Question about Cars & Trucks

Open Question

P0264 I have a 1997 Subaru legacy outback 2.5 engine what does this code mean p0264

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 1997 subaru outback legacy overheating

I've had the same problem all year. I've had four different mechanics look at this car - 97 legacy with 2.5. I've had the coolant seals replaced, the radiator cap, the thermostat, the water pump - all to no avail. I've realized now that it only overheats shortly after running sustained high rpm's. Recently the last mechanic mentioned the bleeder valve (I didn't know it had one and think maybe he didn't know either - not a subaru mechanic). Recently it overheated again (again sustained high rpm's - apparently more prone to produce air in the system), I sat the vehicle on an incline (raising the bleeder valve to be the highest point) and let the car warm up and run for half an hour. Now 300 miles and no overheat. I went through alot with this car to get to this point. Unbelievable.

Posted on Dec 26, 2008

bunnydawg
  • 5158 Answers

SOURCE: Subaru Outback - '03 boxer 2.5L engine sounds like a diesel

heavier oil if you are not in a cold climate. but before you do that have the oil pressure checked. We used to use a can of STP every once in a while on a motor in a dodge we had... nothing wrong with it... was just noisy.

Robert

Posted on Feb 05, 2009

mcgyver468
  • 710 Answers

SOURCE: Cause of noise in front differential of 1997 Subaru Legacy Outback.

there is a plug on the shaft-side of the differential. Using a ratchet remove the plug and with the engine OFF, stick your finger inside the hole and you should get fluid just below the threads of where the plug goes in.

Posted on Apr 24, 2009

mx5turbo92
  • 545 Answers

SOURCE: i have a subaru legacy outback, abs light comes on

one of your abs sensor is bad or the abs motor,go to local shop to diagnose which sensor,shop usually charge $ 60 to diagnose abs system,good luck, let me know ..

Posted on Jun 04, 2009

  • 1 Answer

SOURCE: I have a 1997 subaru outback legacy getting a

There is a tube that connects to the EGR valve that gets blocked up-take it off and clean it out

Posted on Oct 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is a rear diff from a 1997 subaru legacy wagen with a 2.2l inter changeable with a 1997 subaru legacy outback with a 2.5l ?


the only way you can do this is if you can identify the gear ratios from both cars with the transmission codes found on the strut tower plate.
see this list to check for matches, read it carefully its a ton of info
subarugears narod ru

Aug 09, 2014 | 1997 Subaru Legacy

3 Answers

Timing belt broke and need timing marks diagram 2.2 subaru


the timing marks are on the camshaft pulleys and there are 2 notches on each pulley> they line up with 2 marks on the engine block for each pulley> and the crankshaft has a notch that lines up with a mark on the engine block aswell> pluss the new timing belt will have white marks on it that will line up with all of the marks on the pulleys when they are in the right place so its nearly impossable to do it wrong

Apr 07, 2010 | 1997 Subaru Legacy

1 Answer

How do I reset the ''check engine'' light on my 1997 Subaru Legacy Outback wagon?


the check engine light comes on if there is a problem with thecomputer system related to the emmision, when this is is repaired the light on can only be turned off with a monitor,code reader. some of these are quite inexpensive.over the web or at a part store.

Feb 19, 2010 | 1997 Subaru Legacy

1 Answer

1998 Subaru Legacy Outback--Rough Idle


I have the same problem!Running on three.I have checked compression,wires,plugs.Changed injecters,plugs.
3 mech.cant figuire it out???

Nov 21, 2009 | 1998 Subaru Legacy

1 Answer

How do get codes for 2001 outback? Is


Hi,
I'm not sure if you're asking how to obtain the codes, or what the codes mean...
I hope this link is of assistance to you.

http://www.engine-light-help.com/subaru-check-engine-light.html

Aug 27, 2009 | 2001 Subaru Legacy

1 Answer

'99 subaru legacy gets 2 flashes from LED and


try opening door and holding unlock button ,it sounds like its in valet mode

Jun 15, 2009 | 2001 Subaru Outback

1 Answer

On my 2005 subaru legacy outback 2.5l replaced passenger side cv axle. now while driving the vehicle i come to a stop light or stop sign foot on brake pedal engine makes cavitating noise and feel the...


If I understand you correctly, you feel a vibration it the brake pedal when you apply the brakes. Is that correct?
Have your brake rotors re surfaced; they are warped.

"engine makes cavitating noise" ....what does this mean?

Apr 21, 2009 | 2005 Subaru Outback

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...