Question about 2006 Ford Focus

1 Answer

Rev problem After ignition the rev is too high

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 5,470 Answers

There can be several reasons for this. A stuck throttle flap in the intake manifold, or an opening in a gasket.
Some of the engines have a part called a manifold runner. This part is like a 2 position shutter. When it sticks, the high speed chamber can be open at low speeds in error. This causes the engine to run faster. The part may need to be removed to clean or an attaching/operating assembly may be stuck.

Posted on Jul 16, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi, I have a 2005 Mitsubishi Lancer Wagon, 4G93. It wont rev over 4000. It has no error codes, I changed the Mass Air Flow intake sensor and no change.


If your in park or neutral, the PCM stops the engine from revving up to high. If your driving, then the fuel filter is clogged up.

Dec 06, 2015 | Mitsubishi Cars & Trucks

1 Answer

My chev captiva 2.4 petrol, it start nicely but it dsnt want to rev high, it shows code c3fa9


if it will not rev high , it could be in the limp mode or the rev limiter has failed
find what the code refers to and fix the fault

Oct 22, 2015 | 2010 Chevrolet Captiva 2.4

1 Answer

Hw can i fix toyota hilux d4d 3000,2006 model cannot rev over 1500 revs


There are alot of factors that could prevent the engine from revving over 1500RPM. Some sensors like the crank angle or cam angle have to be connected in order for the engine to even start, other wiring loom plugs like the turbo controller need to be connected or the car goes into limp mode and it won't rev past a certain point.

Then there are the automatic throttle controller area wiring loom type plugs near the inter cooler, sometimes people forget to put them all back and the engine won't rev high. Making sure the vacuum pipes in this area are all connected properly, one unplugged pipe, no vacuum, the injector pump relies on the vacuum system and if it doesn't work then not enough fuel delivery, engine can't rev high. Also if the fuel rail is leaking or if the fuel filter is clogged then engine won't rev high.

Feb 26, 2015 | 2006 Toyota Hilux 3.0

2 Answers

Have 1999 cavilleir does it have a rpm protecter


Yes, the PCM for your vehicle's engine has a rev/speed limit seeting programmed into it. Most stock, non high performance/police package vehicles usually won't go above a top speed of 97MPH. if you were to rev your engine while it was in park or neutral, once the engine reaches the cut out rpm limit preset in the PCM, it will cause the engine to cut back, then it will rev up until it hits the preset limit, then cut back, and it keep repeating that pattern. It may sound as though you have a high rev ignition failure that sounds like waaa, waaa, waaa, waaa, but that indicates the PCM is doing its job.

Apr 05, 2010 | 1999 Chevrolet Cavalier

2 Answers

Renault megane engine revving uncontrollably


sounds like its sucking in to much air at inlet manifold have it looked at

Apr 02, 2010 | 2000 Renault 181

1 Answer

I only just brought it v6 1991 wont rev out clean dies down at high revs


it has a rev limitor on it.. at high revs the computer shuts the engine down to prevent damage.

Dec 11, 2009 | Toyota 4Runner Cars & Trucks

1 Answer

Idle Rev Limit in 3.5L engine


yes this is normal. most newer cars are equipped with rev limiters so people cant over rev the engines without a load on it. the shaking is from the computer cutting off the ignition repeatedly when you reach the max rpm.

May 12, 2009 | 2004 Dodge Intrepid

1 Answer

Rev counter high.


sounds like the sensor module

Dec 13, 2008 | 2000 Renault 181

1 Answer

Rev high when changing gear up


my friend has same model its normal he said it does it more so when its cold

May 24, 2008 | 2003 Honda CR-V

Not finding what you are looking for?
2006 Ford Focus Logo

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...