold 5seconds. warning control of traction lighting.

Mar 22, 2010 | 2002 BMW 3 Series

1 Answer

Speedo suddenly not working and two warning lights appeared on dashboard one being ABS light warning light.


If the ABS (and likely the traction control) light came on at the same time that the speedometer stopped working, you likely have a faulty wheel speed sensor at the right rear wheel. You can test this by swapping the two rear wheel speed sensors (ABS sensors). If the speedometer then works (but the ABS & Traction control lights stay on), replace the sensor that is now at the left rear (was at the right rear). If no change, you may have a fault in the ABS & Traction control - control unit.

Rear wheel speed sensor at www.bavauto.com

http://www.bavauto.com/shop.asp?HC1=0&Htarget=search.asp&HCY=2001&HCM=330i&SearchStr=rear%20abs%20sensor

Nov 22, 2009 | 2001 BMW 330

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...