1994 Toyota Pickup Logo

Related Topics:

A
Anonymous Posted on Jul 15, 2013

What is code 43 and code 12 on a 1994 Toyota 22re 4 cyl

5 Related Answers

motor1258

Mike Butler

  • 6674 Answers
  • Posted on Jan 21, 2009

SOURCE: Correct Firing Order for 1994 Toyota Camry 2.2L 4 cyl.

1-3-4-2

Ad
motor1258

Mike Butler

  • 6674 Answers
  • Posted on Jan 24, 2009

SOURCE: OBD code 0401 (1997 Toyota Camry 4 cyl)

There is a VSV (vacuum switching valve) , usually mounted on the back side of engine block, under the intake manifold, as well as the map sensor, that can also cause that code if one or the other is faulty. It takes some pretty detailed troubleshooting to confirm this in some cases, so if that's not in your line of work, you may have to have it properly diagnosed, or take a 50/50 shot at which one first.

Anonymous

  • 2 Answers
  • Posted on Mar 15, 2009

SOURCE: Irratic Idle

sound like your mash air flow sensor is gone on the tp sensor i had the same problem with mine

Michael Gutwein

  • 104 Answers
  • Posted on Apr 29, 2009

SOURCE: Help Me With 92 Toyota Camry LE 4 cyl...

should be a 14mm drain plug on the oil pan. you remove that until no more oil comes out. then put drain plug back in. it should be the only 14mm bolt on the bottom of the pan. then you will have a oil filter below the exhaust manifolds than needs to unscrew. replace with a new one. then fill your engine with 1 gallon or 4 quarts of oil.(same thing) thats all you should need.

i dont know but if you learngin how to work on cars thats a nice car to learn on. it pays off to repair your own car in the long run. you save so much money. :) GOOD LUCK!

good luck,
Michael

Anonymous

  • 1206 Answers
  • Posted on Jan 26, 2010

SOURCE: 2004 Toyota Camry 4 cyl automatic. What mileage 85000

80 thousand miles is the best, any more you are risking damage to your engine.

Testimonial: "Fast answer. Thanks"

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

What colors are the iat sensor wires on a 1990 toyota 22re

If you mean the intake air temp sensor, I'm not showing it being used on a 4 cyl pickup truck that uses a Mass Air Flow meter.
The models that use a sensor have a brown wire for power and a yellow black wire for the signal back to the computer.
0helpful
1answer

93' toyota pickup 4wd 4 cylinders 22re, sputters when given throttle

Low fuel pressure can cause this or a clogged filter, has the fuel pressure been checked? Has the fuel filter ever been changed?
0helpful
1answer

1985 toyota motor home. 4 cyl. 22re engine. goes slowly into reverse when transmission is cold, but when it warms up, it wont go into reverse. If I give it more gas, it will sometimes catch briefly, but...

Change the fluid and filter. If i remember correctly reverse and third gear share the same band and clutch pack. Some transmissions you could tighten the band on it.
1helpful
1answer

WHAT IS THE TORQUE ON THE HEAD FOR 94 TOYOTA PICK UP ITS A 4 CYL 2.4 22R

Here's the manual's engine section for the 22RE:

http://www.ncttora.com/fsm/1993/engine.html

see: cylinder head & specifications
1helpful
1answer
0helpful
1answer
0helpful
1answer

The motor stop when i give gaz

i take it you have a 22re engine you must replace the fuel filter in a precarious position under the intake manifold
0helpful
1answer

1992 Toyota Pickup 4-cyl, 22RE, Brake wires have been disconnected and I can't find a schematic.

this should help this should be good for pickup model years 79 thru 95
right turn - green with yellow stripe
left turn - green with black stripe
backup - red with black stripe
taillight - green
brake - green with white stripe
ground - white with black stripe
11helpful
2answers

Location of knock sensor on 1994 toyota 22vre engine

The Knock sensor on a 22re is located under the intake manifold on the engine block. to the upper left of the oil filter. With is the passenger side of the engine. I believe it is yellow in color. Not do be confused with the oil pressure sensor which is close by. The knock sensor has a larger electrical connector. Good luck it can be hard to get to.
1helpful
1answer

94 toyota 4x4 5 speed 4 cyl 22re engine

Get the timing checked. If it is off over 5-8 degrees, you may have a timing chain that has jumped a tooth. This is a common issue with the 22 RE with high mileage. Let me ask you this, and this may narrow down my solution...Is there a slight "rapping noise" in the front of the engine? If so, the timing chain guids may be worn or broken. Get the timing checked, and advise me of the findings.
Not finding what you are looking for?

539 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...