Question about 2008 Chevrolet HHR 2.4

Open Question

Can you tell me where the overdrive solenoid is for hhr

Shifts perfect through all gears and reverse, but no overdrive at all.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
shaggyrat
  • 1224 Answers

SOURCE: 2003 chevy silverado will not shift into drive or overdrive.

transmission shift solenoid is stuck open this is a common vehicle issue in automatics and not particular to any make or model vehicle 15 dollar part and arm and leg for labor if taken in

heres an idea to try
take out the transmission filter and replace with new one make sure to take not of any metal debry in trans pan this indicates the trans had sheered its gears down and a trans rebuild is needed
the transfilter needs to be changed at a certain milage interval they can get clogged up
there is a kit you buy for your truck at any parts store
its an easy change hour of time unbolt trans pan unbolt trans filter and put new one in
kit comes with new seals less than an hour you can do it yourself

to overdrive you would feel a difference in shift badley if it was that something to keep in mind

Posted on Dec 06, 2008

Ad
  • 58 Answers

SOURCE: not shfiting right

eric sounds like you have a electronic trans mission or computer controled trans.is the check engine light on ?

second it sounds like your trans is in limp in mode ( only has second gear).

the hard shifts is not good news.

somtimes when the controller sets a code that forces limp in it has to be cleared.

dis-connect the battery for a few min. then try it again see if it shifts but be easy on it and make sure fluid level is good.

if it it still messes up CHA CHING hehe i'll fix it fer 1000 bucks

Posted on Jan 27, 2009

Charlie1221
  • 61 Answers

SOURCE: 1996 3500 TRUCK WON'T SHIFT OUT OF SECOND INTO 3RD OR OVERDRIVE

Their are a few possible causes of this. One their is not enough tranny fluid in it or the kick down cable is not hooked up properly. the kick down cable also runs the vacume to the transmission.

Check theese and give me feed back to further assist you.

Thanks, Charlie

Posted on Jan 30, 2009

  • 2 Answers

SOURCE: Stopped shifting

Happened to mine ,, Simple solution : Take it to transmission maintenance,, they clean up the mesh and fresh fluid,, will shift properly, will run like new.

Posted on Mar 16, 2009

  • 37 Answers

SOURCE: My 4L60E transmission will not shift into reverse or overdrive.

Needs rebuilt... www.TransmissionGarage.com

Posted on Dec 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is overdrive light flashing orange when the car warms up and has been driven for about 8 miles?


/D OFF Indicator The instrument cluster receives the O/D OFF indicator status from the PCM over the communication network. When the overdrive function is turned off, the PCM sends a command to the instrument cluster to turn on the O/D OFF indicator. When a powertrain concern exists, the O/D OFF indicator flashes amber and illuminates green when overdrive is selected off. What code ? you said solenoid A -
P0750 SSA SSA Solenoid Circuit Failure SSA circuit failed to provide voltage drop across solenoid. Circuit open or shorted or PCM driver failure during on-board diagnostic. No reverse gear (short) or no 4th gear (open). MIL on. Go To Pinpoint Test A . P0751 SSA SSA Functional Failure (Stuck Off) Mechanical or hydraulic failure of the shift solenoid. Not all gears present, MIL on. Refer to Diagnosis By Symptom . P0752 SSA SSA Functional Failure (Stuck On) Mechanical or hydraulic failure of the shift solenoid. Not all gears present, MIL on. Refer to Diagnosis By Symptom . P0753 SSA SSA Solenoid Circuit Failure SSA circuit failed to provide voltage drop across solenoid. Circuit open or shorted or PCM driver failure during on-board diagnostic. No reverse gear (short) or no 4th gear (open). MIL off. Go To Pinpoint Test A . Could be a wiring problem . Did you check the solenoid A wiring circuit back to the PCM ?

