Question about 2003 Mazda Tribute

1 Answer

Mazda Tribute Gear shift light will not light up Problems

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 133 Answers

It got any fault code to make the shift light system fail to work?
Maybe it is good to use obd2 scanner to have a check.

Posted on Jul 16, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 563 Answers

SOURCE: Having horn problems on 2005 Mazda Tribute. The

Check the grounding source, also check if current flows to the horn wires, and its wire plugs are not corroded.

Posted on Nov 19, 2009

  • 1 Answer

SOURCE: Gear shift is broken in a 2001 Mazda Tribute 3.0

Mine did the same thing on May 31. Turns out the cable that passes through the firewall from the steering column to the side of the transmission had come disconected at the transmission. I was able to re-connect it using a tie wrap for a temporary solution. Hope this helps.

Posted on Jun 02, 2009

  • 1 Answer

SOURCE: My 2001 Mazda tribute column

The same thing happened to my 2001 Mazda Tribute. It was stuck in Neutral. The shifter cable fell off the little metal post under the steering column. To fix it I removed the plastic column covers. Put the round end of the cable back on the little silver colored post. Then secured it on the post with a ring type push nut from Ace Hardware. Total cost of repair was sixty cents. The cables are not always broken. They just fall of the little post.

Posted on Jul 20, 2009

  • 4044 Answers

SOURCE: 2001 Mazda Tribute V6 engine miss

Take the vehicle to Auto Zone or another parts store that will read the engine fault code from the ECM for you. Most will do it for free. Depending on how long it has been since you replaced the plugs and wires on your vehicle you may have a bad spark plug or plug wire that is causing the problem. Easy enough to fix if you don't have to pull the air intake assembly to change the back 3 plugs. If you do have to pull this you should get a chiltons repair manual so you ahve instructions on how to remove and replace the intake assembly.

Posted on Sep 17, 2009

  • 2 Answers

SOURCE: 2001 Mazda Tribute No transmission-- it will

The plastic rod ends on the cable assy that goes between the shft lever in the colum and the transmittion are worn. I change the cable for the same reason last week and that fixed the problem.
The cable part number is MZEC01-46-500E the price from the Mazda dealer was US $ 64.98. Is easy to change all you need is aphillips screw driver & pliers

Posted on Jan 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2005 Mazda tribute and while driving the transmission shifts from drive to 1st, then 2nd, then drive and it will do this off and on the entire time I am driving. The fluid looks clean.


Mazda Tribute Transmission Problems - Edmunds.com

forums.edmunds.com > Mazda > Mazda Tribute

Dec 6, 2007 - 31 posts - ‎20 authors
In March 2005 I purchased my brand new Mazda Tribute. ... When the transmissionproblems first started I explained to Mazda that I .... The whole four wheel drive! ...While they were driving on the freeway, the engine revved a little. ... When it isshifting into or out of overdrive around 50 mph sometimes the ... Mercury Mariner Transmission Problems
31 posts
Apr 5, 2007
Nissan Quest Transmission Problems
31 posts
Nov 7, 2006
Mazda Tribute Gear Selector
15 posts
Aug 2, 2006
More results from forums.edmunds.com

2004 Mazda Tribute / Ford Escape Transmission trouble ...



Jan 14, 2016 | 2005 Mazda Tribute

1 Answer

I have an 02 mazda tribute and my breaks and blinkers stopped working all of a sudden. I can't even get it out of park since I can't uses my breaks to shift. No break lights either??!


The brake light switch at the brake pedal controls the brake lights and the gearshift release solenoid. It should have no effect on the signal lights. You may have 2 problems. You can try tapping the brake light switch and moving the contact plunger by hand to see if the brake lights/shift release will work. If it starts operating again, I would replace it immediaetly before it fails completely

Apr 05, 2015 | 2002 Mazda Tribute

1 Answer

2002 Mazda Tribute hard shift/shift flare only from 2nd to 3rd gear


bad sign that, get it checked, do not allow it to slip.
or it can get worse fast.

Jul 18, 2014 | 2002 Mazda Tribute

1 Answer

How do you turn the gear shift light indicator on mazda tribute


The light comes on automatically with the headlioghts, so you may have a burnt out bulb or a wiring problem.

Sep 18, 2012 | 2001 Mazda Tribute

1 Answer

Please,can you help me fix cods problems p0732,p0734 on my 2006 Mazda Tribute


P0732 - Improper Ratio for Second Gear.
P0734 - Improper Ratio for Fourth Gear.

This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by TCM as follows:

Torque converter slip ratio = A x C/B A: Output shaft revolution signal from revolution sensor B: Engine speed signal from ECM C: Gear ratio determined as gear position which TCM supposes

If the actual gear position is higher than the position (2nd and 4th) supposed by TCM, the slip ratio will be more than normal. In case the ratio exceeds the specified value, TCM judges this diagnosis malfunction.

This malfunction will be caused when shift solenoid valve B is stuck open.

Gear positions supposed by TCM are as follows. In case of gear position with no malfunctions: 1 , 2, 3 and 4 positions In case of gear position with shift solenoid valve B stuck open: 4* , 3, 3 and 4 positions to each gear position above.

Symptoms: Engine Light ON (or Service Engine Soon Warning Light)

Diagnostic trouble code A/T 2ND GR FNCTN with CONSULT-II or P0732 without CONSULT-II is detected when A/T cannot be shifted to the 2nd gear position even if electrical circuit is good.

Possible Causes:
- Shift solenoid valve B
- Each clutch
- Hydraulic control circuit


Check it and tell us news.

Nov 23, 2010 | Mazda Tribute Cars & Trucks

2 Answers

Gear shift stuck


EITHER IT IS CONNECTED TO THE TRANS BY A ROD OR CABLE SOMETHING HAS COME LOOSE THERE

Aug 31, 2009 | 2002 Mazda Tribute

1 Answer

Engine Died on Reverse Gear


try adding some transmition fluid to the transmition . or have it towed to a repair shop

Nov 12, 2008 | 2001 Mazda Tribute

Not finding what you are looking for?
2003 Mazda Tribute Logo

Related Topics:

202 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...