Question about Cars & Trucks

Open Question

Nissan sani 2.4 engine. Is the fuel in the tank

My nissan sani cut off with no fuel supply.What can be the fault.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 9 Answers

SOURCE: 1996 nissan altima engine stalls when going uphill

If you recently replaced the battery, you may need to reset the idle air control valve setting. This is done by removing the NEGATIVE battery wire from the battery while the vehicle is HOT. Then you must wait several hours for the vehicle engine to become cold. Next, once could, reconnect the negative cable. Start the vehicle, place your foot on the brake and imediately put the vehicle in drive. Stay in that situation until the vehicle engine bcomes hot to normal temperature range. This will be known by hearing the radiator cooling fan turning on. You must NOT use the airconditioner during this cause it will be on during the event. Once accomlplished place in park and allow the engine to cool, engine off. This resets the engine computer to tell the idle/load speed control valve to add air and resuling in additional fuel to the engine under various torque loads.

Posted on Jul 22, 2009

Ad
  • 10 Answers

SOURCE: looking for fuel pumps on 1985 nissan maxima

CHANCES ARE THE MOTOR IS NO GOOD IF IT WAS RUN WITH SUGAR IN IT BUT IF IT DID NOT GET TO THE ENGINE CLEAN OUT YOUR GAS TANK AND LINES CHANGE THE GAS FILTER AGAIN YOU MAYBE OK

Posted on Jul 27, 2009

  • 237 Answers

SOURCE: 2005 Nissan Altima service engine

one thing you can bet the house on ....if a nissan sets a cat converter code...it needs a cat converter...trust me on this.in the last 10 yrs. as nissan master tech i have seen no other cause!

Posted on Mar 18, 2011

  • 90 Answers

SOURCE: colorado 2005 3.5l start

If this problem only occurs after shutdown when hot, check temperature sending unit. This is usually first thing to prevent starting until engine is completely cooled down.

Posted on Jul 14, 2011

  • 318 Answers

SOURCE: engine starts from cold but after five mins ticking over it cuts out ,fuel going throu ok .

make and model?

Posted on Dec 10, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Engine cut off while driving down the highway why?


Fuel pump may be failing. Check fuel pressure at injector rail. If pressure is good and stays good, suspect fuel pump relay may be getting weak.

Aug 06, 2017 | Nissan Cars & Trucks

1 Answer

I have nissan np300 zd30 engine its nt supplying fuel t e engine,have t prime harder for it to starter n after starting,if l stop priming t wl cut off.what cld b e problem


?? depending on year ,,,it could have a lift fuel pump in the tank to prime it up for starting ,providing its a conventional injector pump which having a hand primer i would assume it has ,need more info really but do check the fuel lines on the top of the fuel tank as they could be perished so its sucking in air ...or the lift pump inside the injector pump has failed ,really need to see it to know the problem .

Jan 23, 2016 | Nissan Cars & Trucks

1 Answer

My 2005 Nissan Altima 3.5 is idling at 800 rpm's, and my service engine soon light came on. The code read for a Chrysler? P1283, and Fuel pump module detected an incorrect low idle, low idle select...


Make sure you are looking up the code properly. 1283 for Nissan indicates a lean condition on bank 2. See link below. A vacuum leak is likely, but make sure the new sensor is recalibrated. Did you perform the relearn procedure after replacing the sensor? If not, see the second link below. If you ran the relearn procedure and cleared all codes but 1283 comes back, look for a loose vacuum line or leaky intake manifold gaskets. P1283 Nissan Air Fuel Ratio Sensor 1 Lean Shift Monitoring Bank 2 1998 2012 Nissan Altima Clear Mixture Ratio Self Learning Control Data

Jun 21, 2017 | Cars & Trucks

1 Answer

My 2005 nissan altima 3.5 is idling at 800 rpm's, and my service engine soon light came on. The code read for a Chrysler? P1283, and Fuel pump module detected an incorrect low idle, low idle select...


What does a Chrysler product have to do with this fault code, please explain. The meaning of the code is that bank 1 O2 sensor is defective.

Jun 21, 2017 | 2005 Nissan Altima 3.5

2 Answers

01 Nissan Altima cuts off at red lights


Hi Nichelle, Take the vehicle for a diagnostic scan. If the engine sounds smooth and is running well, I do not believe you need an new engine. What is more likely is a defective fuel pump or fuel regulator. A very common fault on Nissans is the mass air flow sensor, which sounds as if it is the problem with your vehicle. Regards John

Oct 24, 2012 | 2001 Nissan Altima

1 Answer

Engine warning light comes on and engine goes limp. Missfires and comes back to life. Registered fault code is 77p7-f/inj timing fdbk. Thinking its the timing solonoid. Any ideas


on nissan terrano diesel: had a fault cose 77 and a white smoke, no power. i changed the fuel filter and cleaned the fuel line from the tank to the fuel filter. it solve the problem.

Dec 07, 2011 | Nissan Cars & Trucks

1 Answer

Looking for fuel pumps on 1985 nissan maxima


CHANCES ARE THE MOTOR IS NO GOOD IF IT WAS RUN WITH SUGAR IN IT BUT IF IT DID NOT GET TO THE ENGINE CLEAN OUT YOUR GAS TANK AND LINES CHANGE THE GAS FILTER AGAIN YOU MAYBE OK

Jul 27, 2009 | 1985 Nissan Maxima

1 Answer

Citroen picasso keeps cutting out twice a week on acceleration


Sounds like an air leak or the tank pump cannot keep up with demand (the supply pump in tanks do give trouble (a pressure gauge between tank and engine would tell, make sure it is visable when driving, I used to tape it to the bonnet with masking tape.

Jun 23, 2009 | 1987 Peugeot Liberte

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...