Dec 30, 2015 | 2007 Ford Focus 2.0

2 Answers

Shifting problems 02 Dodge Durango 46re


shift solenoid needs to be replaced or the speed sensor

Oct 18, 2012 | 2002 Dodge Durango

1 Answer

Where is the overdrive solenoid located on my 2001 Buick park avenue? I have the transmission pan off , can i put that back on and still put the solenoid? i would like a diagram of where it is located


You will need to pull off the side pan cover thats where the overdrive solenoid is located, lets see if i can get you a diagram to help you loacte it.i will tell you that there are two shift solenoid to control the gears and overdrive, there have been problems with jerking in overdrive this is due to the tcc solenoid and wiring harness and also the computer must be reflashed, dealer has update shifting and thats a must, i would replace that as far as the overdrive solenoid here are diagrams. the computer uses the shift solenoid with the pressure solenoid to control the overdrive i have circled the solenoid to replace , as theres not just one to control overdrive i have listed the one that control it .hope this helps.johnjohn2_161.gifjohnjohn2_162.gifjohnjohn2_163.gif

Sep 24, 2011 | 2001 Buick Park Avenue

1 Answer

I have a 1999 GMC K1500 4X4 SUBURBAN WITH A 5.7 liter engine. Problem is that it won't shift into Overdrive. Replaced both of the Speed Sensors that are located above the transmission and still only get...


overdrive servo/ solenoid is not operational , either from failed unit or wiring problem
check transmission actuator for operation or adjustment as well

Jul 06, 2017 | GMC K1500 Cars & Trucks

1 Answer

My 2001 buick regal ls, will no longer shift into overdrive. all other gears are perfect.tune up, fluid and filter changed and still the same.


I believe that the solenoid that controls the overdrive is accessable from the transmission pan area. The solenoids that control the shifting are located in the side. The 4t65e transaxle has been known to have problems with overdrive for more than one reason though, so start with that solenoid. If that doesn't work, you may have luck with a shift kit. My car used to shift rapidly in and out of overdrive, after I installed a shift kit, I have had no further issues. I used the '4t65e sk' kit from TransGO.

Dec 25, 2010 | 2001 Buick Regal

3 Answers

The car will not shift into overdrive? All other gears work perfect? The problem just started tonight on my way home from my sisters. I got on the expressway accelerated up to 70mph and it just stayed in...


There should be an electric solenoid on the side of the transmission that controls overdrive, if it is not the cause then the friction plates inside the transmission will need to be replaced.

Apr 05, 2010 | 2000 Pontiac Grand Prix

2 Answers

95 GMC Sierra 4L60E will not shift down to 1st or up to 4th.


no power stuck in 3rd gear electric shop unless youve burnt it up good luck...www.TransmissionGarage.com

Jan 28, 2009 | 1995 GMC Sierra

2 Answers

2000 es300 lexus auto w overdrive button overdrive 4th gear not work


There isn't anything wrong with your car. This is perfectly normal. I have a 2000 ES300 as well as other people that I know and it operates in the same way. Overdrive doesn't mean the same thing for every car or transmission. In our case overdrive is simply a reference to the top gear which is 4th gear. When you switch overdrive off(which is depressing the button causing the O/D OFF dash light to illuminate,) the highest gear becomes 3rd because you turned 4th gear or overdrive off. The application scenario for this is usually mountainous terrain where a lot of uphill driving makes it more feasible not to up shift into 4th gear while ascending and descending. It will not switch back to overdrive or 4th gear until you re-engage it by turning the overdrive back on or repressing the button. Again, when the O/D OFF dash light is illuminated, overdrive which is 4th gear is off and the highest gear will then become 3rd. It will never shift into 4th gear while this light is illuminated or overdrive is off. When you press the button and the O/D OFF dash light is NOT illuminated overdrive is on and therefore it will shift into 4th gear as usual. This applies to all 97-2001 ES300's and probably any other car you drive tat exhibits this same type of change when overdrive is turned off.

Nov 20, 2008 | 2000 Lexus ES 300

Not finding what you are looking for?
2008 Chevrolet HHR 2.4 Logo

Related Topics:

497 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...